Question about 2004 Honda CBR 1000 RR Fireblade
I would check the chain adjustment.If its in specs you may be going to slow in 2nd gear.Hope this helps you
Posted on Sep 29, 2010
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tips for a great answer:
Inspect the transmission fluid for debris.
DTC P0742 Torque Converter Clutch System Stuck ON Step
Was the Powertrain On-Board Diagnostic (OBD) System Check performed?
Go to Step 2
Go to Powertrain On Board Diagnostic (OBD) System Check
Install the Scan Tool .
With the engine OFF, turn the ignition switch to the RUN position.
Important: Before clearing the DTCs, use the scan tool in order to record the Freeze Frame and Failure Records for reference. The Clear Info function will erase the data. Record the DTC Freeze Frame and Failure Records, then clear the DTC.
Start and run the vehicle.
Select TCC Slip Speed on the scan tool.
With the transmission in D4, drive the vehicle through the 1-2 upshift.
In second gear is the TCC Slip Speed within the range specified?
-20 to +50 RPM
Go to Step 3
Go to Diagnostic Aids
Inspect for the following conditions:
The TCC apply valve stuck ON because of sediment or damage.
The TCC Sol. Valve Assy. stuck ON because of sediment or damage. Refer to Control Valve Body Assembly Inspection, in Unit Repair.
Was a condition found and corrected?
Go to Step 4
In order to verify your repair, perform the following procedure:
Using the scan tool, clear DTCs.
Operate the vehicle under the following conditions:
• The gear range is D2, D3 or D4.
• The commanded gear is not 1st.
• The engine speed is greater than 500 RPM for 5 seconds.
• Not in fuel shut off.
• The engine torque is 95-270 N·m (70-200 lb ft).
• The throttle position is 14-50%.
• The PCM commands the TCC OFF.
• The TCC slip speed is 150-2000 RPM for 5 seconds.
• The engine speed is 800-4000 RPM.
• The vehicle speed is 32-112 km/h (20-70 mph).
• The speed ratio is 0.65-1.18.
• The last gear change occurred more than 3 seconds ago.
Select Specific DTC. Enter DTC P0742.
Has the test run and passed?
Begin the diagnosis again. Go to Step 1
Oct 07, 2015 | Pontiac Cars & Trucks
Dec 11, 2014 | 2002 Hyundai Accent
Nov 10, 2012 | 2002 Ford Expedition
Sep 05, 2012 | 2000 Dodge Grand Caravan
Jun 07, 2012 | 2010 Chevrolet Aveo
Jul 03, 2010 | Cars & Trucks
Feb 02, 2010 | Volkswagen Camper Cars & Trucks
Mar 26, 2009 | 1998 Lincoln Mark VIII
92 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: