Question about 2005 KTM EXC 450 Racing

1 Answer

What Spark Plug Tool Will Remove My Plug From My KTM 250 SXF 2008? Spark Plug Wrench 16mm 1/2 Inch 60029073000 Spark Plug Key 77029072000 Didnt Get One With My Bike And Want To Order The Right One. Thankyou.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Motion Pro offers a tool that is half the price of the one KTM offers, that will do the job. I got mine at Bikebandit.com after searching all over for months trying to find a cheap alternative to removing the spark plug from my 2007 KTM 250 SXF.

Posted on May 13, 2013

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 14 Answers

SOURCE: ktm 250 sxf 2008 backfires

go on google check the air mixture and altar the air screw on the carb to wot u find on the net easy job thers only 2 screws on the carb

Posted on May 20, 2009

voodoomox
  • 1689 Answers

SOURCE: 2008 ktm sxf 250 when engine is under load there

you may want to relube your water pump. this usually happens if the water pump cannot put out what it gets from the inlet valve. what will happen is that coolant will get stuck on the negative reservoir, then will get out of the over flow tube. you may think that you have too much coolant, but yet you only are running half.

avoid further damage and overheating have it replaced.

Posted on Jun 17, 2010

TerryTown
  • 292 Answers

SOURCE: i need engine torque settings on my 2008 ktm sxf

Thank you for contacting FixYa with your inquiry. I have been going
over some of the older help requests that have been archieved and
trying to provide solutions for those that didn't get answered. Hope
this information helps.

Try these:

KTM Torque settings


  1. Collar screw, front wheel spindle Front axle nut 40Nm 30ft lbs
  2. Brake Caliper front Brake Caliper front Loctite 243 2 19ft lbs
  3. Brake Disk, front Brake disk front Loctite 243 1 11ft lbs
  4. Brake Disk, rear Brake disk rear Loctite 243 1 11ft lbs
  5. Clamping screws, upper fork bridge Top triple clamp 20Nm 15ft lbs
  6. Clamping screws, lower fork bridge Bottom triple clamp 15Nm 11ft lbs
  7. Clamping screws, fork stubs Front axle pinch bolts 10Nm 7ft lbs
  8. Collar nut, rear wheel spindle Rear axle nut 80Nm 59ft lbs
  9. Hex nut swingarm bolt Swingarm nut 100Nm 74ft lbs
  10. Hex collar screw handlebar clamp Upper handlebar clamps 20Nm 15ft lbs
  11. Allen head screw handlebar support Lower handlebar clamps Loctite 243 4 30ft lbs
  12. Shock absorber top Shock absorber top bolt 60Nm 44ft lbs
  13. Shock absorber bottom Shock absorber bottom bolt 60Nm 44ft lbs
  14. Sprocket screws Rear sprocket bolts Loctite 243 3 25ft lbs
  15. Ball joint for push rod Rear brake pedal pivot Loctite 243 1 7ft lbs
  16. Engine mounting bolts Engine mounting bolts 45Nm 33ft lbs
  17. Engine brace Engine brace 33Nm 24ft lbs
  18. Screw adjusting ring spring preload Shock preload collar bolt 8Nm 6ft lbs
  19. Spoke nipple Spokes 5Nm 4ft lbs
  20. Other Screws on chassis M6 10Nm 7ft lbs
  21. M8 25Nm 19ft lbs
  22. M10 45Nm 33ft lbs
  23. Other collar nuts on chassis M6 15Nm 11ft lbs
  24. M8 30Nm 22ft lbs
  25. M10 50Nm 37ft lbs
  26. Front Sprocket 44ft lbs
TF

Posted on Oct 29, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I put a 2011 ktm 250sx rear fender on?


