Question about 2005 Honda CRF 230 F

Open Question

2006 CRF230F was running fine now is running rough sounds like it is missing occasionally. Idles fine but has lost power and misses at higher rpm's

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

rselvy
  • 83 Answers

SOURCE: engine missing threw full rev range and rpm fluctuating at idle

Sounds like you definitely need to do a major tune up, that being you need to adjust the valves and cam chain. You most likely have very tight valves which will cause the erratic idle and misfiring. I'd also check to make sure you don't have any air leaks in the intake manifold. A cracked manifold will certainly cause a problem like this. One last thing would be to make sure the carbs are synchronized. If they are out of synch you will never get the bike to idle smoothly.
Let me know if these recommendations help or not. I'll advise after you post your findings.

Posted on Dec 08, 2008

  • 72 Answers

SOURCE: 2001 929 starts and runs but runs a little ruff

Check your injectors for cracked seals or to see if every thing is tight like it suppose to be.Use johnsons babypowder on your injectors tolook for leaks it sounds dum but you will be surprised what leak pop up

Posted on Mar 20, 2009

  • 33 Answers

SOURCE: Engine running rough

sounds like you need new rings

Posted on May 05, 2009

  • 3567 Answers

SOURCE: my 2006 cb 599 idles too high when warm.

You have an air leak between the carburetor and the cylinder head. Old, cracked rubber fittings between carb and cylinder will let excess air into the fuel mix causing a lean fuel/air mixture. Same is true of "O" rings and gaskets. If there is a leak in the head gasket that can lean the mix also. Fix the air leaks and you fix the problem.

Posted on Jul 07, 2009

  • 130 Answers

SOURCE: My 1985 goldwing runs very rough with a load at

Sounds like a restriction in the slow jets of your carburetors or improperly adjusted mixture screws. You might try a fuel additive like SeaFoam or Gumout. I prefer Yamaha Ring Free, available at Yamaha dealers. It is basically a concentrated version of Chevron's Techron Additive. The label lists two different concentrations you can use, basically cleaning or maintenance. Use the high concentration for a tank of gas, and be sure to change your oil afterward as the directions state.
If this does not clear out the problem, you will likely need to remove the carburetors to clean them.


Posted on Jul 22, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1999 454 idles rough but runs fine at higher rpm's What is the problem?


Possibly wrong plugs,incorrect timing. My 94 5.7 TBI ran rough and found that the spark plugs were incorrect for my engine settings.

Sep 11, 2014 | Cars & Trucks

1 Answer

Low rpm miss


Bad espark plug or bad coil very common on ford to burn the plugs

Feb 08, 2014 | 2004 Ford F250

2 Answers

92 dodge 1500 pick up 360 v8 automatic Starts, runs but hesitates, low power code 37 on diagnostic readour


Code 37 is torque converter clutch solenoid failure. Transmission wont shift in and out of overdrive.

Nov 28, 2012 | Dodge Cars & Trucks

1 Answer

Ford Taurus idle missing


It can be issue with IAC( idle air control valve) causing the problem.


There are many other possibilities causing these idle issues.Engine idles rough.

There are few help links with solutions to troubleshoot such idle issues.

I suggest you refer the link below and follow its troubleshooting details:------

Click the link below:-----
Bad miss at idle? http://technoanswers.blogspot.com/2012/01/bad-miss-at-idle.html

-----------
Stumbling and stalling at idle after engine rebuild?

http://schematicsdiagram.blogspot.in/2012/03/stumbling-and-stalling-at-idle-after.html

------------
1999 Ford F-150 Idles rough and quits when gas pedal is pressed less?

http://technoanswers.blogspot.in/2012/01/1999-ford-f-150-idles-rough-and-quits.html

---------
Engine stumbles coming off idle when warm?

http://repairhelpcenter.blogspot.com/2012/01/engine-stumbles-coming-off-idle-when.html

------------------
Erratic idle on car?

http://schematicsdiagram.blogspot.com/2011/12/erratic-idle-on-car.html

-----------


Cold start problem and vehicle shudder around 2500 to 3500 rpms
http://repairhelpcenter.blogspot.com/2012/10/cold-start-problem-and-vehicle-shudder.html

----------
Low idle when cold out side?

http://repairhelpcenter.blogspot.com/2011/12/low-idle-when-cold-out-side.html

-----------
GMC Sonoma Stalls and idles low

http://technoanswers.blogspot.com/2012/10/gmc-sonoma-stalls-and-idles-low.html

--------


GMC Idle Air Control (IAC) Valve Replacing?

http://schematicsdiagram.blogspot.com/2011/12/gmc-idle-air-control-iac-valve.html

-------------
1996 Camry intermittent engine failure while idle?

http://repairhelpcenter.blogspot.com/2011/10/1996-camry-intermittent-engine-failure.html

------------
Engine quits at idle?

http://repairhelpcenter.blogspot.com/2011/10/engine-quits-at-idle.html

-----------
Car overheats and Air blows hot at idle?

http://howtobyme.blogspot.com/2011/11/car-overheats-and-air-blows-hot-at-idle.html

---------

High Idle Problem

http://repairhelpcenter.blogspot.com/2012/10/high-idle-problem.html

-------
While stop engine idles like cylinder missing?

http://schematicsdiagram.blogspot.com/2012/01/while-stop-engine-idles-like-cylinder.html

---------
Idle flair is noticed on car? Rough idle? car will not idle? Erratic idle speed?

http://technoanswers.blogspot.in/2012/02/idle-flair-is-noticed-on-car-rough-idle.html

--------
High rpm in neutral? Inconsistant high RPM in neutral?

http://technoanswers.blogspot.in/2012/02/high-rpm-in-neutral-inconsistant-high.html

-------
Vehicle stumbling at idle and shows code 54?

http://schematicsdiagram.blogspot.in/2012/03/vehicle-stumbling-at-idle-and-shows.html

----------
Rough idle, staling and Erratic shifting?

http://technoanswers.blogspot.in/2012/03/rough-idlestaling-and-erratic-shifting.html

-----------
While stop engine idles like cylinder missing?

http://schematicsdiagram.blogspot.com/2012/01/while-stop-engine-idles-like-cylinder.html

---------

These details will help.

Thanks.

Nov 24, 2012 | 2001 Ford Taurus

1 Answer

Why does my 1998 sebring idle fine but sputter badly under load.


Does it use spark plug wires or individual ignition coils for the each plug?. My 98 intrepid uses coils and occasionally I have to change them out cause it would start to miss when normal temperature was achieved. If it uses wires, try replacing them, along with the spark plugs.

Jun 21, 2012 | 1998 Chrysler Sebring

1 Answer

2003 Chevrolet K1500 4x4 multiple miss fire code P0300


IS IT POSSIBLE YOU GOT A WIRE CROSSED? or a plug is cracked and or gap closed up? i would check these. you have the 5.3? what kind of plugs are you running?

Dec 16, 2008 | 1998 Chevrolet K1500

Not finding what you are looking for?
2005 Honda CRF 230 F Logo

Related Topics:

180 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

Mike

Level 3 Expert

4336 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...