Question about 1999 Honda Steed

1 Answer


Posted by on

  • georgdiamadi Oct 01, 2010



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 474 Answers

NO. when something is made to be air cooled it is designed diffrently ie: cooling fins. if you run a water cooled engine with no coolant your apt to destroy it

Posted on Oct 01, 2010

  • nuckle bustr Oct 02, 2010

    the fins your talking about are smaller than needed for effective cooling and are only to assist the primary cooling system.


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Dometic RM2652 was working fine then stopped - no lights at the control panel above the doors.

Usually there is a short in the system when fuse is blown. Check the cord as sometimes mouse can damage the cord. It is a posibility.
Check power to the electronic board.

Jan 28, 2015 | Dometic RM2652 Refrigerator

1 Answer

Extreme heat

oil cooled I believe your plugged aircooled your plugged, are you winding it out, exhaust plugged check those

Aug 31, 2014 | Polaris 2008 Sportsman 300

1 Answer

What is a posible solution for mazda friendee, after 3months the freon was empty?

Richard, you obviously have a slow leak some where,. Either in the cooling coils or at a coupling, When a technician works on it, they will inject die into the system to find the leak and either repair it or replace the part. I suggest, you have it professional serviced.

Apr 21, 2011 | Heating & Cooling

1 Answer

I want to have an electrical diagram of an Aircooler.

we have different types of aircooler circuit diagram, but i dont know the one you are looking for, so i will kindly direct you on where to get those diagrams from and you will choose the one that suits your search. the address below will show you almost every aircooler circuit diagram;

Dec 22, 2010 | Computers & Internet

1 Answer

Generac Model 5525-1 20kw air cooled standby generator Question: How do you access the battery? I think it is behind the front panel, but can't readily see how to open/remove the front panel. Thanks!

2 bolts on top of the front panel. Take them out and then just puul up and it come off. you can then easily remove the battery but make sure the leads dont touch as they still have charger power running through them.

Dec 04, 2010 | Generac Power Systems Generac 5525 20 Kw...

1 Answer

Carrier Low pressure lockout - 4 hours Code 83 The system is less than 1 half years old. Will it start cooling again after four hours? Infinity control shows Fan - On, A/C - off

If the low pressure sensor trips, the least likely problem is a bad sensor, more than likely, you have a leak in the system, this will require leak location, repair and recharged.
Also posible, a dirty air filter, plugged indoor coil, causing the indoor coil to ice up, causing a temporary low pressure issue, solution would be to clean the coils, power the system down and restart and test.
If this has been helpful, please rate the new guy :)
If you have any other questions, please give me a shout.
Paul Gibson

Apr 06, 2010 | Heating & Cooling

1 Answer

2000 ford f250 ac not cooling at idle cools good going down the road new system and new clutch fan and two electric fans ford put everything new on this truck

What this sounds like is an under charged unit. If you just had the work done then there is a posibility that they under charged it or it has developed a leak. That is posible. Hope this helps and good luck.

May 07, 2009 | 2000 Ford F250 Super Duty Crew Cabs

1 Answer

My Dimplex DAC12AC aircooler is blowing out hot air

Hi,its possible have a problem your PCB Board ,the 17c is so cool setting but blows hot , and the E3 simble its min High Cooling , pls check ur PCB board to the nearest service center.

Jan 07, 2008 | Heating & Cooling

Not finding what you are looking for?
1999 Honda Steed Logo

Related Topics:

128 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers


Level 3 Expert

75807 Answers


Level 3 Expert

4336 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides