Question about 2004 Bajaj Caliber 115

1 Answer

Engine rises but vehicle not run as per throutle

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Bajaj Master
  • 767 Answers

Do you get the gears when selecting them?
Seems the clutch is slipping , probabely worn out clutch plates!

Posted on Aug 20, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

99 ford taurus starts up but doesnt drive more than 10 miles per hour and temperature starts to rise


maybe a coolant thermostat that is faulty, a collapsed or perished hose..

It could also indicate cylinder head gasket/cylinder head problems.

Ten miles is about the correct distance for a car engine to reach normal operating temperature. If your temperature gauge continues to rise beyond normal ..ie. overheating .. you risk causing a lot of damage to your engine.

If you're not sure what to do or look for - get somebody to check it out for you

Jan 27, 2016 | 1999 Ford Taurus

1 Answer

The speedometer on my 1998 toyota D4 corona premio, 3s engine, suddenly drops when i step on the accelerator with the intention of increasing my speed. when i try to speed up the vehicle almost stops but...


GAS
3s-fse-d4-engine???? 3s-GE OR GE WITH RED BEAM? "VVT"
M./T OR A/T (STICK OR AUTO)
the key factor is engine RPM
if it rises, but not speed, that is trans./clutch slip
if no rpm rise that is weak engine , BUT IS THE RED BEAM.?

LOW POWER, 101
1: NEVER TUNED UP. BAD SPARK CLOGGED FILTES X2
2: ENGINE ecu stuck in limphome, scan it, see errors, BINGO
3: engine misfiring, cause by low compression, weak spark or bad fueling (too rich or too lean) many tests, ask.
4: low fuel pressure or regulator not regulation per FsM PAGE
5:STUCK OPEN egr main valve (missing in some countries)
6: melted cat converter , vacuum gage reads real bad,
7: and more, i charge more for more, LOL vvt?

ask or tell?
i want wild guessing
or I want to do the tests. to find it.

Gue$$ or Test.
toss coin.?


Jan 08, 2015 | Toyota Cars & Trucks

1 Answer

Cold start running rich


Hi Malcolm, The cold start operation on all vehicles increases and enriches the fuel to air ratio, making it easier for the engine to start. Most systems also incorporate an 'up idle' which runs the engine at a faster speed until the temperature begins to rise. Regards John

Nov 24, 2012 | 1991 Honda Civic

2 Answers

2007 CHEVY COBALT CHECK ENGINE LIGHT IS ON AND THE FAN IS CONSTANTLY RUNNING


this is normal for most vehicles, it is because the water temp in radiator continues to rise after you shut the engine off. would not worry about it unless it dose not shut off at all. or never runs

Jun 11, 2012 | 2007 Chevrolet Cobalt Coupe

1 Answer

Have misfire, code P0316, any ideals? 86,000 miles on


2004 Marauder and 2003-2004 Mustang vehicles built before 12/19/2004 equipped with 4.6L 4V/5.4 4V engine may exhibit a runs rough, lacks power, and engine misfire, prompted by a MIL light and DTC codes P0301, P0302, P0303, P0304, P0305, P0306, P0307, P0308, and P0316.
ACTION
Diagnose engine for engine misfire concern. If diagnostics determine an engine misfire which is characterized by leakage through exhaust valve(s), only replace the affected cylinder head(s).
SERVICE PROCEDURE FOR VEHICLES WITH RUNS ROUGH/MISFIRE CONDITION:
1. Perform relative compression check on all cylinders. If abnormal, check cylinder leakage and actual compression for "low" cylinders refer to Workshop Manual (WSM), Section 303-00.
2. If leakage/compression check indicates a valve train concern, per valve train diagnostics in WSM, Section 303-00, replace cylinder head and cam assembly, pipe plugs and timing chain tensioner, per procedure outlined in WSM, Section 303-01.
3. If cylinder leakage and compression tests are inconclusive, perform misfire diagnostic, per TSB 05-22-8.

So

Feb 26, 2011 | 2004 Ford Freestar

1 Answer

Our dishwasher has started leaving cloudy film on silverwar, glassware etc. Used Finish in washer per instructiuons. Have cleaned with white vingar per owners manual. Spray arms, filters all clean. ...


Run 2x bottles of Dishwasher Magic 1x per each wash. You can pick this up at your supermarket. Run on normal cycle without any dishes. Kills 99.9 bacteria and cleans out dishwasher.
Also make sure your not using rise aid and detergent with rise aid in it. To much rise aid will cloud the dishes as well.
Have a great day!

Dec 08, 2010 | KitchenAid Dishwashers

1 Answer

I have a liquid cooled 4 stroke scooter. It runs


Check the cooling liquid qty. I feel engine piston is seizing. Replace the engine coolant as per the manufacture's recommendation.

Mar 29, 2010 | Yamaha YZ 250 F Motorcycles

3 Answers

My 1999 dodge durango is having hard time starting and then won't stay running.


I had a simmilar problem with a RAM the throttle body was dirty.You may try cleaning the intake with a good carb spray.This may not have happened to you but my battery had gone dead and when I replaced it my vehicle would not run well (dying out).I clened the intake and it runs fine.A mechanic told me that when a vehicle loses power (battery)the computer resets and if the intake is dirty the fuelwill not flow well therefore causing the computer to send more or less fuel to the throttle body.Although after cleaning it my o2 sensor needed to be cleaned and reset the check engine light

Mar 09, 2009 | 1999 Dodge Durango

2 Answers

Pajero diesel 2800 radiator coolant overflows, engine temp. up


REMOVE RAD CAP AND RUN ENGINE AT 3000RPM WITH ALL HEATERS ON SOUNDS LIKE AIR LOCK, ALSO CHECK IF HOSES ARE HOT

Jan 21, 2009 | Mitsubishi Passenger Cars & Trucks

1 Answer

MILEAGE PROBLEM


possible valves were adjusted to tight. should not have had to adjust idle if it was too low there was a reason for this.possibl;e vacuum leak or something was unhooked or broke while servicing

Sep 10, 2008 | 2006 Hyundai Santa Fe

Not finding what you are looking for?
2004 Bajaj Caliber 115 Logo

Related Topics:

106 people viewed this question

Ask a Question

Usually answered in minutes!

Top Bajaj Experts

sachin sharma
sachin sharma

Level 2 Expert

171 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

chandrakantm

Level 1 Expert

8 Answers

Are you a Bajaj Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...