Question about 2004 kawasaki VN 1500 Vulcan Classic
2004 Kawasaki Vulcan 1500 Fuel Pump not priming not able to start @
Hi, Mantress before testing any electrical component in the Starting Circuit it is "IMPERATIVE" that you have a fully charged battery of 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a preliminary reading of 12.5 volts or more but little or zero amperage, the battery is faulty and must be replaced. AGM type batteries fall into this scenario more so than lead-acid batteries.
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Engine Run Switch is "FAULTY" or corroded.
4. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter.
5. Bank angle sensor needs a reset or is faulty.
6. FOB battery low or dead.
7. Faulty ignition switch.
8. Faulty starter button.
9. Faulty kickstand, clutch, neutral safety switch.
10. Security alarm needs a reset.
11. Starter relay, solenoid, starter motor or circuit wiring faulty.
12. Starter armature or field coils have failed.
13. Main fuse or circuit breaker may be blown or faulty.
14. Faulty ignition relay.
15. The electric starter is working but starter clutch has failed.
16. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
fuel pump not pumping electrical issue Kawasaki Vulcan Forum Vulcan Forums
Kawasaki Vulcan 1500 Classic Fi Service Manual
OEM Parts for Kawasaki
2003 Kawasaki Vulcan 1500 Classic Owner Manual
Posted on Mar 13, 2018
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: remove a gas tank
there are 2 bolts at the front of the seat, takeoff the seat, unsrew the bolts. that is the only thing holding it on. push the tank forward a bit, then lift up. there are breather tubes under the tank. be careful, they are difficult to get back on depending on the length. there are 2 bolts at the front of the seat, takeoff the seat, unsrew the bolts. that is the only thing holding it on. push the tank forward a bit, then lift up. there are breather tubes under the tank. be careful, they are difficult to get back on depending on the length.
Posted on Nov 10, 2008
go to gadgets fix it page, they have diagrams and step by step instructions to do this, i use his site religiously you can find anything there about your vulcan
Posted on Apr 22, 2009
You may be having detonation. Switch to premium gas. Do not use gas with Ethanol. Change to a new spark plug > NGK DP8EA-9. Run through a couple of tanks of gas and see if the problem has gone away.
Posted on May 23, 2009
It makes a great desktop image.
2002 Kawasaki Vulcan 1500 Classic Fi
2002 Kawasaki Vulcan 1500 Classic Fi
• 2002 Kawasaki Vulcan 1500 Classic Fi
What immediately distinguishes the Kawasaki Vulcan™ 1500 Classic Fi cruiser from the rest of the well-populated class is that it has the look, feel and sound of a mid-1950s motorcycle. But Kawasaki matches the "look" with a digitally controlled fuel-injection system and high-tech features that result in modern performance. Indeed, response to the Vulcan 1500 Classic Fi was so positive that upon its introduction, Motorcycle Tour & Cruiser magazine dubbed the bike "Cruiser of the Year."
The big 90 cubic-inch V-twin engine in the Classic Fi pumps out plenty of torque and power with high-compression pistons and cam timing taken from the original Vulcan 1500. A Mitsubishi digital fuel-injection system feeds each cylinder a high-octane fuel mixture through twin 36mm throttle bodies. A separate intake tract for each throttle body provides smooth engine operation. The tip of each injector contains four nozzles, with two of those aimed at each intake valve.
Two different systems automatically and accurately control the amount of fuel injected into the cylinders. A 16-bit electronic control unit (ECU) uses readings from sensors that monitor engine coolant temperature, intake air temperature, atmospheric pressure, intake air pressure and throttle position to adjust the amount of fuel injected. The overall result is excellent engine response and power with increased fuel efficiency. The ECU also has a special pin that allows technicians to check the fuel-injection system if needed.
There are four valves per cylinder actuated by single overhead cams. Two valve springs are used on all valves to help ensure tight valve closure, while hydraulic valve lash adjusters automatically maintain valve clearance for smooth engine performance, reduced noise and no maintenance. Automatic cam chain tensioners keep cam timing accurate and provide greater reliability with no upkeep. The right-side crankcase and clutch cover are designed to make it easy to check the engine’s oil level and to perform regularly scheduled maintenance.