Hi, Dylan for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your KTM, despair not, for a mere zero $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Back fender instal procedure KTM 530 exc
New Acerbis Plastics Install on KTM 300 XC Time Lapse Video
KTM 250 sxf 2016 Repair Manual
http://www.partsfish.com/page/oem-parts-for-ktm
KTM 250 SX 2010 Owner Manual

Mar 28, 2017 | 2011 KTM 250 SXF

1 Answer

2011 KTM 250 SXF will not idle


Hi, Anonymous if your bike has been sitting idle for months or years and you did not do any pre-storage maintenance I feel your pain it will probably have a dead battery and not want to start or if it starts it will idle and run poorly, here are the following steps necessary to complete in order to get your bike back to an acceptable running condition.
1. If your battery was 2-3 years old when you last had the bike running you should replace it.
2. If you believe your battery might still be serviceable remove it from the bike and put it on a 1 or 2 amp trickle charger for 24 hours. If it is the old lead acid type with visible cells and acid levels fill each cell to the top line with distilled water and replace the caps, run the vent tube into a plastic or styrofoam cup, any cells that are cloudy/milky replace the battery.
3. After charging remove the leads and let the battery sit for a couple of hours then check the battery voltage with a volt meter, you should have 12.5 volts or better, any readings in the 11 volt range you need to do a proper load test on the battery and replace as necessary, any readings in the 10 volt range you have a dead cell and replace the battery.
4. Drain and flush fuel tank, google " how to clean a motorcycle gas tank" find a couple forums to view the different options available.
5. Remove your air cleaner and clean and re-oil per Mfg. specifications.
6. Remove the carburetor, disassemble and decontaminate with a carb dip or if you have EFI remove injectors and clean with carb spray and compressed air
7. Remove fuel valve and filter disassemble and clean as necessary, remove fuel lines and replace with new ones.
8. Replace spark plug with a new one and check for spark.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
250 sxf wont idle 250 350 450 505 SX XC 4 Strokes
2012 KTM Fuel Injection Filter Discussion Enduro360 com
http://www.ktmforums.com/forums/two-strokes/5351-help-ktm440-wont-idle.html
https://drive.google.com/file/d/0B2-8B_LViIenQ2xmdkZFUEJiaHc/view

May 06, 2016 | 2011 KTM 250 SXF

1 Answer

Hiya just a quick question on what coolant to put in my ktm 250 sxf Cheers????


Hi, Mally sorry you can't find the first and best tool you ever bought for your KTM despair not for a mere $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
Coolant
Flushing the coolant 250 350 450 505 SX XC 4 Strokes
KTM Service Repair Manuals Kristofsx com
KTM 250 SX Owner Manual

May 01, 2016 | KTM Motorcycles

1 Answer

2008 ktm sxf 250 kick lever jammed


could be as simple as water in the fuel.
kick starter issue: need to remove side cover and inspect!

Jul 21, 2014 | 2008 KTM 250 SX-F

1 Answer

2011 ktm250 sxf wont start


i have a 2009 ktm 450 sxf and was riding yesterday and it stalled out when i switched to fourth gear and wont start back. battery is good and when i hit the e start it just clicks once, and it wont roll start either. any suggestions? could it be the switch under the tank? PLEASE HELP!

Sep 24, 2012 | 2008 KTM 250 SX-F

1 Answer

How do I install the cam chain back on the cams of a 2012 ktm sxf 250?


line the TDC mark on the flywheel/crankcasing up , then the cam shaft marks paralell to the cylinder head mating surface then fit chain, fit chain tensioner, take plug out and turn by hand to make sure valves aren't knocking, **** squeeze bang blow! intake fuel, compression, ignition exhaust out

Jan 27, 2012 | 2008 KTM 250 SX-F

2 Answers

I need to find a free repair manual for a 2007 KTM


2007 ktm 250 really hard to start. Any thoughts

Jan 09, 2010 | 2008 KTM 250 SX-F

1 Answer

Ktm 250 sxf 2008 backfires


go on google check the air mixture and altar the air screw on the carb to wot u find on the net easy job thers only 2 screws on the carb

May 20, 2009 | 2008 KTM 250 SX-F

Not finding what you are looking for?
2005 KTM EXC 450 Racing Logo

1,620 people viewed this question

Ask a Question

Usually answered in minutes!

Top KTM Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

Brian Anderson

Level 3 Expert

356 Answers

Are you a KTM Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...