Question about 1999 Suzuki GSX-R 600

1 Answer

98 gsx600 wont star with the starter but i can push start it is there a kill switch somewhere?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 474 Answers

There is a switch on the clutch that will prevent the bike from starting without the clutch pulled in. look for a set of wires that go to the clutch lever, trace them down to a plug in connecter, unplug and on the lever side of the plug put a multi meter set to ohms and pull the lever. you should get a connection. or take a jumper wire and bridge the two wires on the bike side of the connector and try to start. make sure if you do this the bike is in neutral and the clutch is in because it will start in gear.

Posted on Sep 11, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I HAVE A 2003 FORDWIND STAR SE.3.8 NEW PLUGS AND WIRES NEW STARTER NEW THROTTLE BODY NEW SPEED CONTROL STILL WONT CRANK OR TURN OVER EVERY ONE IS SAYING IT THE KILL SWITCH I DONT WHERE IT IS LOCATED


The fuel shut-off switch (inertia switch) is located probably in the rear somewhere, like behind a side or kick panel , or sometimes it is located in the kick panel on the front passenger side.

But this switch is only for fuel shut off in case of accident or emergency. It will not affect the starting circuit. Something else would be preventing from cranking the engine over. Since you have a new starter, there must be a problem in the start circuit. If security light is flashing when trying to start it, it must be activated. If not, you need to see if power is going to starter solenoid with key held in crank position.

Apr 24, 2017 | Cars & Trucks

1 Answer

Car was running, electrical wire burning smell, starter makes grinding noise, with the car running, stop the car, starter keeps making grinding noise, with the car turned off, ABS and trac control


You have the polarity of the battery backward somewhere. Did you replace the starter and hook it up backwards. Difficult but possible. Check your positive and negative on the battery itself.

Nov 23, 2015 | 2001 Mercury Grand Marquis

1 Answer

650 v star wont start battery good no green light


Hi, Anonymous and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, needs to be 12.5 volts or better and be able to pass a load test if necessary, check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Bank angle sensor tripped and ignition/light key switch not cycled to the "OFF" position and then back to the "ON" position.
5. Faulty starter button/switch.
6. Faulty kickstand or clutch pull in switch/sensor.
7. Security alarm needs a reset.
8. Starter control circuit, relay, or solenoid faulty.
9. Main fuse or circuit breaker may be blown or faulty.
10. Electric starter shaft pinion gear is not engaging or over-running starter clutch slipping.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
VStar 650 won start
Help My Star 650 Wont Start
98 00 Yamaha XV650 Star Service Manual XVS650 Moto Data Project
OEM parts for Yamaha
http://www.starmotorcycles.com/assets/service/manuals/2003/LIT-11626-16-05_22.pdf

Apr 16, 2014 | Yamaha V Star Classic Motorcycles

1 Answer

Yamaha 650 v star classic won't start


Hi, Anonymous and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, needs to be 12.5 volts or better and be able to pass a load test if necessary, check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Bank angle sensor tripped and ignition/light key switch not cycled to the "OFF" position and then back to the "ON" position.
5. Faulty starter button/switch.
6. Faulty kickstand or clutch pull in switch/sensor.
7. Security alarm needs a reset.
8. Starter control circuit, relay, or solenoid faulty.
9. Main fuse or circuit breaker may be blown or faulty.
10. Electric starter shaft pinion gear is not engaging or over-running starter clutch slipping.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
Help My Star 650 Wont Start
V650 won start in 650 Star Tech Forum
98 00 Yamaha XV650 Star Service Manual XVS650 Moto Data Project
OEM parts for Yamaha
http://www.starmotorcycles.com/assets/service/manuals/2003/LIT-11626-16-05_22.pdf

Sep 28, 2013 | 2004 Yamaha V Star Classic

1 Answer

My 98 mazdab4000 wont star.first was my starter.ichanged it,it was running ok for abou 3 weeks,than star doing the same,i checked the ground wires.battery.they are ok.i used jump cables ,still wont star...


If you mean it just wont crank over,what I did on my Toyota(just another vehicle,but same situation),I clipped a wire onto the main starter wire to the solonoid and put the other end on a toggle switch on the dash and a hot wire from battery to the other side of toggle switsh(spring loaded from auto parts store),and any time my Truck wont crank over,I leave the switch on and pull the toggle switch over and it starts right up.Can be done with ANY vehicle.

Jul 23, 2011 | Charging & Starting Systems for Mazda...

2 Answers

Hi I'm rey. I have a problem of my Yamaha V Star 1100. I can't start the engine. The battery is new(fully charge) starter is working, but it appears the gear that trigger the engine can't get through. Can...


Fist things first.
Check all the terminals, ie battery, solenoid and starter.
Make sure they are all tight and that the earth lead on the starter is good along with the +12v.
Check the fuses.
Then get a meter to check the voltage at each point when you press the starter button.
If ok, you will then have to look at things that cause the starter circuit to not to work, ie
Kill switch, in gear, side stand down.
come back to me when you have done that.

Feb 14, 2011 | 2002 Yamaha V Star 1100 Classic

1 Answer

The battery is charged but the motorcycle wont start, possible starter?


could be solenoid.
side stand switch.
bike in gear switch
ignition kill switch
faulty starter switch
you are going to have to get a test meter and and see what power is going to solenoid both sides and if it is getting the signal to start.

---


Please dont forget to vote if you liked my answer


thanks

Feb 09, 2011 | 2004 Yamaha V Star Classic

1 Answer

2001 kaw Vulcan 1500 will not start. new battery, starter relay


Check continuity at the kill switch? sidestand switch? Either could be malfunctioning. What does your manual tell you about the starter relay circuit?

Jul 20, 2009 | 2000 kawasaki VN 1500 Vulcan Classic...

1 Answer

My 2006 vstar 1100 classic wont start. i checke the fuses and kick stand switch. it is in neutral. when i tried to start it the other day, i turned over like it had a weak batter , as i havent ridden in...


could also be your starter relay. Try jumping the terminals on the relay and see if the bike attempts to start if so then you have forund your problem.

Mar 11, 2009 | 2006 Yamaha V Star 1100 Classic

Not finding what you are looking for?
1999 Suzuki GSX-R 600 Logo

Related Topics:

140 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Ed Nelson
Ed Nelson

Level 2 Expert

149 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...