Question about 2006 Aprilia RS 125

1 Answer

My bike says er5 what does that mean - 2006 Aprilia RS 125

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Aprilia Master
  • 43,836 Answers

Hi, Marz_carz I am sorry you can't find the first and best tool you ever bought for your Aprilia but despair not for a mere $10 you can download another one. For more information about your issue, please visit the websites below. Good luck and have a nice day.
http://www.apriliaforum.com/techtips/1000/faultcodes.htm
DOWNLOAD 2006 Aprilia Rs 125

Posted on Oct 29, 2015

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What does the error code ER5 for a EDW154E Eurotech D/W mean?


e5 error is drain error. need to check all drain related items.
drain pump, drain hose, and of course garbage disposal knock out.

Jun 06, 2014 | EuroTech 24 in. EDW154E Built-in...

1 Answer

My ER5 Clicks instead of turns on


Check if the battery has 12 volts.
Check the battery terminals if they are corroded with acid deposit. Clean them if they are, by using a wet sponge, wet it with water and let it stay for a while on the terminals this will ease off the corroded acid deposits.
If the battery is ok and if there's no acid deposit on the terminals , thn you have to check the starter motor, it may need to be overhauled.
Better too to check the solenoid switch.
Hope this helps!

Dec 08, 2009 | 2002 kawasaki ER-5

1 Answer

How do I derestrict my 2006 Kawasaki ER5 please?


I assume it has been restricted to 33bhp for use on an A1 license?

If so it will either have been done through the ECU if your bike is fuel injected. Or (more likely) it is carbs then there will be large washers inside the inlet rubbers restricting the bore of the carbs. If you take the carbs off and pull these out you'll have access to your bikes full potential.

Regards

Chris

Nov 06, 2009 | 2006 kawasaki ER-5

1 Answer

I have just bought an 03 Kawasaki 500 ER5 it has a noise from thn


Best would be to examine tht noise, put your bike on the center stand and get an assistant to sit on it so tht the front wheel is thn free to rotate.
Rotate the wheel and try to locate the noise...not bad if you start at the brake pads!
Hope this helps!

Oct 31, 2009 | 2006 kawasaki ER-5

2 Answers

Can't remove rear brake panel and shoes from brake drum on ER5.


if the rear shoes have jammed the way i normally fix this problem is to undo and remove the arm so you are left with the spline sticking out. then knock this in carefully and it should release the shoes and you should be able to remove the hub.

May 05, 2009 | 1997 kawasaki ER-5

2 Answers

My rev counter does not work on my kawasaki er5 1999


The ER5 has got an electronic rev-counter, no cable.

Like the oval rear brake-drums this is another ER5 bugbear, the rec/rec fails, the battery boils and the rev-counter is usually a victim too.
Often on ER5 specific forums there will be someone who repairs the circuit board and sells the repaired units much cheaper than a new one. it's usually a tiny zener-diode that is killed.

May 04, 2009 | 1999 kawasaki ER-5

1 Answer

Problems getting the bike moving


Have you had the clutch checked? Cause that's where it sounds like the problem is. My HD tried that same ****,adjusted the clutch,fine for a while,then it happened again. Turned out my clutch cable was popping loose in the hand-lever one wire at a time. Repaired that and no probs since.
So, I'd check the cable first and if it's good I'd have the clutch plates etc. checked. Good luck.

Apr 02, 2009 | 2002 kawasaki ER-5

1 Answer

My er5 runs rough when i ease off on throttle and go back on bike shakes and picks up speed i have cleaned carbs changed plugs and oil+filter


Hi there Dave
I would check Carby setting. Like float levels, Mixture screw setting. These can make the bike run
roughily. Also the spark plugs settings, eg not right gap or heat range or ever reach. One other thing
is vacuum leak eg from a vacuum hose ( this usely makes the bike run rough all the time) Simple way
to test this is use a can of WD 40 & spray over the vacuum hoses & if it stops the problem for a short
time you need to replace the hose or fix the leak. I hope this helps your problem, if not please put up
some more info on what you have done to help you There is many little things that can course is
problem.
Regrades Lighten

Feb 27, 2009 | 2001 kawasaki ER-5

Not finding what you are looking for?
2006 Aprilia RS 125 Logo

Related Topics:

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top Aprilia Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Are you an Aprilia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...