Question about 1994 Honda CBR 600 F(2)R

1 Answer

1994 honda cbr 600 motorcycle wont start just turns over put new petrol and replaced plugs but still wont start please help

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 921 Answers

Check pulse generator circuit for any opens or shorts..even if you still show a weak purplish/red spark its bad..it must be a big bluish/white spark..check plug #1 for spark and then check #3 foe spark if there both week then its your pulse generators that are bad ..but if one of them has a blushish spark then it that systems coil..eg #1and#4 or the #2and #3 coils..

Posted on Aug 19, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a honda cbr 600 f2 1994 I cleaned my carburetor and replaced everything but I still can not get it to turn over it trys but won't start


Hi, Tieshorn and the usual suspects are:
1. Fuel tank empty.
2. The fuel tank has old dead gas.
3. Fuel tank bottom contaminated with ethanol sludge, dirt, water, rust, etc.
4. Fuel supply valve/petcock turned off.
5. Fouled spark plugs.
6. Engine flooded as a result of overuse of the enrichner.
7. Vacuum hose to the fuel supply valve/petcock disconnected, broken, cracked, or pinched.
8. Fuel valve/petcock or filter clogged.
9. Fuel line to carburetor or throttle body pinched, kinked or blocked.
10. Carburetor float stuck.
11. Fuel injectors clogged.
12. A severely discharged or damaged battery, you need 12.5 volts or better and be able to pass a load test if necessary.
13. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
14. Loose or corroded wire connection at the coil or plug between ignition sensor and ECM module.
15. Spark plug cables in bad condition and shorting check for spark leakage in the dark, cable connections loose, or connected to the wrong cylinders.
16. Ignition timing incorrect due to a faulty ignition coil, ignition module or MAP, CMP, CKP, O2, TPS, ETP, IAC sensors.
17. Faulty neutral, clutch lever, or kickstand safety switch.
18. Faulty fuel pump or fuse or relay.
19. A stuck bent or burnt valve.
20. Tilt sensor needs a reset.
21. Security system not disarming alarm needs a reset.
22. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
http://www.fireblades.org/forums/honda-cbr-600/73539-cbr-f2-wont-start-please-help.html
1994 CBR600F2 wont start
1991 1994 Honda CBR600F2 Service Manual Moto Data Project
http://www.partsfish.com/page/oem-parts-for-honda
Honda CB Owners Manuals

Mar 24, 2017 | Honda CBR 600 F(4)i Motorcycles

1 Answer

93 Honda CBR 600 F2 Won't start just backfires


carb needs cleanin or rebuild--getta clymermanual for procedure

Dec 11, 2012 | Motorcycles

1 Answer

1994 Honda CBR 600 F(2)R will not start when engine is hot


Hi, Anonymous your bike starts great when cold but once it reaches operating temperature and the engine is shut off for a few minutes then you try to restart it and it will turn over but will not fire or it doesn't do anything, the usual suspects are:
1. When electronics get hot they build up resistance then stop working. It might be an ignition coil, stator, CDI unit etc. First, you must find out if the spark dies out. When the bike won't start, pull a plug wire off, stick a new spark plug in the end and ground the threads on bare metal while someone cranks the engine over. You should see a nice big blue spark between the spark plug gap. Incorrect spark plug gap will cause or contribute to a no start when hot issue.
2. Fuel Tuners have been known to cause this type of problem, disconnect it and see if resolves the issue.
3. Any engine management sensor could be faulty especially the ones that monitor temperature.
4. Gas cap not venting properly, improperly routed fuel lines they must always go down from the gas tank to the carburetor never in any kind of a loop this will cause a vapor lock. Clogged, bent, kinked, pinched or restricted carburetor vent lines will do the same.
5. Overhead camshaft valves adjusted too tight when cold, this will cause loss of compression when hot, except for pushrod engines they usually get looser when hot.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
http://www.fireblades.org/forums/honda-cbr-600/49891-problems-starting-only-when-hot.html
HONDA CBR WONT START TRY THESE TIPS
Honda CBR600F4I 2001 Service Manual
http://www.partsfish.com/page/oem-parts-for-honda
Honda CBR600F Owner Manual

Jun 25, 2017 | 1994 Honda CBR 600 F(2)R

2 Answers

I need wiring schematic


I bought a cbr 600 , but bike came with the wirers not connected. Rectafire, was also not connected? need diagram or help really badly!!!!

Jun 26, 2009 | 1994 Honda CBR 600 F(2)R

1 Answer

Bike wont start bought new battery charged it and still wont start i havent changed spark plugs


It won't start? or it won't turn over? If it won't turn over have your starter checked out and proceed from there. If it tries to turn over but won't start, change the sparkplugs and see if you get a spark. If you do not get a spark you should take it to a repair center. If you do get a spark with the new spark plugs, install them and see if it runs. If not see if it's getting fuel, If it still wont run whether it is getting fuel or not I reccomend taking it to a bike mechanic.

Jun 15, 2009 | 1994 Honda CBR 600 F(2)R

1 Answer

HONDA CBR 600 ( 2003)


Without the fairings the plugs should be pretty accessible. Get a new set of stock plugs from the dealer. Since you are already there anyway, have them show you how to install the new plugs.. Talk to them about the starting problem and get their thoughts.

Mar 30, 2009 | 2003 Honda CBR 600 F(4)i

1 Answer

Wont start


the old petrol has buggered up the jets a good carb cleaning will fix the carbs now drain the old petrol out and get new dont try to mix old and new gas it does no good please give us a rate hope this helps

Jan 03, 2009 | 1988 Honda CBR 400

2 Answers

Bike wont turn over


I have a 1996 cbr 600 f3 and when I first bought it used it would not turn over for the life of it. It turned out that a major problem was the spark plugs needing to be replaced. Thats the first thing to do. Next clean out those carbs with some good carb cleaner.

Nov 10, 2008 | 2005 Honda CBR 600 F

Not finding what you are looking for?
1994 Honda CBR 600 F(2)R Logo

570 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75197 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...