Question about 2001 Husqvarna WRE 125

Open Question

Very poor top speed - 2001 Husqvarna WRE 125

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

Tip

Loss in engine power, sluggish responses, low top speed, etc.


If your car has
  1. Poor fuel responses
  2. Lost its "power"
  3. Low RPM
  4. Lower top speed
  5. Burns a lot of fuel
Then it could be because of carbon build-ups in your engine's combustion chamber. This is left behind with unburned fuel. It causes poor acceleration, a loss in power, lower top speed, and burns more fuel than it really has too. Not to mention causes smoke belching.

The best way to get rid of that would be to have a carbon ridding solution injected into the combustion chamber. The solution will liquify the carbon and other build-ups, which would then restore the "power" of your car. You'll get better acceleration, higher rpm and top speed, save fuel, etc. have a mechanic do it for you. It's alot cheaper and faster than having the engine overhauled (overhaul could trigger "loose compression").

on Aug 08, 2008 | 1995 Toyota Camry

Tip

Restoring Car's Power And Saving Fuel At The Same Time


If your car has
  1. Poor fuel responses
  2. Lost its "power"
  3. Low RPM
  4. Lower top speed
  5. Burns a lot of fuel
Then it could be because of carbon build-ups in your engine's combustion chamber. This is left behind with unburned fuel. It causes poor acceleration, a loss in power, lower top speed, and burns more fuel than it really has too. Not to mention causes smoke belching.

The best way to get rid of that would be to have a carbon ridding solution injected into the combustion chamber. The solution will liquify the carbon and other build-ups, which would then restore the "power" of your car. You'll get better acceleration, higher rpm and top speed, save fuel, etc. have a mechanic do it for you. It's alot cheaper and faster than having the engine overhauled (overhaul could trigger "loose compression").

on Aug 08, 2008 | 2001 Honda Civic

2 Answers

Wind noise 2011 volvo s60


possibly a partially open window or partially open sunshine roof.

Mar 12, 2015 | 2011 Volvo S60

1 Answer

Difference between ford 9 inch and 8.8 inch rear end


The size of the crown wheel gear. Ford 9 inch is a strong diff used in V8 models. The 8.8 is slightly smaller but is still a good diff. The gear ratios will probably be different. Manual gearbox cars have different ratios to automatics. The higher the ratio, the faster takeoff you will have but lower terminal speed. At high speeds , the high ratio differential will cause high engine revs and poor fuel consumption. A low ratio will be mediocre takeoff but allows high top speeds and lower engine revs. (Good for fuel economy if you are mostly highway driving)

Sep 25, 2014 | Cars & Trucks

1 Answer

Motor has poor starting torque and trips out shortly after starting.


In the absence of other symptoms, the brakes may be binding. Try a dab of silicon grease (or automotive brake-caliper grease) on the brake disc.

Sep 09, 2013 | Speed Queen AWS52NW Top Load Washer

1 Answer

No speedo i have a honda civic 1.4 2000


it's missing - or it stopped working?
Check the speed sensor (tach) or VSS wiring and sensor itself for failure.
If you have an aftermarket alarm or remote starter - the installation may be poorly done - and the speed sensor wire cut or disconnected with vibration.

The Tach wire is blue - and found at the coil.
The VSS (vehicle Speed Sensor wire) is blue/white found on the Passenger's Firewall - 3 Pin Connector (top Transaxle for the sensor itself)

Thanks for using FixYa - a Very Helpful Rating is appreciated for answering your FREE question.

Jul 31, 2009 | 2004 Kia Sorento

1 Answer

Zephyr Savona Range Hood only speed 3 works


had same problem (w/in a few months)
switch assembly poor design
thay sent a replacement (i put it in)
seen other complants

Jul 15, 2008 | Kitchen Ranges

1 Answer

Kenmore 23832 top load washer


lalocke If the load is not properly balnced, your washer will shake too much on the spin cycle and it wlll never go on full speed. Gendos...post back

Mar 01, 2007 | Kenmore 23822 Top Load Washer

Not finding what you are looking for?
2001 Husqvarna WRE 125 Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Husqvarna Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

choprboz5

Level 2 Expert

196 Answers

Joseph Hoffmann

Level 3 Expert

1702 Answers

Are you a Husqvarna Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...