Question about 2002 Aprilia RSV Mille Haga

Open Question

I have a yamaha townmate and it is not cutting out in idle but if you keep hand on trottle it will run suspect that the carburetor needs adjustment, which of the screws do i need to adjust as slightly different set up to my suzki 50n

Posted by on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3567 Answers

SOURCE: carburetor adjustments yamaha 450yfz 2004

Turn both the air screw and throttle screw inward until they LIGHTLY seat. Now back each one outward one and one half turns. This is the factory setting. I am going to give you a web site where you can download a free PDF factory service manual for a YZ450FR. I believe the model is a bit different but the carbs are the same.

Go to this site and you can download a free PDF service manual. The site may take up to 25 seconds to fully load the list of manuals. It is worth the wait. www.carlsalter.com/motorcycle-manuals.asp The service procedures are there in detail and a lot of diagrams and photos. Don't mess with the pilot screw unless you have to, Part #11 in the diagram.
Can I get a Very Helpful" rating out of this?

6a23d75.gif

Posted on Sep 06, 2009

  • 3567 Answers

SOURCE: yamaha t80 townmate carb keeps overflowing with petrol

Yes, the float or the float needle is sticking in an open position. The only other possibility is a float that has a pinhole in it and has filled with petrol and will no longer float as it should.

Posted on Nov 22, 2009

  • 65 Answers

SOURCE: flooding problem need to adjust mixture screw to correct setting

is air filter clean and what is your elevation?

Posted on May 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wildstar starts and ticks over but cuts out when I give it throttle any help appreciated about off my rocker


Hi, Wullie and the usual suspects are:
1. Idle port, transfer ports, slow air jet clogged.
2. Idle adjusting screw set too low.
3. Air fuel mixture adjustment too lean.
4. Pilot/slow fuel jet clogged.
5. Faulty accelerator pump.
6. Float level too low.
7. Float bowl contaminated old fuel, water, dirt, rust, etc.
8. Carburetor bowl vent line clogged/blocked/pinched.
9. Fuel line to carburetor kinked or pinched.
10. Fuel filter clogged.
11. Intake manifold leak.
12. The gas cap is not venting properly or fuel tank venting system blocked.
13. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
14. Needle and seat stuck closed in the float bowl.
15. Multi carburetors not in sync.
16. Faulty fuel pump.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Bike idles perfect but dies when given the slightest amount of throttle 93...
Engine cuts out when throttle is turned Technical Mechanical Problems
Yamaha XV16AL Service Manual
OEM parts for Yamaha
YAMAHA XV1600A Owner Manual

May 30, 2017 | 2000 Yamaha XV 1600 Wild Star

1 Answer

What would cause 99 r1 to idle rough when warm


Hi, Anonymous and the usual suspects are:
1. Idle speed improperly adjusted.
2. Air fuel mixture screws not properly adjusted.
3. Inlet system air leak.
4. Leaking accelerator pump.
5. Loose low-speed jet.
6. Plugged low-speed jet.
7. Contaminated or plugged low-speed circuit.
8. Enrichner valve/choke not seated or leaking.
9. Multi carburetors out of sync and need to be balanced.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
http://www.r1-forum.com/forums/104-04-06-r1-mechanical-help/333978-rough-idle-knocking-engine-cutting.html
Stalling rough idle when hot Suzuki GSX Motorcycle Forums Gixxer com
1998 1999 Yamaha YZF R1 Service Manual R1 Moto Data Project
OEM parts for Yamaha
http://mybikemanuals.com/yamaha/yamaha-yz-owners-manuals

May 19, 2014 | Yamaha YZF-R1 Motorcycles

1 Answer

1994 Yamaha diversion 900 cuts out after idle revs


Hi, Anonymous and the usual suspects are:
1. Idle circuit and transfer ports clogged.
2. Air fuel mixture adjustment too lean.
3. Pilot jet clogged.
4. Faulty accelerator pump.
5. Float level too low.
6. Float bowl contaminated old fuel, water, dirt, rust, etc.
7. Float bowl vent or overflow tube clogged.
8. Fuel flow to carburetor restricted.
9. Intake manifold leak.
10. The gas cap is not venting properly or fuel tank venting system blocked.
11. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
12. Needle and seat stuck closed in the float bowl.
13. Multi carburetors not in sync
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
cylinders 1 and 4 not firing idles cuts out with throttle
Info needed on running lean rich
Yamaha XJ900 XJ900RK 1983 1994 Service Repair Manual Download Manuals...
OEM parts for Yamaha
http://mybikemanuals.com/yamaha/yamaha-xj-owners-manuals

Oct 10, 2013 | 2000 Yamaha XJ 900 S Diversion

1 Answer

Yamaha tw 125, not idling properly


Hi, Anonymous and the usual suspects are:
1. Idle speed improperly adjusted.
2. Air fuel mixture screws not properly adjusted.
3. Inlet system air leak.
4. Leaking accelerator pump.
5. Loose low-speed jet.
6. Plugged low-speed jet.
7. Contaminated or plugged low-speed circuit.
8. Enrichner valve/choke not seated or leaking.
9. Multi carburetors out of sync and need to be balanced.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
Yamaha TW200 Trailway Discussion Forum
TW200 Running Idling issue help
Yamaha TW125 1999 Service Manual
OEM parts for Yamaha
YAMAHA TW125 Owner Manual

Feb 27, 2013 | 2001 Yamaha TW 125

1 Answer

94 yamaha fzr 1000 was running fine, went to start it an it would start run on choke but cut out as soon as the choke was closed, definetly getting petrol as far as the carbs an getting spark, wud the...


Hi, Anonymous and the usual suspects are:
1. Fuel cap or fuel tank is not venting properly.
2. Fuel filter clogged.
3. Fuel line pinched or kinked.
4. Float needle and seat sticking.
5. Float level too low.
6. Carburetor bowl vent line clogged/blocked/pinched.
7. Idle adjusting ***** set too low.
8. Air/fuel mixture ***** set too lean.
9. Idle port, transfer ports, slow air jet clogged.
10. Slow fuel jet clogged.
For more information about your issue and valuable free downloads that you will need please visit the websites below. Good luck and have a nice day.
FZR 600 post storage idle stall issue The FZR Forum
View topic FZR 600 carbs only runs with choke on Help
Exup1000 co uk Tech FZR1000R
OEM parts for Yamaha
http://mybikemanuals.com/yamaha/yamaha-fz-owners-manuals

Feb 26, 2013 | 1991 Yamaha FZR 600

1 Answer

2007 yamaha v star 1300 idle is to high and fuel mixture to rich


Hi, Brian you may have a stuck choke and the usual suspects are:
1. Throttle cables improperly adjusted, pinched or need lubrication.
2. Idle adjusting screw needs to be backed off.
4. Air fuel mixture adjusted too lean start with 2 full turns.
5. Intake system air leak.
6. Fast idle choke ramp is not releasing.
7. Broken throttle return spring.
8. Damaged diaphragm or slide.
9. Faulty MAP, TPS, ATS, O2, sensors or wiring/connector
10. Multi carburetors not in sync.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
Running rich
Erratic idle so confused Yamaha Star Forum
YAMAHA XVS1300A Owner Manual
OEM parts for Yamaha
Yamaha XVS1300A 2007 Service Manual