The engine produces 85 foot-pounds of torque at 2,500 rpm so that a crack of the throttle punches out smooth acceleration. A gear-driven engine counterbalancer and rubber engine mounts reduce handlebar and floorboard vibration, yet the engine retains its distinctive V-twin rumble.
A long, low-slung chassis provides the classic cruiser look. The Classic Fi’s floorboards are positioned to put the rider in an upright and comfortable position. Also, the brake pedal is designed to make it easier to apply the dual-piston-caliper-equipped brake. Other conveniences include wide, five-way adjustable brake and clutch levers for added rider comfort and self-canceling turn signals for easier use.
An electronic speedometer eliminates the traditional wheel-driven mechanism and its speedometer cable for a cleaner look. The speedometer face atop the five-gallon gas tank features an LED display for the odometer and tripmeter, as well as a clock.
Because customizing is integral to the whole cruiser experience, Kawasaki offers a full line of FIRE & STEEL™ accessories for the Classic Fi. Among the choices are numerous chrome pieces, leather bags and trim, backrests, lights, racks and windshields.
With its exceptional performance, nostalgic looks and high-tech enhancements, the Vulcan 1500 Classic Fi is just the ticket for the high-minded cruiser enthusiast.
Kawasaki Vulcan® Cruisers
By introducing the KZ900 LTD in 1976, Kawasaki was an early metric leader in what has become today’s cruiser movement. When the Vulcan® 750 cruiser debuted 10 years later, it was Kawasaki’s first V-twin-powered cruiser and featured high-tech items such as liquid cooling, double overhead cams, shaft drive, dual disc front brakes and mag wheels. In 1995, Kawasaki unveiled the Vulcan™ 800, one of the industry’s first V-twin metric cruisers to feature modern cruiser styling.
For 2002, the Kawasaki cruiser lineup is 10 models strong and ranges from the entry-level Eliminator® 125 to the brand-new Vulcan 1500 Mean Streak. The venerable Vulcan 500 LTD, Vulcan 750 and Vulcan 800 models retain the stylish characteristics that have made them popular, and are now available in new hues.
Also available this year are the Vulcan Classic and Drifter™ models. The Classics include the 800, 1500 and 1500 Fi, and provide a choice in both displacement and technological advancement without sacrificing style. Similarly, the Drifter 800 and Drifter 1500 provide a stylish retro appearance, but in both the mid- and heavyweight-cruiser genres.
In addition to the bikes, a key element to the cruiser lifestyle is customizing the motorcycle to fit individual design tastes and performance needs. Fortunately, Kawasaki offers its own extensive line of genuine Fire & Steel™ accessories. Motorcyclists can choose from literally hundreds of parts to customize their Kawasaki Vulcan motorcycles, and in doing so, make their own bold statement. Customers can find Fire & Steel accessories at their local Kawasaki dealer or shop online at buykawasaki.com.
Posted on Jun 22, 2009
on the bottom chrome band there are like four holes. in your tool kit there is a "thing-a-ma-gidgette" (i call it this because it looks like one, it is actually a "spoke wrench"). the tail of the spoke wrench will fit in the 4 holes Righty tighty so it feels weird: one side you are turning towards the front one side towards the back.
Posted on Jul 16, 2009
Tips for a great answer:
Dec 24, 2016 | 1996 kawasaki VN 1500 Vulcan Classic
Jun 03, 2014 | 2004 kawasaki VN 1500 Vulcan Classic
Aug 17, 2012 | 1997 kawasaki VN 1500 Vulcan Classic
Jul 10, 2012 | 1996 kawasaki VN 1500 Vulcan Classic
May 15, 2012 | 2004 kawasaki VN 1500 Vulcan Classic
May 13, 2012 | 2004 kawasaki VN 1500 Vulcan Classic
May 22, 2011 | 2002 kawasaki VN 1500 Vulcan Classic
Oct 16, 2010 | 2004 kawasaki VN 1500 Vulcan Classic
Jul 19, 2010 | 1999 kawasaki VN 1500 Vulcan Classic
Jul 22, 2009 | 2004 kawasaki VN 1600 Mean Streak
193 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: