Question about Buell 1125R Motorcycles

1 Answer

The basttery fuze and the ignition fuze are blowing when the battery is connected. This is a new battery from HD. Any ideas?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

Maybe getting bigger fuses will help

Posted on Aug 04, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My run/start fuse is blowing but it only does it sometimes. I just bought the Jeep and I drove it for a week and it drove fine. I changed the plugs, cap, rotor, and wires. I drove it around and then f


Did you or previous owner add any electrical things like winch, radio amp or lights hooked up to that fuze? If yes, rewire so they run on their own properly sized fuze.

If no, you have an intermittent short somewhere. Get a schematic, figure out where the wires from that fuze go to get to the things the schematic tells you they go, then follow the wires looking for damage. If you cannot isolate wiring harness damage, run new wire taped to the outside of the existing wiring harness.

It is possible one of the things hooked up to that fuze has an intermittent problem inside. A way to find that is to run a separate fuzed power to the devices (ignition coil, EGR, fuel pump etc). on that circuit, drive it for a while and see if that fuze blows. If it does, investigate/replace that device. This requires major surgery on the wiring harness and is not to be undertaken lightly, this is a big deal and it is hard. Big problem is to make sure the reconnected wires are reliable for the next 15 years.

Jan 04, 2015 | 1999 Jeep Cherokee

1 Answer

Chevy van g20 year 1994 the battery dies has new battery and new alternator but each morning its dead need to charge the battery need help have any ideas and please talk problem please


Does the battery light work when you switch the ignition on? This provides a live feed to the alternator via the ignition bulb, the rotor needs a live feed to start the charge process, if the bulb has blown it won't charge (thin wire connected to the IND on the alternator). To check for a power drain, disconnect the negative battery lead put a AMP meter in series, (DON'T TRY TO START, YOU WILL BLOW THE METER). If you get a reading above 0.05amps (clock) you have a drain, pull the fuses one at a time and watch for a drop in the meter reading. Hope this helps.

Jan 24, 2014 | 1994 Chevrolet G20

1 Answer

Fuse box what fuses are for ? what do they protect and do they have anything to do with the coils?


main fuse protect sthe whole system from power surges caused by a bad stator or regulator,then the other fuzes are for lights,horn, and are usually marked. if the main fuze blows it will shut down the ignition to prevent damage to wires,coils, and anything else. your answer, no there is no fuze just for coils,only the main.

Aug 07, 2010 | 1979 Suzuki GS 750 E

2 Answers

My HTC fuze started to heat up on its own! This is resulting in the battery discharging at a much faster rate. Any ideas?


i know this sounds crazy but u can get a blow dryer and put it on cool and dry your phone thats what i did to my htc fuze and it works so good luck!!!!

Apr 02, 2010 | HTC FUZE Smartphone

3 Answers

My new sandisk fuze shut off and will not power back up even with the charger attached - any ideas?


Hold power on for 30 seconds. Then release and push power up again. This will reset it.

Dec 31, 2009 | SanDisk Sansa Fuze MP3 Player

1 Answer

Intermittent electrical problem


Have your voltage regulator checked. On some vehicles the voltage regulator is built into the alternator. Voltage changing and giving too much or too little can cause all kinds of problems.

Jun 04, 2009 | 2002 Chrysler Town & Country

1 Answer

Blowing fuzes


If the fuses blow before the remote voltage is applied, the power supply FETs or the reverse protection diode has likely failed.

Let me know if you have any other questions.

Aug 29, 2008 | Kicker 06ZX750.1 Car Audio Amplifier

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buell Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

jeepguy617

Level 1 Expert

41 Answers

Are you a Buell Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...