Oct 27, 2012 | 2007 Yamaha V Star 1300 Tourer

1 Answer

Yamaha pw 80 wont idle


Hi, Anonymous and the usual suspects are:
1. Idle circuit and transfer ports clogged.
2. Air fuel mixture adjustment too lean.
3. Pilot jet clogged.
4. Faulty accelerator pump.
5. Float level too low.
6. Float bowl contaminated old fuel, water, dirt, rust, etc.
7. Float bowl vent or overflow tube clogged.
8. Fuel flow to carburetor restricted.
9. Intake manifold leak.
10. The gas cap is not venting properly or fuel tank venting system blocked.
11. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
12. Needle and seat stuck closed in the float bowl.
13. Multi carburetors not in sync
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
Yamaha pw80 wont stay running
1989 Yamaha pw80 won idle
YAMAHA PW80 Owner Service Manual
OEM parts for Yamaha
YAMAHA PW80 Owner Manual

Oct 21, 2012 | Yamaha PW 80 Motorcycles

1 Answer

2009 Yamaha Vity engine keeps cutting out for no reason


Hi, Anonymous and the usual suspects are:
1. Severely discharged or a damaged battery, should have 12.5 volts or better and be able to pass a load test if necessary.
2. Failed alternator/generator and or voltage regulator.
3. Loose or corroded battery terminals and or cables especially the "NEGATIVE" cable, look for loose, corroded, or broken connectors inside the cable harness at "BOTH" ends.
4. Failed main circuit breaker or ignition switch, check for loose connections and continuity.
5. Failed system and or ignition relay, check for continuity.
6. Failed ignition coil, ignition/electronic module.
7. Failed CKP, CPS, CMP, MAP, TPS, or BAS sensor, corroded, loose or broken wire connector pins/sockets.
8. Throttle cables and or idle speed improperly adjusted hot idle speed should be 950 RPM to 1000 RPM.
9. Air/fuel mixture screw improperly adjusted.
10. Accelerator pump damaged or not working.
11. Water or dirt in the fuel system, carburetor or filter.
12. Restricted, blocked or kinked fuel line.
13. Fuel tank empty.
14. The gas cap is not venting properly or fuel tank venting system blocked.
15. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
16. Needle and seat stuck closed in the float bowl.
For more information about your issue and valuable "FREE" downloads that you need please click on the links below. Good luck and have a nice day.
yamaha vity 125 engine cutting out
KTM Duke 125 cutting out help
YAMAHA VITY XC125E Owner Manual
OEM parts for Yamaha
Yamaha XC125 Service Manual

Aug 11, 2012 | 2009 Yamaha Vity

1 Answer

Tdm 900(2006) rev`s still running high after choke has gone off


Hi, Anonymous and the usual suspects are:
1. Throttle cables improperly adjusted, pinched or need lubrication.
2. Idle adjusting screw needs to be backed off.
4. Air fuel mixture adjusted too lean start with 2 full turns.
5. Intake system air leak.
6. Fast idle choke ramp is not releasing.
7. Broken throttle return spring.
8. Damaged diaphragm or slide.
9. Faulty MAP, TPS, ATS, O2, sensors or wiring/connector
10. Multi carburetors not in sync.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links blue below. Good luck and have a wonderful day.
2006 Yamaha Wolverine 450 Extreme High Idle
04 06 R1 overheating and High Idle
Yamaha 2002 TDM900 Service Manual
OEM parts for Yamaha
YAMAHA TDM900 Owner Manual

Apr 04, 2012 | Yamaha TDM 900A Motorcycles

1 Answer

1980 Yamaha Townmate T80 wiring diagram


Hi, Jbrown5050 for more information about your question and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
1980 Yamaha Townmate T80 wiring diagram Google Search
Yamaha Motorcycle Wiring Diagrams
Yamaha Motorcycle Manuals
OEM parts for Yamaha
HAYNES MANUAL Yamaha T50 T80 Townmate 1983 95 eBay

Mar 07, 2011 | Yamaha Motorcycles

Not finding what you are looking for?
2002 Aprilia RSV Mille Haga Logo

Related Topics:

768 people viewed this question

Ask a Question

Usually answered in minutes!

Top Aprilia Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Fabrice Wolters

Level 2 Expert

163 Answers

Are you an Aprilia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...