Question about 2005 Suzuki RM 125

1 Answer

The carb seems to be sticking at full throtle. It does not appear to be cable or throtle. we have checked the two. I have notice the motor will rev and miss a bit when the sticking accures. It use to stick only at full throtle and that was once in a while. today it stuck at half throtle.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Suzuki Master
  • 4,514 Answers

Take carb off clean or disassemble it acording to what the shop manual sez--it has alot of gum n varnish from the heat of use

Posted on Aug 30, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Husqvarna 45 carb jet blocked


Could be a fuel starvarion problem. Theres one thing you could try before you try stripping and cleaning the carb. Back off both tuning screws, and pull over till it fires. Then screw both back in and reset them to standard. H3/4 of a turn anticlockwise, L1 full turn anticlockwise. Then try firing it up again. Sometimes its enough to cklear any dirt in the carb. Failing that, Its a strip and clean.

http://www.ebay.co.uk/itm/Evinrude-Johnson-Mercury-Yamaha-Outboard-Motor-CARBURETOR-CARB-CLEANING-TOOL-/261167700551?pt=Boat_Parts_Accessories_Gear&hash=item3cceceda47

These carb cleaning tools are great, but you have to know where and where not to be putting them. Certain parts of Zama carbs and Walbro carbs have tiny valves within the carb. So be carefull.

Apr 15, 2013 | Husqvarna Garden

1 Answer

2006 Hawkeye sputters at full throtle. Take air boot and air cleaner off runs fine. put just air boot on it starts to sputter at full throtle. Not even the air cleaner just tube from carb to air clean


that might be the overflow tube and should not be hooked to anything, it's like a emergency drain for the carb and when you hooked it to the filter is pulling gas out of the carb at high motor speeds causing it to sputter .. jay

Aug 28, 2012 | Polaris ATV

1 Answer

I have a 96 gs500e suzuki that idle fine but when you rev it up past 3000scientifically the idle climbs to 4500you and sticks it does not seem that the throttle cable is bound up because the actual...


Hey David, has this bike been "tuned-up" lately..have the valves been adjusted?.. This sounds like an air leak, OR the intake valves are too tight.....or other carb issues...if this continues.. take it to a QUALIFIED professional... they will fix the carbs...

Jul 24, 2017 | 1996 Suzuki GS 500 E

1 Answer

Runs at full throtle and then stops


sounds like you have a crank seal out of it, you ncan try to clean carb and check fuel lines etc, but usually when they rev high with out giving throttle means there is an air leak Good Luck 2StrokeJim

Nov 19, 2011 | Poulan 25CC Gas BlowerVac

1 Answer

Hello I bought a Honda CBR 400 when you use the throtle it dies a bit but revs also noticed fuel leaking from carb ? how much do you think will this cost Thanks Steve!


hi there you could first start by stripping the carb down sounds like the jets could be stuck or damaged in some way or could ust need ajusting

May 22, 2011 | 1987 Honda CBR 400

1 Answer

Hello, I just purchased a 125 cc yamaha XTR equipped with a 3D6 Mikuni carb, and even brand new the RPM increases routhly most of all with no gear engaged until too hight RPM and the decreases. Seems to...


check for flooding carb/ carbs. set propper float levels. make sure the throtle cable is adjusted from the top and the bottom. make sure the carb flys are closing all the way. sounds more like a flooding problem.

Jan 06, 2011 | Yamaha XT 125 R Motorcycles

2 Answers

My banshee keeps sticking in high revs


Your throtle cable or the carb it stisking. Check the cable for kinks and lube the cable that goes threw the cable housing with cable lube. Do not use w-40 cause it attacks dirt.

Sep 30, 2009 | Yamaha BT 1100 Bulldog Motorcycles

2 Answers

Pore idle cold w/choke/warm reves 4 or 5000 on its own


hi m8y,, soundz like the needles in the carb are sticking,and the diaphram barrels in the carb arnt sliding closed easily,,,or u have a slightly bent needle,, pull the carbs off and using your finger lift the needle barrels up and see if they slide closed if they aint then theres a bent needle,, and check all 4 seat the same,,, also check u dont have pin holes in the diaphrams to,that will make it rev like mad,, check this 1st m8,, if no change come back and il take u threw next step,,cheers m8,

Apr 27, 2009 | 1982 Yamaha XJ 650

2 Answers

1993 blaster wont stay running


try cleaning carb and see if the choke is hung up also make sure it has the right plug ngk b8es

Feb 22, 2009 | 2003 Yamaha YZ 250

Not finding what you are looking for?
2005 Suzuki RM 125 Logo

Related Topics:

144 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Ed Nelson
Ed Nelson

Level 2 Expert

149 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...