Question about 2005 Hyosung GT 250

1 Answer

Thers a radiator in front of my bike what is it and why is it ther

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 2,100 Answers

Your bike is water cooled, it is in the front to catch the wind to keep it cool, don't take it off. Hope this helps.

Posted on Aug 25, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How much 134a does it take to refill if empty for a 2007 nissan quest

One or two..start w one. Make sure thers no leaks and condensor in front of radiator is garbage free

Jun 18, 2018 | Nissan Cars & Trucks

1 Answer

Nissan r32 skyline front window wiper not working but rear is still working and the front still sprays washer fluid

Check if ther is power to the front wiper moter when its on if ther is power then replace the moter, if no power check wiring.

Apr 04, 2014 | Cars & Trucks

1 Answer

Yamaha aerox 100cc

Engine seized

Jun 30, 2013 | Motorcycles

1 Answer

I bought a 2007 R1 thers no key and thers no ignition system and i wana get the bike started without costing me an arm and a leg is this possible thanx

The ignition is coded to the ECU and are a set
If you have the red key you can re- use ignition switch but will need a new ECU ,as once they are paired,cannot be changed and bike will not run. You cannot use S/H unless they are a set with keys.

Aug 11, 2010 | Yamaha YZF-R1 Motorcycles

1 Answer

On the zxr750 h2 at the bottom of thermastat housing ther is a small water pipe , where does the pip go to

water pipes either go to your radiator at the front of of your bike, or to the water bottle :) if tis not them, uner your ptrol tank there is your water pump, it could go to there :)

Jul 31, 2010 | 1990 kawasaki ZXR 750

1 Answer

I have had the bike a month its done its engine break in its done 650 miles the engine seems to have lost a little power. ther is a bit of vibration all over the bike wich wasn't ther when i was riding it...

During break in, everything breaks in. Valves need to be adjusted,bolts loosen(check your engine mounting bolts),steering neck bearings need to be adjusted,carbs need tuning,etc. 600 mile check ups often include changing the plugs along with the oil. You need to go over the whole bike with a fine tooth comb, it's probably a motor mount bolt.

Jun 24, 2010 | 2008 Yamaha YZF-R125

2 Answers

Replace cooling system thermostat

Follow top radiator hoze to the engine block. The item it is attached too is the thermostat hosing. Remove coolant for the radiator. Remove theromastat housinf. Remove theromastat.Clean all casting surfaces for new gaskert. Place gaskert and sealer on cleaned surfaces as well as the new thermostat in exactly ther same position as the ond one came out. Tighten bolts evenly. Refill the radiator with the coolant. Add extra coolant to replace what was lost. 

Sep 22, 2009 | Cars & Trucks

2 Answers

Need to install a starte solonoid in a 1982 yahamaha XS400R

hi if you follow the wire from the starter motor it will lead you to wear the solonoid goes
ther should be two large wires one from the battery then one fron the starter then ther will be two smaller wires that operate the solonoid

Jun 20, 2009 | 1982 Yamaha XS 400

1 Answer

Where is the ink cartridges

Ink cartridges are usually located on the inside of the machine behind the front door


Open any and all doors on the copier (usually front door)

some copiers are **** shell in design and ther is a release on ther left hand side as your are facing the front of the machine...pull release and it pops up

in either case look inside usually in the upper right corner

you will see handles for removing the cartridge or charger etc and drum etc

some copiers have ink and photo image as one

ther is usually a diagram on the inside cover..follow those directions

after removing the cartridge read directions on replacement ..close all doors and and you are ready to go!

good luck

If you still have problems send make and model and we can be moe specific

Jan 09, 2009 | Office Equipment & Supplies

1 Answer

Engine mounts

who told u ther was 4?
ther is only 3

Jul 16, 2008 | 1992 Toyota Celica

Not finding what you are looking for?
2005 Hyosung GT 250 Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyosung Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4988 Answers


Level 3 Expert

80417 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Hyosung Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides