Question about kawasaki VN 1500 Vulcan Drifter Motorcycles

1 Answer

How can i drain a little oil - VN 1500 Vulcan Drifter kawasaki Motorcycles

Posted by on



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 220 Answers

Well if you can remove the oil filter it will have about 1/2 quart or less in it.

Posted on Aug 24, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Can't find the oil drain plug

Most small engines don't have an oil drain plug. Open the oil filler cap and flip the unit upside down and let it drain into a suitable container.

Apr 10, 2014 | Little Wonder LB270S Optimax 265cc Subaru...

1 Answer

Changing motor oil

Hi Anonymous, it's a common mistake your not alone. Engine and transmission oil live in the oil pan underneath the transmission. The engine oil drain plug is on the left side rear corner, and the transmission drain plug is on the bottom right.. Good luck

Apr 06, 2014 | 2007 Harley Davidson FXDB Dyna Street Bob

1 Answer

Where is the oil drain plug located?

how much is a little and how does anyone confuse a gas filler neck with an oil fill cap, they are in two completely different locations. if you haven't put in more than a cup of gas then it will burn off and not cause a problem therefore you won`t have to do anything but drive it. if its more then the drain plug is on the bottom of the OIL pan and you will or should change the oil and the filter as the gas will be in the filter as well.

Nov 29, 2013 | Daewoo Cars & Trucks

1 Answer

The oil doesn't drain out of my 2001 Harley Davidson Dyna When I remove the oil plug only a half quart of oil drains out. Dipstick is removed and oil is hot.

Are you sure you're pulling the correct drain plug?
On Harleys with the oil tank under the engine, there are usually two drain plugs, oil and transmission drains.
Also, some have a drain on the bottom of the engine, which only a little residual oil will come out of it.
Finally, when the oil stops draining from wherever you're draining from, does the oil dipstick show that the oil level has dropped?
If not, you got the wrong plug!

Aug 07, 2013 | Harley Davidson FXDL Dyna Low Rider...

1 Answer

Where is the oil filter located? Where does the oil drain from?

The oil filter is Almost always on the passenger side lower half of the engine. If it is external ( on the outside of the engine) it should be the size of a pop can only a little shorter and a little fatter. The oil drain plug is located at the bottom of your oil pan. It's the pan on the bottom of the engine.

Sep 06, 2010 | 1993 Nissan Pathfinder

1 Answer

Twhere is oil drainplug located

The oil pan is on the bottom of the transmission. There are two plugs in the oil pan, one for engine oil and one for transmission drain. The one closest to the left front corner is the engine oil. Loosen the drain and allow just a little of the oil to drain out and check it. It should be dark colored and smell like engine oil rather than transmission oil. The transmission oil drain is nearer the center of the transmission.

Good Luck

Aug 14, 2010 | 2002 Harley Davidson FLHT Electra Glide...

1 Answer

Change the oil on a 2000 Dodge Caravan

Jack up pass side.Put cardboard, BIG piece under engine just in case. Using a pan to drain the oil in put under oil pan drain plug. Remove drain plug with socket wrench. Let drain 5 min. Check the gasket on the drain plug, if bad replace with new gasket .99 cents to replace gasket only on plug. Put plug back in DO NOT OVER TIGHTEN the plug. Slide drain pan with drained oil to the front to remove oil filter. Using a filter wrench remove oil filter. Let drain. When installing new filter put a little new engine oil on the rubber gasket on the filter with your finger. Screw filter back on tighten with filter wrench. Fill van with oil from front valve cover opening.

Nov 21, 2009 | 2000 Dodge Caravan

2 Answers

Engine smokes on starting then quits smoking on acceleration.

4.3 liter and or any of the V-8's the valve seals , little rubber rings get old and brittle and no longer do the job.
what happens when you shut the engine off the oil from the rocker arms flow down the valve stem and collects then when you go and start the car you get a little shot of motor oil into the combustion chamber, hence a little blue smoke for 20 -30 seconds something most of us live with as its more of a pain to fix than it is to live with.

Nov 12, 2009 | 1984 Chevrolet Camaro

1 Answer

How do you change the oil in a 2000 Chevrolet Malibu?

The same as you would in almost any other car. Crawl underneath (easier done with car jacked up a little). Locate the drain plug on the oil pan (cant remember which side its on.) remove it and let the oil drain. Then locate and remove the oil filter. Wipe a some oil on the rubber seal of the new filter so it can seat a little better. Replace the drain plug, pop the hood, open the oil fill cap on the valve cover and 4 or 5 quarts of 5w/30 NOT 10w/30.

Jul 11, 2009 | 2000 Chevrolet Malibu

1 Answer

How do i change oil in 2002 saturn sc2

you will need approx. 5 quarts of Oil 10W 30
you will need an oil pan, rags an oil filter wrench(walmart--very cheap). New oil filter obviously. 14mm wrench or socket for the drain plug.

Procedure: let car warm up (this will help drain all oil out faster and more efficiently)

take drain plug out first,
let that drain while you place a little oil in the new filter (if it is a horizontal mounting filter then there is no need to put any in)
use your oil filter puller and take off the old filter. that may have a little residual drainage; after that place the new filter in and then replace the drain plug(once all the oil has stopped running out. a little bit left in there won't hurt) place at least three quarts in to the filler hole. then start the engine for aproxx 30 sec. This will allow the oil to fill the oil filter and also heat it up a bit. let it sit for a minute then check the level. It may take a little over 4 quarts, you will have to check the dip stick as you pour more in. take it for a test drive then park on the level, let it sit for a minute, then check it again. if it is way over then you must drain some back out. over filling can damage your engine.

Jun 25, 2009 | 2002 Saturn Sl

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

75 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4749 Answers


Level 3 Expert

78267 Answers


Level 2 Expert

342 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides