Question about kawasaki ZX-6R Ninja Motorcycles

1 Answer

The 12f would go through a gallon off oil in a afternoon,its comming out off the exhaust,compression is equal in all cyl,(jetski)

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 29 Answers

Another place oil may enter the exhaust is through the Valve Stem Seal.

Posted on Sep 02, 2010

Testimonial: "right on the mark,many thanks noel from northern ireland.."


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

3 Answers

2002 3.7 litre jeep. How can I ck to see if a valve is fully closing? There is no lash adj. Springs look o.K. no compression #2 cyl. All others o.K.

You put compressed air into the cylinder an listen for the air escaping , if coming out of the throttle plate ,burnt intake valve . If you hear air coming out of exhaust pipe , burnt exhaust valve . If you hear air coming out dip stick tube bad rings or piston damage. How To Perform Leak Down Test EricTheCarGuy

Mar 02, 2016 | Cars & Trucks

1 Answer


There are too many design changes to determine the HP of an engine. Timing, compression ratio, and the type of fuel determines the HP of an engine. There is no direct correlation between the cc and an engine and the hp it produces.

Oct 06, 2014 | Yamaha 96 Waveraider 760 Air Temperature...

1 Answer

Ultra 150 jetski when driving smoke is coming out the exhaust more then usual I don't have any coolant and cap of oil is clean this is a jetski

what colour is the smoke , white or blue ?
is it cooling ok ?
are all 3 cylinders working , remove two plug leads and see if it fires etc , compressions ok ?

Aug 03, 2014 | Boating

2 Answers

Blue smoke in the exhaust

Have you checked your oil? If it is low add the oil but blue smoke usally means the motor is using oil could be the rings or broken rings you will have to check the compression in the cyl.

Jan 09, 2012 | Cars & Trucks

1 Answer

My 1991 wrangler 6 cyl runs for few min then what appears to be exhaust and some oil comes out pvc and dipstick, whats wrong?

Sounds like a compression ring in one of your cylinders has broken and compression is being pushed into oil pan. Cylinder compression getting past the piston, instead of going out the exhaust it's going into oil pan and coming through engine (dipstick, air cleaner, PCV.) You'll need to have a compression test to confirm.

Jan 08, 2011 | 1991 Jeep Wrangler

1 Answer

1400 kawasaki 4 stroke jetski Engine surges ,looses 1 cylinder on and off whilst in operation

Change your spark plugs , and gap to spec . Also check coil for cyl that you think is cutting out
be very careful put your hand over end of exhaust pipe you think is giving problem . Also if bike has been sitting with old gas , replace gas and filters. you will be proud of your self for doing so.

Nov 18, 2010 | kawasaki KZ 1300 A2 Motorcycles

1 Answer

Need timing marks for 2002 ford explorer 4.0 engine. trying 2 check timing chain. any one know specs

There are no marks on this one. There is a special tool set to align camshafts ($900). The best you can do is to bring #1 cyl to TDC compression with both cam(valve) covers off. #5 cyl should have lobes at equal opening, exhaust just closing and intake just opening.. #1 cyl cam lobes should each be diametrically opposed to the positions of #5. If cams need to be moved, there is no registration of gear onto cam. Just loosen bolt holding gear and move cam. Retighten bolt. Roll thru 2 crank revolutions and check cam timing again.Simple.

Jul 24, 2009 | 2005 Ford Explorer

1 Answer

Oil Leak at exhaust flange

No major problem. The proper mix is 32 to 1 gas and oil. That equals 4 ounces of 2 stroke ENGINE oil to one gallon of gas. Do not use MOTOR oil in the gas. 10w40 motor oil is what goes in the gearbox. Tighten the exhaust flange.

A top ranking please ... Thanks BJS!

Apr 25, 2009 | KTM 250 EXC Motorcycles

1 Answer

Help Me With 92 Toyota Camry LE 4 cyl...

should be a 14mm drain plug on the oil pan. you remove that until no more oil comes out. then put drain plug back in. it should be the only 14mm bolt on the bottom of the pan. then you will have a oil filter below the exhaust manifolds than needs to unscrew. replace with a new one. then fill your engine with 1 gallon or 4 quarts of oil.(same thing) thats all you should need.

i dont know but if you learngin how to work on cars thats a nice car to learn on. it pays off to repair your own car in the long run. you save so much money. :) GOOD LUCK!

good luck,

Apr 23, 2009 | 1992 Toyota Camry V6

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

150 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4535 Answers


Level 3 Expert

76649 Answers


Level 2 Expert

342 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides