Question about 2000 Yamaha FZX 250 Zeal

1 Answer

Hi Czaa, I need your advise again. Whle I was changing gear down from 6 to 5/4, the bike just went dead when I was holding on to the clutch. When I release the clutch, the bike then started again, but it was like giving it a jump start. Sometimes it also gives the feeling as though it is leak of oxygen / feels like drowning. Can you advise what's wrong with it and what should i do about it?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

Check your air filter, if it is dirty change it.

Posted on Sep 27, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Please I have changed the Clutch plates of my BAJAJ boxer biker 6 times but they keep on burning. What can really be the problem


bike clutch plates are normally running in special oil as they are wet clutches
for them to burn they will be running dry
read the workshop manual and if you don't have one go google and type in workshop manual for bajaj motor bike boxer model- look for a pdf version to down load

Oct 02, 2016 | Bajaj Motorcycles

1 Answer

All my electrics failed on my bike after a short ride I turned the bike off went to star it again but completely dead. Any ideas thanks


Hi, Steve and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Bank angle sensor tripped and ignition/light key switch not cycled to the "OFF" position and then back to the "ON" position.
5. Security alarm needs a reset.
6. Starter control circuit, relay, or solenoid faulty.
7. Faulty starter button.
8. Electric starter shaft pinion gear is not engaging or over-running starter clutch slipping.
Good luck and have nice a day.

Nov 20, 2015 | Motorcycles

1 Answer

I need 2,3 & 4 gear for Yamaha 1100 special 1982 model


Instructions
    • 1 The gears on a motorcycle run in this order: first, neutral, second, third, fourth and fifth. When you are moving, shifting up from first gear will skip over neutral and shift you right into second gear. The only time that shifting up from first will get you into neutral is when you are not moving.
    • 2 Pull in the clutch lever and tap the gear lever down until it stops. This will signify first gear. Pressing the gear lever down will shift you down one step and pressing it up will shift up one step.
    • 3 Tap the gear lever up one click while still holding in the clutch. This will put the bike into neutral.
    • 4 Start the bike. The bike needs to be in neutral to start.
    • 5 Hold in the clutch lever and tap the shifting lever down to shift to first gear.
    • 6 Release the clutch slowly and give it just enough gas to get moving.
    • 7 Listen to the motor to know when you need to shift. If the engine is making a low grumbling noise, then it will need to be shifted down. If it is making a high squealing noise, then it needs to be shifted up.

Jan 15, 2013 | Motorcycles

1 Answer

Where can I find 2/3 & 4th gears for Yamaha XJ special 1982 model.


Instructions

1

The gears on a motorcycle run in this order: first, neutral, second, third, fourth and fifth. When you are moving, shifting up from first gear will skip over neutral and shift you right into second gear. The only time that shifting up from first will get you into neutral is when you are not moving.
2

Pull in the clutch lever and tap the gear lever down until it stops. This will signify first gear. Pressing the gear lever down will shift you down one step and pressing it up will shift up one step.

3

Tap the gear lever up one click while still holding in the clutch. This will put the bike into neutral.
4

Start the bike. The bike needs to be in neutral to start.
5

Hold in the clutch lever and tap the shifting lever down to shift to first gear.
6

Release the clutch slowly and give it just enough gas to get moving.
7

Listen to the motor to know when you need to shift. If the engine is making a low grumbling noise, then it will need to be shifted down. If it is making a high squealing noise, then it needs to be shifted up.

Jan 15, 2013 | Motorcycles

1 Answer

Recently went for a ride and everything was good. Made a stop, when I came out bike wouldnt start. turning the key everything was normal, rpm gauge spiked, lights turned on, fuel pump was heard. Went to...


Did you leave your motorcycle in gear when you turned it off? It sounds like the side stand safety switch is keeping the bike turned off. If my Suzuki is running and I pull in the clutch, with out raising the side stand, and I place the bike in gear with the side stand down, it will immediately shut off. The cycle is set up that way so you will not drive with your stand down and go out of control when you take your first left turn. If your cycle is not in neutral and your side stand is down, that would cause the condition you describe. If that is not the case start by inspecting the side stand safety switch and the clutch safety switch for proper operation.

Jun 24, 2011 | Suzuki GSX-R 750 F Motorcycles

4 Answers

How do i on a motorcycle go to first gear from 5th


hi, if when you start your bike you press the gear lever down to go to 1st from neutral and then pull it back up to go to 2nd,3rd,4th and 5th then the only way to get back into first gear is to press the gear lever down 4 times to get it back into 1st gear their is no quicker way to do this you have to work your way back down the gears.

if your coming to a stop quick then just pull the clutch in and keep pushing the lever down until it dont push down any further it will only go down 1 gear at a time so you will need to push it down 4 times but you dont need to count you can just keep pressing it down the gears until it dont go down any more then you know this is first, you need to keep the clutch in when doing this.

how ever if your slowing down is more gradual then what you can do is go from 5th down to 4th then let engine slow the bike down then when the revs drop down change down to 3rd and so on until you get ot 1st gear.

if your coming to a stop quick say at lights or junction then if the bike is in 5th gear then you can change down the gears once the bike has stopped just hold the clutch in when you stop and keep tapping the gear lever down until you feel that its not going down any more gears this way you know its in 1st without having to cound down the gears, their id no quicker way of going down the gears to get to 1st.

i hope i have read your question right and gave you the answer you was looking for if i got the question wrong then please explain then i can assist you further ok

May 23, 2010 | 2005 Yamaha Xv 250 Virago S

Not finding what you are looking for?
2000 Yamaha FZX 250 Zeal Logo

Related Topics:

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...