Question about 1985 Honda GL 1200 Interstate Gold Wing

1 Answer

Water pump leaks from bottom of housing - 1985 Honda GL 1200 Interstate Gold Wing

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,978 Answers

You need to replace your water pump assembly. New water pumps are available at your local Honda dealer ( about $135). Get the after market gasket set , it comes with all the gaskets and seals necessary to remove the lower front cover and replace the water pump (K&L makes the kit ($25)). You do have to take off the lower front cover to replace the pump.

Posted on Aug 21, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I just installed a us pool pump motor eb841 1hp 3450rpm 208volt 56y and it is leaking water behind the square bell housing actually leaking bottom side of motor


There is a leaky water seal on the pump shaft housing between the pump and the motor.
The drain hole prevents water from going into the motor and this seal needs to be replaced before the motor is damaged.

Aug 19, 2012 | A O Smith Motors A O Smith 1hp 115/230v Ur...

1 Answer

Radiator fluid leaking - top driver side under the thermostate housing or water pump housing?


1st check to see if the hose to the thermostat housing is tight, if so, then check the thermostat housing to see if anti freeze is leaking from that area, if so replace the gasket, or try tightning down the bolts, but don't over do it with the tightening, if that area is ok, then check to see if antifreeze is leaking from water pump, start vehicle and let run, and observe the pump for any leakage, do not get close to the fan area, most of the time when water pumps go bad , they have a small hole in the bottom of the pump, this is called a weep hole, this is a true sign that the bearing and seal in the pump is wearing out, hope that this information has helped.

Feb 13, 2011 | 1996 Ford Explorer

1 Answer

I have water leaking from the middle bottom of washer, not leaking from hoses or water outlet


sounds like the water pump, pull the housing and look at the bottom center for a oval shape with two hoses.I bet you find the leak there.......GOOD LUCK

Nov 15, 2010 | Maytag SAV5710 Top Load Washer

1 Answer

Water leak. I dont think its the water pump but the leak is really close to the water pump


could be a hose but most likely its leaking water out of the weep hole in the bottom of the pump housing

Mar 11, 2010 | 2005 Dodge Caravan

1 Answer

Water leaking from bottom


Replace water pump. Common problem. Unscrew the control panel ,two screws on each end. Flip control panel over and unsnap gold brackets from base to the back. Lift up housing and disconnect lid switch, remove housing. The water pump is in the front lower that has two hoses , disconnect hoses and unsnap pump. My sister fixed hers in about 25 minutes.

Apr 06, 2009 | Whirlpool 3.2 cu. ft. Plus Washer

2 Answers

2002 chryler sebring is leaking anti freeze


It depends on where the leak is coming from. If the water pump is leaking, it has a hole on the bottom of it. You will see a trail of dried anti freeze coming from the bottom of it, indicating a bad water pump. It's best to dry everything off, crank it up and let it come to operating temp and check for where the leak is coming from. It may just be an old hose or loose clamp.

Nov 20, 2008 | 2002 Chrysler Sebring

1 Answer

I have a coolant leak coming from the front of the engine. looks like it is leaking around the cam shaft pulley. The vehicle is a 2001 Nissan Frontier v6


Sounds like either the water pump or the thermostat housing. The water pump has a small hole in the bottom where the shaft comes through, when the water pump gets worn it will leak here so you know to replace the pump. The thermostat housing will be at the motor end of the upper radiator hose where it attaches to the motor. Hope this helps.

Aug 11, 2008 | Nissan Frontier Cars & Trucks

Not finding what you are looking for?
1985 Honda GL 1200 Interstate Gold Wing Logo

Related Topics:

180 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75051 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...