Question about 2000 kawasaki VN 2000

1 Answer

I have trouble starting

Turns over slowly, has new batterty

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Vice President:

    An expert whose answer gotĀ voted for 100 times.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

  • Expert
  • 56 Answers

Does it have a reticifer if so you might need a new one or it could be the charging coil on your magneto.

Posted on Aug 01, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wont start ignition coil


Right now either the cold or the starter is going out. My Caravan has a new battery, but turns over slowly due to the cold. I just jump it and it starts.

Jan 23, 2014 | 1984 Ford Ranger

1 Answer

I Have a Ryobi Trimmer. I cleaned out the carb and put it back together but forgot the High and Low needle settings. I have got it to start but am having trouble tuning it. I have put a carb kit in it and...


adjust the needles both all the way in until they stops. unscrew both 1 1/2 turns and start engine. slowly accelerate and if it bogs down unscrew the HIGH SLOWLY until full speed is gain. some times you have to unscrew a little the low speed too. is a matter of playing with it. be patient you will get it. if you are still having problems you may have to take the bottom of carb. out and make sure the gas inlet needle is letting pass gas into the carb. chamber.

Feb 16, 2011 | Ryobi Garden

1 Answer

1994 jeep, wont start, wont run


It sounds like you may have a bad connection somewhere. Start with your battery cables and then look at all of your ground wires as well. When you try to start your jeep see if the wires from the battery get hot.

Jul 30, 2010 | 1994 Jeep Cherokee

1 Answer

Clicks when you go to start it


Why change battery and alt? Both failed together, not likely. Clicking of the starter solenoid has for decades been a battery gone bad or a starter issue. Solenoid or starter motor brushes etc. What relationship has the sitting and not starting have to do with it. The alt only keeps the battery charged if it the alt can not supply the current needed to run the veh and draws on the battery. That battery keeps the computer memories live and turns the starter over. New battery. Are all the ground wires clean and tight? There may be Relays for the starting circuit. Please do not throw parts at it. Take it to the very best, close by repair facility or dealer. These vehicles are very complex today and even with my 45 years experience,some professional we can't keep up.

Sep 25, 2009 | 2003 Chevrolet Tahoe

2 Answers

Renault espace 2.2d.c.i new battery turns over wont start.


could be one of many probs check your altenator is giving a charge to the battery any garage could do this for you it only takes 30 seconds and most reputable garages wont charge for this

Sep 03, 2009 | 2003 Renault 181

1 Answer

1997 E250 van turns over but won't start,its fire or fuel?how do I trouble shoot the problem? It has been slowly starting for about a week now,engin turns over fine,went into store came out and won,t...


test the fuel bar by unscrewing the cap next to the bar the depress it while key is in on position careful not to get it in yer eyes and see if the fuel will flow ....while turning over ch for spark with a squirt bottle of water to see any visible sighs of an arc

Aug 22, 2009 | 2004 Ford E250

1 Answer

Car overheated sounds like it want to start but it wont


You could be in big trouble if the engine turns over slowly when trying to start when engine is cold (not warmed up). Check the charge in your battery and connections to make sure they are clean. If they are ok and it still turns over slowly and does not start you may have major engine repairs due.

May 30, 2009 | 1991 Toyota Camry

1 Answer

Changed the batterty and now it will not start


This engine is controlled by a computer, run the self test on it and see if the system has trouble codes stored.

Oct 17, 2008 | 1988 Volvo 740

Not finding what you are looking for?
2000 kawasaki VN 2000 Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4742 Answers

yadayada
yadayada

Level 3 Expert

78267 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...