Question about Triumph Trident 750 Motorcycles

Open Question

How do you wire up the red charging light?. - Trident 750 Triumph Motorcycles

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Harley davidson electra glide 2001,batter when dead,charged on slow charge on the bike,now have red key light flashing,no ignition,can you help,thanks


Not sure what the red key light is.. Possibly anti theft?? If you recharge a battery, you should disconnect all wiring from it first. try disconnecting the bike battery connections, recharge the battery and when charged, reconnect the bikes connections. Hope it works.

Jan 05, 2015 | Motorcycles

1 Answer

Wheel Horse 111-B&S 11hp eng-where do i conect red & black wires from charging system


Hi,
Your Briggs & Stratton uses a dual circuit type alternator. One side of the unit produces up to 3 amps of DC electricity via a one way diode so that only the positive charged electrons pass through converting the AC from the alternator into DC after passing through the diode. This wire will have a slight lump just before the wire terminates at the plug. This is the wire that will be red and it needs to be connected either to the battery side of the solenoid or directly to the positive terminal of the battery. This keeps the battery charged an also provides enough power at full speed to run the electric clutch.
The other wire does not pass through a diode and therefore produces AC current for the lighting system only. This will be the black wire after the connector. The black wire connects directly to the headlight switch. The AC side produces 5 amps at full speed and therefore enough to power 60 watts of lighting at 12 volts. The typical 1156 bulb uses 28 watts x 2 = 56 watts and if the unit has taillights they are normally 3 watt bulbs. The headlights will be dim at low speed and reach full brightness at full speed.
In Summary, red wire to battery and black wire to light switch.

Hope this helps.

Apr 07, 2014 | Garden

1 Answer

What wire on the ignition switch goes to the alternator on a 86 thunderbird


The gray-yellow wire from the key switch powers the charge light.
The light green-red wire goes from the charge light to the alternator.

Apr 16, 2013 | 1988 Ford F 150

2 Answers

My blackberry curve 8520 is at low battery and wont charge or show the charge lightning bolt


King, many times this happen, don't worry, put your device on charge 2 to 5hours it will solved, if problem persist, change battery, because this sounds me a only battery problem. there is one another way (if you are not sure don't try this) we call that direct charging
first take one charger who has light on head and then cut the charging connector of charger and then you will see two colours of wires separate the black and red wires (red wire is positive line and black is negative line) and then connect to current supply but make sure there wire are separated otherwise it will have a short circuit and then take battery and search + and - connector and then red wire connect on battery positive connector and black on negative connector if you connect properly you will see the charging light are getting dim. that mean it is charging, do direct charge for 10 min and then switch on your device with battery and put in charge normally. this will solve your problem. if my sugetion was helpful please rate it.

Jul 02, 2012 | RIM BlackBerry Curve 8520 Smartphone

1 Answer

My battery charger for my Jazzy 600 does not light up or get warm when I plug it in. The chair has not been used for months.


I tried to charge my jazzy. The charge light (red) remained on for several hours. Finally I moved the wire slightly the charge light turned green than faded to red. What is my problem? Your solution would be greatly appreciated.

Jun 04, 2012 | Pride Jazzy Select 6 Indoor Power...

1 Answer

I need to know how to wire the batteries together on my shoprider jimmie chair so they will charge


If the charger is 24 volts and you have 2 12 volt batteries they have to equal 24 volts , so wire the batteries terminals red to black and connect the charger to the other terminals red to red and black to black.

Feb 10, 2012 | Shoprider Jimmie Power Wheelchair

2 Answers

I fitted new batterys, now the joystick is reading low battery but no responce from the joystick.the batterys are wired red to red and black to black does the chair turn this to 24v itself, theres no...


Will you don't say what chair you have and they can all be wired differently. Look under the shroud that covers your batteries and see if there isn't a wiring diagram there. If you let me know the brand ie: Pride Jazzy, Invacare M51 etc. I can give you the proper wiring for the batteries. Now you also didn't say if you charged the batteries after you installed them. Remember always charge before use. Just because they are new doesn't mean they are charged (in fact they could have sat on the shelf for a while). Make sure that they are no older than 4 months old even new batteries can be bad. Charge these puppies overnite. When you plug in the charger you should see a red and yellow light after charging overnite you should see a red and green light( indicating full charge) If when you plug the charger in you get a red and green light then something isn't wired correctly. Hope this helps

Oct 27, 2010 | Health & Beauty

1 Answer

No power to alternator green/red wire on dash light


alternator drived mechanically by a belt receiving energy from the crank shaft . and it chargs the battery , so your battery dead or the cables nedd to be replaced

May 31, 2009 | 2002 Ford Ranger Regular Cab

5 Answers

Battery charger flashing red light


Clean contact points of both battery and charger with q-tips dipped in rubbing alcohol. This solved my problem with blinking lights and not charging of the batteries.

Nov 03, 2008 | Olympus Stylus 710 Digital Camera

2 Answers

Digital camcorder problem


there a short line to the carbon wire of the function switch.....unfold the wire to loose the fold....and clean the contact of the wire using a pencil eraser slowly

Oct 14, 2006 | Sony Handycam DCR-HC40 Mini DV Digital...

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Triumph Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Are you a Triumph Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...