Question about kawasaki KDX 220 R Motorcycles

1 Answer

I have an 01' kdx 220. I wanting to mill the head but im not sure howthick to tell mymachinist and i think someone said i would have to recut the squeesh ring?? Know anything?? Give me your 2 cents. Thnx james. East, tx

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • kawasaki Master
  • 5,065 Answers

U need a rebuild manual and dont do anything until-bookstore ,library or online cowboy

Posted on Aug 09, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i change a piston head in a 2010 hyundi sonata


You could have a timing belt that has slipped. This would mean the pistons are hitting the valves. This is not an easy job. You have to drain the coolant, take off the exhaust and intake manifold, take off the head to the cylinders on the engine block. Check for damage to the pistons, replace everything and change the oil.

Aug 01, 2014 | Masterflex Series Q Valveless Piston Pump...

1 Answer

Can I use Interceptor Amsoil in my 99 KDX 220 and what mix


The Amsoil is an excellent oil to use. I would use it or Motul at a 40:1 ratio.

Apr 27, 2014 | 2003 kawasaki KDX 220 R

1 Answer

Kdx 200 clutch not engaging properly


The clutch in your bike is a wet clutch. There is a lot of hyrdostatic friction even when the clutch is released completely. I think a large factor is the type, age and condition of oil. Perhaps something as simple as an oil change would help.

Jan 14, 2010 | 2005 kawasaki KDX 200

1 Answer

I just want put e speed metre on my kdx 220


GET A DIGITAL ONE (FOR MOTORCYCLE & BICYCLE)
THE READ-OUT CAN BE CLAMPED TO THE HANDLEBARS & THE WIRE FROM IT GOES DOWN THE FORK LEG TO A PICK-UP UNIT THAT U STICK TO THE INSIDE OF THE FORK LEG AT THE NEAREST POINT TO THE MAGNET WHICH GETS STUCK TO THE WHEEL (USUALLY THE RIM)
GET ONE THAT ILLUMINATES. SOME HAVE TRIP & OTHER FEATURES
I HOPE THIS HELPS, IF SO, PLEASE MARK AS USEFUL
RIDE SAFE
BIKE-DOC

Jan 07, 2010 | 2003 kawasaki KDX 220 R

2 Answers

Im replacing my piston and rings and i took the cylinder and cylinder head out and i dont know how to time the engine , the sproket has a mrk on it and i dont know if i shuldput the piston all the way down...


Below is a generic diagram. If only one mark is present it points upward and in line with the crankshaft center line. If two marks are present they line up with the gasket surface of the cylinder head. The piston should be on TDC and the cam lobes should be pointing downward. Be sure the chain is on the crank sprocket, not wedged between the sprocket and the balance weights. Also be sure that the chain is taught on the front side of the engine. Any slack should be at the back side of the cylinder so the chain tensioner can work properly.
Can I get a “very helpful” rating on this answer?

639adea.gif

Aug 23, 2009 | 2005 kawasaki KDX 220 R

2 Answers

Pinging noise at high rpm


You could have fuel with to low of octane rating.

Jun 01, 2009 | 2003 kawasaki KDX 220 R

1 Answer

Starts only with new plug,sometimes (1984 kdx)


check engine oil and change the oil seal of engine

Apr 02, 2009 | 2004 kawasaki KDX 220 R

2 Answers

Upper fairing R model pieces..


rofl sorry i didnt see this thread the 01-03 has those for sure, but im not positive on the 98-00, my best bet would be yes, but they are very expensive, i think like 250-300 bucks, anything will fit with a little modification.. so i would say try it.. what the hell! ,,,

Nov 10, 2008 | 2002 Aprilia RSV Mille Haga

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

166 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

5065 Answers

Marvin
Marvin

Level 3 Expert

81424 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...