Bike was running perfect then it bogged down. now it wont start and is making a really loud squeeking noise when i try to kick start it. iam begining to think it could be the piston and/or rings but not sure..

Will the bike start when you bump start it? If it does, then you will need to replace the kickstart drive gear.

You will need to check the tub roller wheels. This is a common noise when the wheel bearings start to ware down. They are not expensive, and you should be able to do this yourself. Good Luck Friend.

remove the AC relay to shut the AC off all the time. Not sure why it wont start but you may havea security lockout. Fully charge the battery to proceed.

Sounds like your starting components are bad on the compressor. If the freezer section begins to loose temp then this is probably the case. They will try to start the compressor and then it will kick off on its overload. However this will usually occur every 10-15 mins when they are completely toasted. Your compressor may be starting up part of the time and not starting the rest. Either way you will probably need new starting components on the compressor. You could also check to make sure your condenser fan motor is running (in the back of the ref behind the access panel) because this could cause the compressor to overheat but usually wont cause a buzzing noise.

Hope this helps _MJ_

I used to own an old 250 Ducati and I had a similar problem but all it turned out to be was not shutting off the gas **** whenever i shut off the engine even for a 10 min stop.After I resolved that problem the little F....r ran great.I do not know if this is of help or not but that was my resolution.It also did not cost me an arm and a leg...Just an arm to find out

WE 3X 75 is the part number you need. Take a look at these repair pix

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Sorry to tell you.The motor seized and needs a rebuild.Not to many other options.You gave a very good description of what happened.Hope this helps

your problem sounds common. i would also try a rejet!

This really sounds like a need to replace the intake gaskets. When the bike warms up the gaskets loose their seal leading to a lean condition that makes it almost impossible to start, until bike cools down. Gaskets are cheap, this would be my first place to begin. Hope this helps.

JP

yea it sounds like the compression is down could be the rings or barrel wear or leaking head worst is lower end bearing this is most probable due to the banging noise think engine needs overhaul by a good mechanic