Question about 2002 Suzuki GSX-R 600

1 Answer

I have a 2002 gsxr600 and there is a hole under the #1 header on the head that is shooting out air and i can start it but its realy loud and if i dont give it a little gas then it shuts off cause im guessing its not holding compression any ideas?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 224 Answers

If the hole is in the head and not the header pipe, Then you need a new head and maybe some internal parts as well depending on what made the hole

Posted on Aug 25, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Mini digger over heating


several possible problems
1 if the stud holes were not cleaned out with a thread tap and compressed air then you will be bottoming out the studs at the head tension settings but not compressing the head onto the head gasket correctly
2 head is warped/ cracked and needs shaving and crack detecting
3 cracked cylinder wall/s
4 blocked radiator fins and cores

Aug 27, 2016 | Mini Cars & Trucks

1 Answer

My 115btu redi header won't run with the hood on


This sounds as if it is a problem with either a partial fuel blockage or a low air pump pressure. Low air pump pressure could be caused by cracked or damaged air line from compressor to burner head, or the plastic end that holds the air filters has a hair line crack, letting the pressure away. You may need to inspect thwe plastic end under a bright lame and flex it between youe fingers and thunbs to see the damage, look around the outside, across the middle and near the bolt holes and adjuster. Damage to the nozzle housing or the rubber nozzle seal , letting air into the fuel line and escaping, could also cause the problem. You need to inspect everything carefully.

Feb 22, 2014 | Reddy Heating & Cooling

1 Answer

What is wrong with my 2009 kawasaki ninja 250r?? is it a crankshaft issue?


If it is a loud air type sound you probly have a vacuum leak some where, Check your air filter and all hoses to make sure there are no holes, Also a hole in your exhaust or leaky gasket at the header could be a cause.

Sep 05, 2012 | 2009 kawasaki Ninja 250R

1 Answer

My bikes actually a 2000 gsxr600 anyway I was riding today and when I took off from a stop the bike lost all power and backfired real loud so I pulled the clutch in and barely got it home. When I got it...


not a good idear adding more oil to the fule it realy dont need it and it only gloos up the works,,,as for this fuse blowing it could be your battery took a wack and you busted the plates inside it but that wont do anything to the head lights thats another fult

Jun 13, 2010 | 1999 Suzuki GSX-R 600

1 Answer

Engine light is on car is running rough


when car is running spray some starting fluide on all the hoses and throttle body to find leak the car will rev up when spray is sucked in leak. good luck cj

May 14, 2010 | 2002 Cadillac Deville

2 Answers

Acer Aspire 5570z laptop CPU Fan


me to !!

it's seem is the fun is broke

Apr 11, 2010 | Acer Aspire 5570-2067 Notebook

1 Answer

I have 2002 jeep cherokee and radiator fan stays on when jeep is off. Pulled fuse and it shuts off, put fuse back in it turns on. Someone told me it was the realy switch. Where is it located?


the relay switch is located behind the passenger side head light. I just replaced mine 2 weeks ago. The manual says to remove the bumper, but this is way too much work. I cut a 3" x 5" hole in the plastic with a dremel tool. Start 6" from the fender make a small hole so you can see it. It is a blue box 2" square.
The price for the relay in Canada is $110.00, dealer only!

Oct 21, 2009 | 2002 Jeep Grand Cherokee

2 Answers

Where is the cooling fan rlay located on a 2002 jeep grand cherokee 4.0 cyl


Your cooling fan relay is located below the passenger front head light under the hood.

Jun 08, 2009 | 2002 Jeep Grand Cherokee

1 Answer

2002 lancer started to overheat.


While the car is cold, take off the radiator cap. If you cannot see coolant, fill the radiator with coolant until you can see coolant standing in the radiator. Start the car, and go look at the coolant. Can you see a steady stream of air bubbles in it? If you can, the air is coming into your cooling system (and coolant is exiting) from a leaking head gasket, cracked head, or cracked block. Did you remove the head when you installed your headers? If so, the gasket was probably improperly replaced. Are you getting white smoke from the exhaust? That's an indicator of water in the exhaust.

Jan 01, 2009 | 2002 Mitsubishi Lancer

Not finding what you are looking for?
2002 Suzuki GSX-R 600 Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

Richard
Richard

Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...