Question about 2007 Bajaj Pulsar 150

1 Answer

WHY DOES ONE RED LIGHT IS GIVEN IN RPM METEER

Posted by on

  • Mohammad Saleem Shah Jul 01, 2013

    Sorry, I mean Tachometer instead of Odometer

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

For two reasons.
1. When the odometer crosses 90000 rpms
2. When the fuel will reach just near the reserve mode

Posted on Jul 01, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Alternator or Voltage Regulator or Other?


You will need to test the charging system. Try this simple test, hook a voltmeter to the battery and check the voltage with the key turned off. Should be 12 volts. Now start the engine and note the volt meter reading at idle, it should go up to about 13.8 - 14.2 volts. Rev the engine up and note what happens. If the voltage is low at low RPM 12V and then goes up with more RPM like you stated it could be the regulator or the alternator. Start by switching out or trying another voltage regulator. If this does not fix the problem you will need to test and repair the alternator. The alternator out put can be tested by bypassing the regulator. This requires special equipment and know how. I hope this gets you

Jun 30, 2015 | Honda GL 1500 SE Gold Wing Motorcycles

1 Answer

On my 2005 F/expdn, if I am on red light stop, when rpm goes under 50 x 1000 my car shutdown. If I keep it above 50 by pressing accelrator is OK, pl suggest


1st your car should not idle below 110 rpm even in gear

idle problems on these are caused by both broken or open vac ports or a dirty throttle body the A/F ratio cant get a correct reading

Feb 18, 2015 | 2005 Ford Expedition Eddie

1 Answer

High rpm at idle


Check the vacuum hoses, and the intake manifold gasket for a leak.

Feb 14, 2014 | 2001 GMC Jimmy

1 Answer

RPM is high on 2012 Versa


If Transmission fluid level is correct (with vehicle running etc.). You could have an issue with the transmission not being in the right gear. Other wise throttle position sensor could be the issue. This is why service centers need to do proper diagnosis because you should be in drive when your at the red light but you say its good in drive, park and neutral ?.

Bring it in.

Jan 14, 2014 | RPM Air Gap; Intake Manifold - 7107

1 Answer

What RPM should you change gears in 02 xterra


That is not a question that can be given an answer that works for everyone, what ever suits you. Never exceed the Red zone in RPM.

Jul 10, 2012 | Cars & Trucks

1 Answer

Engine stalls on red light


increase the engine rpm by adjusting the accelerator cable from under the hood to a higher rpm.
it only stall when the rpm get too low

Oct 15, 2011 | 1999 Dodge Durango

1 Answer

Truck slightly jerks when switching gears


Given how little it's being driven there's a good chance it's just a vacuum leak or a bad modulator. neither one of these are very expensive to fix.

Jun 07, 2010 | 1999 Chevrolet Blazer

2 Answers

I have a Bosch next dryer that doesn't get hot???


there is a reset button on the hi limit thermal fuse located on the side of the heating elment can. this can be accessed by removing all the screws on the back apnel of the dryer( Make Sure the Dryer is Unpluged).once the back panel is removed there will be a black thermal fuse with two wires attache and a smalle red button between the wires bush this button in and this will reset the thermal fuse .if you have an ohm meteer check the continuity of the elment and verify that it is good.i hope this helps good luck with your dryer.let me know how things work

Jan 20, 2010 | Bosch Nexxt WTMC 3300 Electric Dryer

Not finding what you are looking for?
2007 Bajaj Pulsar 150 Logo

Related Topics:

458 people viewed this question

Ask a Question

Usually answered in minutes!

Top Bajaj Experts

sachin sharma
sachin sharma

Level 2 Expert

171 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4535 Answers

Are you a Bajaj Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...