Question about 2003 kawasaki KLX 300 R

1 Answer

What would be the problem if when you give the bike gas it cuts out? The bike starts fine just when u give it gas it dose not accelereate

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 3,567 Answers

This is a crack, pinhole or tear in the rubber carb diaphram or loose screws on the diaphram cap. The tear, pinhole or loose cap is killing the vacuum needed in the top of the carb to raise the carb slide to increase speed. Please rate my answer.

What would be the problem if when you give the - 4762725.gif

Posted on Aug 04, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Bike not starting

first try a new spark plug, if you get spark check gas filter, have spark ,have fuel, have timing it should start

Jan 05, 2014 | Pit Bike 125cc 4 Stroke Dirt Bike

1 Answer

Suzuki gsxr600 srad 1998 bike .When stationary in neutral ot starts and runs fine .... it revs sweetly up through the rev range , when when on the road it accelerates well in 1st , then jit second gear and...

You need to tunes up the carbs. The small jets in the carbs can easily run at idle when partially clogged but can't sustain a high rev without bucking the bike.

Oct 12, 2013 | 1999 Suzuki GSX-R 600

1 Answer

2006 TTR125L Starts and Idles fine, but cuts out when I accelerate.


Jun 14, 2013 | Motorcycles

1 Answer

2007 flhx starts,but cuts off on take off.

Does the bike run if you give it throttle past idle? The motor should accelerate and gain RPM's when doing so. If it does and gains RPM's but is sluggish in response, I would check to make sure it has good gas flow. Check flow off the petcock, if good, check gas filter on the motor side. If still not running correctly, I would check the air cleaner inside to make sure some critter didn't get in there and make a nest or something. Beyond those ideas, I would bring it to a profession shop or a friend in the know.

Jan 13, 2013 | 2007 Harley Davidson FLHX Street Glide

1 Answer

2001 Suzuki TL1000R will not acelerate

Hi , you must get local help from someone that has access to the means to adjust your fuel injection sistem, wich is not reponding to trootle action. It may be a simple transducer, but you must be sure.
Good luck

Nov 02, 2011 | 2001 Suzuki TL 1000 R

1 Answer

Having trouble getting bike to run whenI give it

This is more than likely a carburetor problem. Either your main jet is stopped up or your accellerator pump is not working.

Take the front cover and element out of your air filter so you can see down into the carb. With the engine off, twist the throttle. Watch to see if a stream of fuel squirts into the carb, If you don't see it, your accelerator pump needs to be rebuilt. If you do see the stream of gas, then it sounds like your main jet may be stopped up.

One other cause is that your diaphragm for the slide has a hole in it and not operating. Start the bike with the air filter element out. Rev the bike and watch to see if the slide lifts up. If not, bad diaphragm.

Mar 16, 2010 | 2003 Harley Davidson XL 1200 C Sportster...

3 Answers

I have a 1994 buick lesabre, it idles fine however when you drive it and come to a stop sign it either tries to cut off or dose cut off, pressing the gas pedal dose nothing at all, some times it will try...

If t dies hard - feeling like the trani is not disigaging when you stop - it could be a electronic part inside the trani.. This part tells the stall converter to kick in at a stop.. Not super expensive to fix.. But best done by a trani shop....

Jul 08, 2009 | 1994 Buick LeSabre

1 Answer

Starts fine then stalls when I give it any gas

if it only runs w/choke on then your jets are plugged...fuel should have been drained before storage...time for carb clean i suspect...Tim

May 30, 2009 | 2006 Yamaha V Star 1100 Classic

1 Answer


dose it start again?? dose it have acceleration in the first 20 second ??
if not . check the fuel pressure , fuel filter & fuel injectors
check and give us more details to help you again
with my best wishes

Jul 08, 2008 | 2000 Daewoo Lanos

Not finding what you are looking for?
2003 kawasaki KLX 300 R Logo

Related Topics:

142 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

5042 Answers


Level 3 Expert

81285 Answers


Level 2 Expert

342 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides