Question about Suzuki GS 650 GT Motorcycles

Open Question

1982 Suzuki GS650G timing chain adjustment how do you adjust the chain

Posted by on

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 58 Answers

SOURCE: 1982 Suzuki GS650G timing chain install

Don't ever break & relink a timing chain on a vehicle like yours.

You don't have to remove the crank just to replace the timing chain. says

like jeshern85 says, just remove whatever parts are blocking access. I usually wrap the chain around the crank sprocket then pull the chain up through the cylinder with a coat hanger.

Posted on Sep 03, 2009

  • 132 Answers

SOURCE: 1982 Suzuki GS650G timing chain install

DONT SPLIT THE TIMMING CHAIN TAKE THE CRANK OUT AND FIT IT THAT WAY. IF YOU SPLIT THE CHAIN IT WILL MORE THAN LIKELY SNAP AT THE POINT WHERE IT WAS REJOINED

Posted on Dec 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I bought a 1983 GS550E and the cam chain rattles a bit.Is there any adjustement possibility or do I have to change the chain?


Something you can try....

http://www.bikebandit.com/1983-suzuki-gs550e-cam-chain/o/m14397sch238839

In the above illustration, item #10 is listed as "Chain Tension Adjuster".

You can try adjusting this to see if it helps.

Mar 06, 2014 | Suzuki Motorcycles

1 Answer

1982 Suzuki gs650g won't stay on is it the


if ignition it will kill all electrics .. if kill switch then just the engine will die. it could be other things too. more information

Mar 15, 2013 | Motorcycles

2 Answers

Need a labeled carburetor diagram so I can synchronize, clean, and adjust the carbs. Also need to steps to change the diaphram adn check the timing chain.My engine seems to be running rich, how do I fix...


The site below has got all but the tappet clearances covered. You will need a service manual for the correct valve clearances or a friendly word to your dealer if you want to do it yourself.

Front and rear carbies' are depicted in exploded view form with all parts named and numbered. The diaphrams and idle adjustments are clearly shown. All sections of the bike are covered.

As for the timing chains, they are self adjusting and when adjustment runs out, the chains must be replaced.

Richness is governed by the size of the carby jets, smaller numbers are leaner.

Cheers!

http://www.cmsnl.com/suzuki-vs800-gl-intruder-1992-1997-usa_model16322/partslist/

Sep 28, 2010 | Suzuki VS 800 Intruder Motorcycles

2 Answers

82 Suzuki GS650 Engine turns over but gets no fire to start.


take the plugs out and see if you have a spark get back to me

Sep 22, 2009 | 1982 Suzuki GS 650 GT

3 Answers

1982 Suzuki GS650G timing chain install


it is possible to unlink the timing chain. I dont really recommend it, but I have done it before with no problems. if you can get ahold of a small chain breaker you can use that to press one of the pins out of the chain. you may be able to find one at a hardware store. then, use the same breaker to press the pin back into the chain. you MUST be sure that it fits tightly though, so the pin doesnt try to back out later down the road. this is what I did...for a loose fitting pin, I used a hammer with a punch to "mushroom" the ends of the pin so it cant back out. I had a friend hold the metal end of a small sedge hammer against the chain, while I used the punch and hammer on the other end, then we switched sides. Im not too familiar with your engine, but in general, you dont have to remove the crank to replace the timing chain. usually, just removing the clutch basket gives you enough access to replace it. on certain models though, the cases may be in the way, and removing the crank may be necessary. but before you break the chain or pull the crank, check to see if its possible to install a chain by just removing the clutch basket, and if necessary, the gears on the end of the crank.

Sep 03, 2009 | 1982 Suzuki GS 650 GT

1 Answer

How do i adjust the drive chain on my suzuki bandit 600


set the bike on the centre stand,loosen the rear axle nut,on either side of the swingarm at the rear there will be a small adjuster nut(normally with a lock nut on it)undo the locknut,then turn each ajuster 1/4 turn at a time untill the chain has about 1 1/2 inches freeplay up and down,make sure when you do this that the axle alignment marks are exactly the same on both sides of the swingarm,once you have the chain adjusted to the right tension,tighten the rear axle bolt and replace the splitpin(if fitted),then tighten the locknuts on the chain adjusters,thats it,hope this helps

Jul 09, 2009 | 1997 Suzuki GSF 600 S Bandit

1 Answer

1993 suzuki dr 650


it has an automatic tension adjustment

Apr 16, 2009 | 1993 Suzuki DR 650 RS-E

1 Answer

SUZUKI INTRUDER 125, WHICH CHAIN SHOULD I BUY


the chain type is 428. take chain off and count # of links.give those 2 #s to parts guy. when you replace a worn chain,the front and rear sprockets should be replaced at the same time, because worn sprockets and a new chain will cause accelerated chain wear. count # of teeth on sprockets & give those 2#s to the parts guy also. if you want a longer wearing chain, buy one w/ the highest tensile strength,once again, parts guy can help you find that.dont forget,lube & adjust chain as needed.

Feb 17, 2009 | 2003 Suzuki VL 125 Intruder LC

1 Answer

Chain check and maintenance


Depending on how aggressively you ride, chains should be inspected every 500-700 miles, or roughly twice a month

Nov 10, 2008 | 1982 Suzuki GSX 400 FS impulse

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

161 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Ed Nelson
Ed Nelson

Level 2 Expert

149 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...