Question about 2000 Sym Husky 125

1 Answer

Poor starter, plug gets wet, starts when bumstarted

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,567 Answers

First, get a fresh sparkplug. Next, charge the battery. Batteries usually only last two years or less. A battery that will not hold a charge will rob electricity needed for spark. On a bump start, the flywheel generates more electricity than a kick start. Give the throttle only one twist on your morning start if your bike has a power valve. The valve gives a shot of gas when the throttle is turned. Twist too much and the engine will flood. Please rate my answer. Thanks.

Posted on Aug 23, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Will not start after changing air filter and sharpening blades


Pull plug see if it is wet. Wet means gas getting to cylinder. Replace plug if worn. Check oil level and condition. Fill or change the oil. Ensure "deadman's cable is working. Spray starter fluid into carb at air cleaner to start. Ensure air cleaner is installed correctly.

Apr 02, 2016 | Toro Garden

1 Answer

I have a 2000 a190 4 door mercedes benz-replaced 4 spark plugs-bushes-washed it yesterday and now wont start


Battery is defective if clicking is solenoid for starter trying to engage the starter. Did you get water under the hood, could also be wet ignition coil or distributor. Did you disconnect anything while getting at spark plugs like a wire to ignition?

Feb 15, 2016 | Cars & Trucks

1 Answer

Replaced motor, starting hard. runs fine . how do I check fuel pressure


Doubtful you have a fuel pressure problem if the car runs well, poor starting can be a few things , poor air circulation air filter needs cleaning or replacing, poor injector flow warn injectors or just dirty fuel additive sometimes clears this , poor spark plugs not firing under pressure ok when started . for diesel cars you don't say what car it is , poor glow plugs . bad fuel filter , air leaks in fuel pump , poor injectors . and especially with diesel poor compression due to worn rings or head gasket failure . You may even have just have disturbed the engine earth strap when you replaced your starter motor .

Jul 03, 2015 | Cars & Trucks

1 Answer

98 dodge intrepid/ 2.7 liter, cranks but will not start. Even with using starting fluid. Plugs are wet


take out the plugs take them inside let them dry out for 6 to 15 hours
before replaceing them crank the starter once or twice to dry out the cylinders put the plugs back in start it and away you go

Dec 25, 2011 | Cars & Trucks

1 Answer

I have a 1980 Shadow 2 which I have not run this year although turned it over regularly,I now want to start it but not getting any fuel thro I am told that there is a sensor that stops fuel flow to carbs...


It is more likely to have poor fuel in the carberettors. I would start by removing the spark plugs and give them a sniff. See if the fuel is potent. Note if the spark plugs are wet. If they are, replace the spark plugs with Champion plugs and see if it will fire. Let me know if you need anything else.

Dec 23, 2010 | Rolls Royce Camargue Cars & Trucks

1 Answer

Engine light on, sounds and feels like using lumpy petrol.


i have found 2 areas that cause issues such as you are reporting.
one is poor voltage. check the connection at the starter motor between the alternator and the battery.
the other and perhaps more likely is a wet ECU.

the ecu box is under the windshield on the passenger side, access under the hood. this are can get wet ad corrode an ECU.

remove the ecu, take the bottom plate off and clean any corri=oded and wet areas with alcohol and a tooth brush..be gentle.
i would look for a way of mounting the ecu so that it doesn't lay on a flat surface that gets wet...

Jan 28, 2010 | 1999 BMW 323 Series

2 Answers

My toyota land cruser is poor to start first thing espesialy when its cold , I have replaced the glow plugs and fuel fillter


didyou replace the manifold heater?
have you checked the relay?have you checked to see if there is actualy power getting to the glow plugs? and also the fuse .
It is very srtange ,if the glow plugs are working ,for it not to fire up straightaway .Does it miss when it does first start?If so, the glow plugs are not all working.Last thing try giving it a squirt of aero start, or starter fluid , if with that ,if it doesn`t start straight away, then you better come back to me as i have another idea what could be a problem but I dont think the glow plugs are working properly so try the aero start first "youdoit"

Sep 13, 2009 | 2000 Toyota Land Cruiser

2 Answers

95 Jeep Grand Cherokee will not start when wet


check cap rotor wires and coil. likely one or more of these items is arcing and causing poor spark distribution.

Mar 10, 2009 | 1995 Jeep Grand Cherokee

1 Answer

Car will turn over just not catch and start


turn the engine over for at least a minuit in 2 or 3 intervals. (NEVER HOLD THE STARTER MORE THAN 25seconds at ONE TIME) pull out a spark plug or two and see if their wet and smell like gass, then you know if its getting fuel. You will need a long 3/8'' extension cuz its overhead cam but the front plugs are easy to get to. If the plugs are dry then pull all the plugs and poor no more than a 1/4 ounce of clean gass in each cylinder of your inline 4, reinstall each plug as you have added fuel connect the plug leads again and start it. if it starts momentarily you've varified the proplem. If the plugs were wet apone the first test verify you have spark, pull one plug & reconnect it to the plug lead touch the bottom of the plug to the engine block (away from its hole) and get some one to crank the engine darker the environment the better and look for a brightblue spark it should be their on all leads. Hope you find somthing

Dec 27, 2008 | 1995 Suzuki Sidekick

1 Answer

89 f-150 turns over just wont start


If the only evidence of trying to start was when u used starter fluid, it's probably a fuel issue. After attempting to start several times, pull a plug and check for gas/wet plug. If there is no evidence of gas reaching the plug, it's probably the fuel pump. Change the fuel filter too.

Dec 18, 2008 | 1989 Ford F 150

Not finding what you are looking for?
2000 Sym Husky 125 Logo

Related Topics:

125 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sym Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Dave Matthews
Dave Matthews

Level 2 Expert

97 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Are you a Sym Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...