Question about 2001 Yamaha YZF-R6

1 Answer

My r6 is running like 3 min and than it just shouts off and it has to stay like thats for like 30 to 45 min and it will star one more time

Posted by on

  • carlosjcarba Aug 02, 2010

    well i just change all the spark plugs and it did the same thing run for 3 min and it just went out on me some people told me that it had to be the fuel pump or if not the air filter. any help that i can get will be perfect for me. but how will i know about the bad coil.

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 87 Answers

Sounds like it has a bad pick up coil you need to check for spark after it quits running

Posted on Aug 01, 2010

  • andrew richards Aug 05, 2010

    you need to pull one spark plug after it quits running and ground the metal part of plug to the head and spin the engine over by the starter do not hold plug in hand it will shock the mess rigt out of you use needle nose hold gently by the wire if you do not own a spark tester the fire on the plug should be a blue spark if it has any at all red or oarnge will mean weak fire if it appears to have good spark put plug back in try to give it a little raw fuel srtaight through the air breather if it cranks and it will if it has good spark you have found a fuel problem may be bad pump if it has one

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I droped my vstar 950 now it wont start.


Hi, Anonymous and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, needs to be 12.5 volts or better and be able to pass a load test if necessary.
4. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
5. Tip over sensor needs a reset.
6. Faulty ignition switch.
7. Faulty starter button.
8. Faulty kickstand or clutch pull in switch/sensor.
9. Starter control circuit, relay, or solenoid faulty.
10. Main fuse or circuit breaker may be blown or faulty.
11. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
Bike fell over and won start
http://www.r6messagenet.com/forums/r6-maintenance-technical/75710-dropped-my-r6-left-side-now-wont-start-ideas.html
Yamaha XV950CU Owner Manual
OEM parts for Yamaha
2011 Yamaha STAR 950 TOURER Motorcycle Service Manual Download Manuals...

Apr 23, 2014 | 2011 Yamaha V Star 950

1 Answer

My r6 keep push coolant out of expansion tank


Recommended cooler level in expansion tank is in the middle between MIN and MAX while the bike is at top working temperature and it's radiator fan already engaged a couple of times. Use coolant that can withstand +112 C or more
If after that still spills coolant from expansion tank's overflow hose you should check compression on each cylinder for head gasket damage.

Oct 17, 2012 | 2002 Yamaha YZF-R6

1 Answer

I have a 2000 Yamaha V Star 1100 Classic and the check engin light stays on...


That means that the motorcycle's ECM has a fault recorded in its memory and you should take it to a dealer to run electronic diagnostics to find it.

Feb 01, 2012 | 2000 Yamaha V Star 1100 Classic

1 Answer

Pc won't start


Think your power supply died. Check that out first since they are relatively inexpensive. Or throw in a known working PS to see if that does the trick. Write back with results for further info.

Sep 17, 2017 | Packard Bell iMedia Computers & Internet

1 Answer

2004 r6 starts but won't stay running what I do


Hi, Mckinneym697 and the usual suspects are:
1. Idle circuit and transfer ports clogged.
2. Air fuel mixture adjustment too lean.
3. Pilot jet clogged.
4. Faulty accelerator pump.
5. Float level too low.
6. Float bowl contaminated old fuel, water, dirt, rust, etc.
7. Float bowl vent or overflow tube clogged.
8. Fuel flow to carburetor restricted.
9. Intake manifold leak.
10. The gas cap is not venting properly or fuel tank venting system blocked.
11. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
12. Needle and seat stuck closed in the float bowl.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
2007 Yamaha R6 won idle more info inside motorcycles
Wrecked bike starts but doesn stay running ideas
2003 2004 Yamaha YZF R6 Service Manual R6 Moto Data Project
OEM parts for Yamaha
http://mybikemanuals.com/yamaha/yamaha-yz-owners-manuals

Jul 14, 2011 | 2000 Yamaha YZF-R6

1 Answer

MY READY HEATER STARS FOR 3 SECONDS THEN SHOUT DOWN


This can be from either a bad connection from the thermocouple to the gas valve or it could be a bad high limit switch.

If you run a jumper wire between the two leads on the thermocouple and the units runs then you may need to replace the High limit Switch.
If that does not solve the problem then clean the end of the thermocouple lead that goes into the gas valve.

Thanks

M Cramer

www.allpartsinc.com

Jan 03, 2011 | Reddy Heater-30-55,000 BTU Variable

1 Answer

My heater is running fine than its been shout off for some time and the fan well kick on and run for 2 to 3 mins then shut off is it a high limet ????


Sorry to read about your heater problem.

If the furnace starts up and you feel heat,then yes you may have a high limit issue. if you dont feel heat, then you may have a glow rod issue.

I tried to help you. Please help me and Rate/Vote on my response. We take the time to answer your question. take the time to rate us.Thanks and good luck

4 Thumbs - Very Helpful
3 Thumbs - Helpful
2 Thumbs - Somewhat Helpful
1 Thumb - Not Helpful

Dec 27, 2010 | Goodman GMS90703BXA Heater

1 Answer

Why do the computer shout off after two min: 's of running is something wrong with the power cord or what whats happening


Generally, if a system runs for a short period of time then shuts down, it is a Hardware issue (Usually overheating or bad RAM)

Sep 26, 2010 | Gateway Computers & Internet

1 Answer

Fueling question


the gas is probly bad--pump could be froze from inactivity-u need a repair manual today for detailed procedures and troublshootin

May 17, 2010 | 2001 Yamaha YZF-R6

Not finding what you are looking for?
2001 Yamaha YZF-R6 Logo

Related Topics:

200 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1147 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...