Question about Triumph Rocket III Motorcycles
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Vibration below 4000rpm
Hello cloaky...does the vibration seem to be more RPM related than speed related on your gixxer? Can it be felt more through the grips, or foot pegs? Any noise along with the vibration?
The 99 GSX-R600 has been subject to recall for the replacement of it's faulty cam chain tensioner (NHTSA CAMPAIGN ID Number: 99V132000) Dealer supplied and installed at no charge under warranty... corrected the problem of cam chain tension but the damage of shorten chain life for most owners, had already occured. Didn't know if you were aware of this...so i thought i would mention it.
Hope this helps...
Posted on May 15, 2009
SOURCE: Misfires when accelerating
check out your ignition system itdoes not advance
Posted on Aug 19, 2009
Testimonial: "I really do appreciate the info. I think my problem is above my knowledge so I will take it to the Harley agents. It was worthwile getting your advice"
Sounds like the starter sprag clutch on the flywheel is slipping.
Posted on Jul 29, 2010
Testimonial: "thank you I will look into that. How might you go about fixing that? I want to try and avoid taking the engine apart again if that is possible."
SOURCE: my 1999 honda shdow aero
Backfiring on deceleration is air getting into the exhaust and igniting unburned fuel. You probably have an after market exhaust on. You need to seal up the exhaust system by replacing all the exhaust gaskets. Dig the copper crush washers out of the head and replace them with new copper crush washers. This should take care of most of the popping. If the problem persists,unbolt the fuel cut diaphragms from the side of the carburetors and inspect them for holes and stickiness. Replace the fuel cut diaphragms if they are bad . Fuel cut diaphragms are on almost all Honda Kei Hin carburetors to stop the cycles from popping or backfiring on deceleration With the stock exhaust.
Posted on May 10, 2011
Tips for a great answer:
Jul 16, 2016 | Garden
Feb 14, 2015 | Toyota RAV4 Cars & Trucks
Mar 15, 2014 | Cars & Trucks
Feb 06, 2013 | 2008 Saturn Astra
Oct 01, 2012 | Cars & Trucks
Jan 27, 2012 | Oldsmobile Cutlass Supreme Cars & Trucks
May 03, 2011 | 1996 Ford Ranger SuperCab
Feb 21, 2011 | 2003 Kia Optima
Jul 13, 2009 | 2001 Ford Focus
Jan 06, 2009 | 2004 Dodge Caravan
29 people viewed this question
Usually answered in minutes!