Question about Yamaha WR 400 F Motorcycles

1 Answer

The idel is way too high. It happened out of no where. What could b the cause

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

Air leak check the intake boot, mybe air cleaner , or chek ur cable from your handle bars to carb it could have come out.

Posted on Sep 05, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What makes a 1995 chevy 2500 high idle and shifts hard


High idel usually caused by vacuum leak, the high idle will make it shift hard as well.

Jul 22, 2014 | AMI - All Sales MFG 1995 Chevy C/K Pickup...

1 Answer

How to stop a 1999 buick century from ideling high


You have a failed IAC (Idle air control valve) its on the throttle body,11_24_2012_4_07_52_am.jpg

Nov 24, 2012 | 1999 Buick Century

1 Answer

High idel


check if all vacuum air OK . check the idel air Beside idel control .check the agr . or you have bad voltage regulator .

Nov 20, 2011 | 1999 Dodge Ram 2500 4WD

1 Answer

How do u turn the idel down ideling to high


the idle is computer controled and is not adjustable, if the idle is not correct then you must have a computer problem most likely a bad idle control motor....have some oneretreve the trouble codes and that should lead you to the cause of your problem....good luck

Aug 18, 2011 | 2004 Dodge Grand Caravan

1 Answer

Idels high shifts hard and that is like every other time started put in new ecm and still have the issue


Your describing a vacume leak or a mis adjusted throttle body. Does it ever idel down? What engine is in it Desiel? If it's gas the AIS motor might be sticking or is bad. Does it run and is the check engine light on? are all the fluilds correct level? coolant level low can make the coolant senser lie about the temperture of the motor to the ecm and it'll command a high idel. Once the idel motor goes as high as it can it might be shicking and you can remove it and wash it off with carb spray and while it's out with the wire connected turn the key on and off with it in your hand and spray it with cleaner till it moves smoothly. With it retracted install it and try again, any vacume leak will make it idel fast. The trans mission will shift hard if the vacume line to it is off and it's on the back of the intake manifold and it goes to a modulater on the side of the trans. it can be off there too.

Dec 19, 2010 | 1995 Chevrolet Suburban

2 Answers

1995 Nissan Maxima automatic high idle


Idle is set by the compuer, check vacuum lines, a broke ,cracked or missing line will cause higher idle

Jun 20, 2010 | 1995 Nissan Maxima

2 Answers

When startn car engine cold idels high to low ,up


sounds like the throttle position sensor, I think that is the one that makes it idel rough

Apr 10, 2010 | 1987 Lincoln Town Car

1 Answer

Does the pilot screw alter the air intake on the Carburetor of a gsxr 750 slingshot 1988 model


Certainly you best adjust these screws with a vacume gauge set connected and set them all the same as the gauges dictate as the number of turns out is just where you start. The sync needs to be set first with the idel turned up too high when it's right turn the isel back down and check again as the idel is low nows the time to correct differences with the idel mixture screws. As the idel mixture is always on they effect the total mixture at all enf=gine speeds but lesser so at high speeds only noticeable at the gas pump carefully cheaking

Dec 04, 2009 | 1988 Suzuki GSX-R 750 J

1 Answer

2002 NEON IDELS ROUGH AND IDELS HIGH RPM.


sounds like the intake hose from throttle body is not on intake manifold properly..as for the p0700 trouble code,you need trans controller scanned for fault codes..let me know what codes are in trans controller

Mar 15, 2009 | 2002 Dodge Neon

1 Answer

Ideling high


Check Your Throttle Cable It Must Be Hanging Up Somewhere Try Putting Some wd-40 Where It Meats Inlets

Jan 15, 2009 | 2004 Yamaha YZ 250 F

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...