Question about 2005 Honda VT 750 Shadow Aero
Center stand the bike or jack it up to get the rear wheel off the ground ,loosen the rear axel nut, take out the bolt, knock out the spacer on the brake panel, unhook the brake cable , unbolt the bar going to the brake panel, grab the wheel, and slide it sideways away from the final drive. The wheel should slide right off the spline of the final drive and roll out the back under the fender. If the wheel wont slide past the final drive let the air out of the tire. Be sure to coat the spline of the final drive with moly60 paste from your local Honda dealer when reassembling.
Posted on Sep 14, 2010
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
You do not have to remove the final drive , the wheel is resting on a spline shaft. Center stand the motorcycle or lift the rear wheel, remove the axle bolt, knock out the spacer, and slide the brake panel out of the way. Now the wheel is resting only on a splined shaft. Grab the wheel and gently slide it away from the final drive ( off the splined shaft ) and roll it out the back of the wheel well. When replacing the wheel be sure to get some MOLY60 paste from the Honda dealer and grease the spline before putting the wheel back on.
Posted on Jul 29, 2010
SOURCE: Needing a manual on how
Put the bike on the center stand or jack up the back end enough to get easy access. Unbolt and slide out the rear axle. If the axle hits the mufflers, take out the lower shock bolts and lower the wheel and swing arm enough to pull the axle and spacer out. Unbolt the brake panel stop arm. The wheel is now resting on a splined shaft. Grab the wheel and pull it/slide it sideways away from the final drive assembly. Now you should be able to drop it out the bottom or roll it out the back of the wheel well. If the tire is too wide to fit between the final drive spline and the swing arm, let the air out of the tire to squeeze it through the gap. Go to the local Honda dealer and purchase a tube of Moly60 Paste and coat the spline on the final drive with it before reassembly.
Posted on Jun 24, 2011
Tips for a great answer:
Jun 04, 2017 | Honda VT 1100 C3 Shadow Aero Motorcycles
Jul 13, 2014 | 2005 Honda VT 750 Shadow Aero
May 22, 2014 | 2008 Honda VT 750 Shadow
Sep 25, 2012 | 2008 Honda VT 750 Shadow
May 06, 2011 | 1986 Honda VT 500 C Shadow
Jul 29, 2010 | 2005 Honda VT 750 Shadow Aero
Jun 18, 2010 | 2005 Honda VT 750 Shadow Aero
Sep 23, 2009 | 2005 Honda VT 750 Shadow Aero
2,121 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: