Question about 2006 kawasaki KLR 650

1 Answer

Bike has been sitting for a while. it turns over but will not start. I got it to start a couple of time but it stalls right out. what should i look at to correct the problem.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 707 Answers

Good high octane gas and some carb cleaner for the dipharam in the carb may be gummed up or if injection use injection cleaner with a tune up....Hope this helps.

Posted on Sep 03, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Bike has new battery and i was riding it,parked bike and came back a couple hours later and it was dead. push started it and it was fine,shut it off a couple times after riding places and it started up....


You should start by checking if its charging.
put a volt meter across the battery, it should read roughly 12v
then start the bike and it should rise to 14v
much more than this can blow bulbs and boil batteries

Aug 14, 2011 | 1993 Yamaha FZR 600

1 Answer

Its stalls and hard to start


The next time you have the starting problem, try putting the shifter in the neutral position and try starting. If it starts right up, you have a park/neutral safety switch problem.
As far as the stalling, I would suggest a complete throttle body cleaning as well as a injector cleaning. You can purchase a couple of bottles of Chevron fuel system conditioner. Poor a bottle in the tank and fill with fuel. Run a couple of tanks through and you should notice an improvement.
You might want to stop by your local Auto Zone and ask them to scan your vehicle for trouble codes, it might give you additional clues.
Good luck,
Regards,

Aug 15, 2009 | 1990 Jeep Cherokee Limited

1 Answer

Bike starts and stalls, then doesn't turn over.


if it won't turn over when it's standing, but will when it's not, then it's a pretty safe bet that it's an electrical short!

Jul 21, 2009 | Suzuki RF 900 R Motorcycles

1 Answer

1992 kawasaki Vulcan 750 stops running


Check the intake manifold/s, even a small leak will make it run poor. Being stored for five years then putting it into use, you may have a blocked main jet. Sea-foam is a great product and I would have used that product to store the bike but not to get it running. It is slow acting so it doesnt work like carb cleaner.

Jun 01, 2009 | 1992 kawasaki VN 750 Vulcan

1 Answer

Wont fire turns over faster than normal


if you still havent started the bike yet from sitting.then i dont think the choke has anything to do with your problem.but ether way take the plugs out.I think your piston rings are frozen from sitting.did u winterrize it?with the plugs out pour a little auto trans fluid in each cylinder.very little.now crank the bike over to coat the cylinders. becareful it could be messy now let the bike sit overnight.the next day crank bike over again.but this time for a few tries.then install fresh plugs.and try to start it.p.s there will be white smoke from the transmission fluid. that will go away in a couple of minutes.then all should be good.

Mar 09, 2009 | 2000 Yamaha YZF-R1

6 Answers

Stalling problem from neutral to first gear


Hi and welcome to FixYa,

Initially, if the bike will be run without its own battery, the engine will really stall. This is because there will be no consumer for the voltage output other than the ignition system which will clamp down when the engine is revved and the voltage tends to go higher still.

Just a start, do postback how things turned up or should you need additional information. Good luck and Thank you for using FixYa.

Nov 27, 2008 | 1984 Yamaha XS 400 L Maxim

Not finding what you are looking for?
2006 kawasaki KLR 650 Logo

Related Topics:

142 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

yadayada
yadayada

Level 3 Expert

76649 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...