Question about 2006 Yamaha V Star 1100 Silverado

1 Answer

We haven't driven 2006 Yahama Vstar 1100 in over a year and the clutch is sticking. Cables are okay, any suggestions from here.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,978 Answers

You have to unhook both ends of the clutch cable. If there is any drag at all replace it. If it hangs up the slightest bit when you let it out , The clutch will slip for a moment and then grab. If the clutch plates have become stuck together, when you let out the lever it will creep or judder. You probably have plates that are stuck together. You will have to take the clutch cover off ( if you do it carefully you can save and reuse the gasket), the springs, and the pressure plate. Then you can lift out the clutch pack (group of plates). Carefully separate all the plates one at a time, coat them with oil and reassemble them the same way. Put the bike back together and the problem should be fixed.

Posted on Sep 09, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Yahama vstar 1100 dies when put into gear


Could be a couple things, first, make sure your kick stand is all the way up, if so, you probably have either a bad kickstand or clutch switch. They can be checked with a meter set on ohms, if you get the same reading in both "in and out" the switch is bad, Frank

Aug 07, 2016 | Motorcycles

1 Answer

My bike wont turn over.. can anyone help??


Hi, Ashley and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Bank angle sensor tripped and ignition/light key switch not cycled to the "OFF" position and then back to the "ON" position.
5. Security alarm needs a reset.
6. Starter control circuit, relay, or solenoid faulty.
7. Faulty starter button.
8. Electric starter shaft pinion gear is not engaging or over-running starter clutch slipping.
For more information about your issue, please visit the websites below. Good luck and have nice a day.
Please Help My 02 vstar 1100 classic won start
Re My Yahama Star 1100 wont start Road Star Forum Yamaha Road Star
http://www.sloneservices.com/SilverBack/Other-Stuff/V-StarShopManual99-07.pdf
http://www.starmotorcycles.com/assets/service/manuals/2000/LIT-11626-13-36_96.pdf

Dec 30, 2015 | Yamaha Motorcycles

1 Answer

2005 yahama vstar 1100 custom


Hi, Anonymous your starter motor is not the problem it's the starter drive/Bendix/clutch which is a mechanical gear driven component that engages the clutch pack ring gear to turn over the engine. It has an internal mechanism that allows the gear to turn in one direction and once the engine starts allows the drive gear to free spin. If gear free spins in both directions then the drive gear has failed, it is not serviceable and needs to be replaced. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
How To Star Starter Clutch Replacement Sample
02 Star 1100 starter clutch replacement time lapse
http://www.starmotorcycles.com/assets/service/manuals/2000/LIT-11626-13-36_96.pdf
OEM parts for Yamaha
http://www.sloneservices.com/SilverBack/Other-Stuff/V-StarShopManual99-07.pdf

Jul 04, 2014 | 2005 Yamaha V Star 1100 Custom

1 Answer

2005 yamaha vstar 1100 custom will turn over but why wont it start?


Hi, Anonymous and the usual suspects are:
1. Fuel tank empty.
2. Fuel supply valve/petcock turned off.
3. Fouled spark plugs.
4. Engine flooded as a result of overuse of the enricher.
5. Vacuum hose to the fuel supply valve/petcock disconnected, broken, cracked, or pinched.
6. Fuel valve/petcock or filter clogged.
7. Fuel line to carburetor or throttle body pinched or kinked.
8. Carburetor float stuck.
9. Fuel injectors clogged.
10. Severely discharged or damaged battery, you need 12.5 volts or better and be able to pass a load test if necessary.
11. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
12. Loose or corroded wire connection at the coil, battery or plug between ignition sensor and CDI box.
Spark plug cables in bad condition and shorting check for leakage in the dark, cable connections loose, or connected to the wrong cylinders.
13. Ignition timing incorrect due to a faulty MAP, CKP, O2, TPS, sensors.
14. Faulty neutral, clutch lever, or kickstand safety switch.
15. Faulty fuel pump or fuse or relay.
16. Faulty CDI box.
17. A stuck bent or burnt valve.
18. Tip over sensor needs a reset.
19. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
Re My Yahama Star 1100 wont start Road Star Forum Yamaha Road Star
Starting Problem on vstar classic
http://www.sloneservices.com/SilverBack/Other-Stuff/V-StarShopManual99-07.pdf
OEM parts for Yamaha
http://www.sloneservices.com/SilverBack/Other-Stuff/V-StarOwner%20Manual.pdf

Jun 17, 2014 | 1999 Yamaha V Star 1100 Custom

1 Answer

Starter switch


Hi, Anonymous and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, needs to be 12.5 volts or better and be able to pass a load test if necessary.
4. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
5. Tip over sensor needs a reset.
6. Faulty ignition switch.
7. Faulty starter button.
8. Faulty kickstand or clutch pull in switch/sensor.
9. Starter control circuit, relay, or solenoid faulty.
10. Main fuse or circuit breaker may be blown or faulty.
11. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
Starting Problem on vstar classic
Re My Yahama Star 1100 wont start Road Star Forum Yamaha Road Star
Yamaha XVS1100L Service Manual
OEM parts for Yamaha
YAMAHA XVS1100 Owner Manual

Apr 19, 2014 | 1999 Yamaha XVS 1100 Dragstar

1 Answer

2006 Yamaha V Star 1100 Silverado the starter motor is working but the bike won't turn over


Hi, Anonymous your starter motor is not/was not the problem that dubious title goes to the starter drive/Bendix/clutch which is a separate component that is activated by the starter motor it is a mechanical gear driven part that engages the clutch pack to turn over the engine. It has an internal mechanism that allows the gear to turn in one direction and once the engine starts allows the drive gear to free spin. If gear free spins in both directions then the drive gear has failed, it is not serviceable and needs to be replaced. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
Starter spins but doesn turn over the engine Yamaha Star Forum
Yamaha VStar 1100 starting problem
http://www.sloneservices.com/SilverBack/Other-Stuff/V-StarShopManual99-07.pdf
OEM parts for Yamaha
http://www.starmotorcycles.com/assets/service/manuals/2000/LIT-11626-13-36_96.pdf

Aug 21, 2013 | 2006 Yamaha V Star 1100 Silverado

1 Answer

Removal of motorcycle rear tire/shaft driven


The final drive assembly has to be unbolted from the swingarm and it is removed with the rear wheel. Once the assembly is off the bike, the axle can be removed and the final drive separated from the wheel.

Jul 16, 2009 | 2005 Yamaha V Star 1100 Classic

Not finding what you are looking for?
2006 Yamaha V Star 1100 Silverado Logo

254 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...