Question about 1994 Yamaha XV 535 Virago DX

1 Answer

Please could you help me? i have a virago 1100 that as been stood for a year , it ticks over at 1000 revs but when u rev it only goes to 3000 and backfires and the revs go up and down

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

Clean the carbs, bubba.

Posted on Aug 29, 2010

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2002 jaguar xj8 when I drive it won't go over 3000rpm

Jaguar wont rev 3000 rpm Questions & Answers - Fixya > Forum > Tags > wont rev 3000 rpm
1998 Jaguar XJ8 won't rev over 3000 rpm ... Wont go beyong 3000 Revs s type 2001, wont go beyond 3000 Revs and it' in limp ... Question about 2002 X-Type ... My jaguar xjr8 year 2000 battery went dead started car went for short drive back ...

Jaguar engine cuts 3000 rpm Questions & Answers - Fixya > Forum > Tags > engine cuts 3000 rpm
1998 Jaguar XJ8 won't rev over 3000 rpm ... engine cuts out and shudders at 3000 rpm won't accelerateobd code p0332 2002 jaguar x type 3.0 l P0332 - Knock ... Car is boging out in park and will not go over ... driving, don't worry about it.

Rev Won't go up

Dec 15, 2015 | Jaguar Cars & Trucks

2 Answers

Not Accelerating beyond 40-50 kmph

NOT clutch issue - if it was the clutch the rpms would rev out but bike would go no faster.
Sounds like carburetor may be partially plugged up, main jet.
Or air filter needs replacing.

Apr 03, 2014 | 2006 Bajaj Wind 125

1 Answer

I have put on new/rebuilt carbs 1100 virago. starts up nicely thenwarms up and idles 2000rpm. everything is new,intake boots etc.please anyone HELP

Check the choke settings . If the choke is set to stay on too long it will have high revs and check the linkage to the throttle to ensure that the adjustment is correct.

Apr 08, 2013 | Motorcycles

1 Answer

I just got a 1997 yamaha virago 1100. It will not idle unless I leave the choke on and the engine revs at 3000 rpm. Runs perfect after 3000 rpm. Any ideas? Original factory carb settings? Thanks

Hi, Ungerconstru and the usual suspects are:
1. Fuel cap or fuel tank is not venting properly.
2. Fuel filter clogged.
3. Fuel line pinched or kinked.
4. Vacuum line from the petcock to intake manifold cracked.
5. Float needle and seat sticking.
6. Float level too low.
7. Carburetor bowl vent line clogged/blocked/pinched.
8. Idle adjusting screw set too low.
9. Air/fuel mixture screw set too lean.
10. Idle port, transfer ports, slow air jet clogged.
11. Slow fuel jet clogged.
12. Faulty fuel pump.
For more information about your issue and valuable "Free" downloads that you will need please Click on the blue links below. Good luck and have a wonderful day.
Bike won Run without Choke
Won Idle Choke
OEM parts for Yamaha
Yamaha Virago XV1100K Owner Manual

Jul 29, 2011 | Yamaha Motorcycles

3 Answers

Yamaha fzr 1000 exup, flat spot and then holdin back till 4000rpm. Any solutions...?

Hi,,,sounds like you have a blockage in the carbs,,,remove and clean carbs,,check spark plugs too.

Mar 22, 2011 | 1991 Yamaha FZR 1000

2 Answers

How do iget the fuel gauge on my 2002 aprilia 125 to show up,

there aint one m8 i have the same bike same year and no petrol gauge only earlier rs had them they swapped it for a sidestand switch

Jul 13, 2010 | 2002 Aprilia RS 125

1 Answer

Bmw 318ti. When stood still the car with rev on its own

try disconnecting the battary for about 1 hour this will clear the computor settings then reconect and drive for a while it may fix it as it happened to me.

Mar 09, 2009 | Daewoo Nubira Cars & Trucks

1 Answer

Tick over problem

Sounds like it could be a bad EGR valve, the trans fault codes of p1775 is nothing really, it could even be the fact that you are putting the car in gear at 3,000 revs.
If this is an intermittant problem then it goes right back to the egr valve. They clog and stick and will cause bad/rough idle issues especially on start up and also will cause spiratic idle problems.

Jan 28, 2009 | 1995 Jaguar XJ6

1 Answer

Intermittent high revving!

Throttle position sensor.

Jun 25, 2008 | 1998 Ford Escort

Not finding what you are looking for?
1994 Yamaha XV 535 Virago DX Logo

Related Topics:

310 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts


Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers


Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides