Question about Harley Davidson FLSTCI Heritage Classic Motorcycles
Hi Johnrobindan, and the usual suspects are:
1.Ignition/Light Key Switch not in IGNITION position.
2.Engine Stop switch in the OFF position.
3.Discharged battery, loose or corroded connections check negative cable at both ends. (solenoid chatters).
4. Bank Angle Sensor tripped and Ignition/Light Key Switch not cycled to Off and then back to
5. Starter control circuit, relay or solenoid faulty.
6. Electric starter shaft pinion gear not engaging or over-running clutch slipping.
For a prime suspect please visit website below and good Luck.
Harley Diagnostic Codes 04 to Present
Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e
Posted on May 20, 2015
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
The oil drain us usually a hose with a plug in it that is held by a clip on the frame. It us usually on the right hand side of the bike just behind and underneath the transmission side cover. Loosen the clamp and pull the plug out. The oil will run out of the tank. Replace plug and add new oil to the tank.
Posted on Sep 24, 2009
The fork oil is a very specific job needing a manual and a special tool, I don't want to insult anyones mechanical knowledge but if you have never done it before, best to take somewhere else. Engine oil on the other hand is easy, the drain tube to any softail is on the right side by where the frame meets the swing arm, has somekind of plug in it. Start and run bike for a little while, long enough to get it warm but not hot. Remove fill plug and then remove plug in drain line. Using a peice of cardboard or something put in between filter and frame , directing the oil to your drain pan instead of where ever it goes. Put 1 qt oil back in (after everything is reinstalled) start the bike and make sure the oil light goes out, when it does shut bike off and fill to the point that when it is standing upright you get a little oil on the tip of your finger, over filling may result in loss of oil cap from pressure (been there)
Posted on Feb 16, 2010
Tips for a great answer:
Mar 08, 2018 | 2006 Harley Davidson FLSTCI Heritage...
Dec 15, 2014 | 2006 Harley Davidson FLSTCI Heritage...
Jul 30, 2014 | 2005 Harley Davidson FXSTS - FXSTSI...
Apr 21, 2014 | Harley Davidson FLSTC - FLSTCI Heritage...
Dec 30, 2013 | 2006 Harley Davidson FLSTCI Heritage...
Feb 16, 2013 | 1995 Honda Accord
Jun 18, 2012 | 2000 Harley Davidson FLSTC Heritage...
Mar 16, 2012 | 2000 Harley Davidson FLSTC Heritage...
Apr 12, 2009 | 2005 Harley Davidson FLSTC - FLSTCI...
301 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: