Question about 2000 KTM SX 250

1 Answer

How do i install my new rear brake pads on my 2000 ktm 250sx

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Take it to a shop. If you have to ask, you dont need to be working on it.

Posted on Nov 05, 2012

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

scott_77
  • 48 Answers

SOURCE: Bleeding Rear brakes on KTM 250SXF

Get someone to pump the brake pedal a few times, and someone else to undo the bleed screw, it will be a small grease nipple looking thing on the rear caliper. Undo the screw then re-tighten it, holding the pedal down the whole time. Repeat until fluid comes out of the screw, then do it a couple more times to be safe. Be sure to wipe the fluid off your bike as it strips paint. Also make sure the reservoir has plenty of fluid in it before you start.

Posted on Apr 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I put a 2011 ktm 250sx rear fender on?


Hi, Dylan for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your KTM, despair not, for a mere zero $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Back fender instal procedure KTM 530 exc
New Acerbis Plastics Install on KTM 300 XC Time Lapse Video
KTM 250 sxf 2016 Repair Manual
http://www.partsfish.com/page/oem-parts-for-ktm
KTM 250 SX 2010 Owner Manual

Mar 28, 2017 | 2011 KTM 250 SXF

1 Answer

Ktm 250sx 03 shifter shaft sticking


Is this a genuine part if not the part may be at fault also if not is there any dirt through the hole in the crank case the gear shaft goes through a simple solution is to use a multi tool and sand the shaft or crank case hole

Oct 10, 2013 | Motorcycles

1 Answer

Need to replace brakes on 2000 GMC Safari. does it have disc brakes all around or drum rakse in rear?


Disc brakes in the front and drum brakes in the rear. Make sure that you repack the front bearing's with wheel grease before finishing the job.If the front rotors and or the rear drums have a rough brake pad surface,get them resurfaced before installing new brake pads or brake shoes in the rear. you can go online or your public library for complete instructions on how to replace the brakes on that vehicle.

Apr 01, 2011 | 2000 GMC Safari

1 Answer

What could cause a KTM 250SX transmission to


Either the shift linkage could be binding or you may need to adjust the clutch.
The other problem might be a synchronizer in the transmission going bad.

Jul 30, 2010 | 2005 KTM SX 250

3 Answers

Rear brake lock up on KTM LC4


When was the last time you checked/changed your rear brake pads? This isn't really easy to miss, with the reduced braking power and different sound when braking, but if you have worn the pads so much, that the pad's metal surface (or even the cylinder itself) has gone out and stuck into disc, you could have a problem... For starters, remove your brake caliper, and have a look inside, this can be done easily.

Jun 20, 2009 | 2000 KTM 640 LC4

1 Answer

How do I adjust the parking brake?


Loosen the cable nut at the rear brake, pull the cable until the tension is tight, then tighten the cable nut. Since the parking brake only operates on the rear brakes, your rear pads may be too worn causing the parking brake not to hold. Check the pads first to see if they need to be replaced. Also, the parking brake cable can stretch or break over time. Verify that isn't case since you may need to install a new cable rather than adjust it.

Apr 30, 2009 | 2000 Ford Explorer

2 Answers

Oil


Correct me if I'm wrong but the 250SX is a 2 Stroke engine with a Gas (1.98 Gals Unleaded Premium 91 octane Recommended) to Oil Mixture (using Motorex Cross Power 2T at a 40:1 - 60:1 depends on oil quality) and when KTM says to Change the transmission oil the amount called for is 0.7 liters engine oil using Motorex Top Speed 4T 15W50. These Quanities are from an 04 250SX could not find a 2000. So consult with your local KTM Dealer's Service Department and pickup a Owners Manual at the same time it would be in your best interest. Liter breakdown 0.7 liters = 0.739681 quart (US liquid) OR 0 quart (US liquid) and 1.47936 pt (US Liquid) / 0.7 liters = 1.47936 pt (US Liquid) OR 1 pt (US Liquid) and 0.958726 cups (US)

Nov 10, 2008 | 2003 KTM SX 250

1 Answer

New brakes


Still have air inside, because you used gravity feed method.

Jul 17, 2008 | 2000 Chrysler Cirrus

Not finding what you are looking for?
2000 KTM SX 250 Logo

Related Topics:

124 people viewed this question

Ask a Question

Usually answered in minutes!

Top KTM Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Are you a KTM Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...