2004 Honda CBR 600 RR Logo

Related Topics:

Posted on Jul 31, 2010
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Blinkers stay solid after modification

I put a hotbodies undertail on my 04 600rr. All wires are matched correctly. When i turn the blinkers on they stay solid and dont blink. The blinkers have a live and groud wire, so no mixing them up is not possible. The instructions also tell you what colors to match. I did disconnect the plate light because there is no place for it now. The wires for that are just taped off. Any ideas?

Answer This Question

1 Answer

Anonymous

Level 2:

An expert who has achieved level 2 by getting 100 points
MVP:

An expert that got 5 achievements.
New Friend:

An expert that has 1 follower.
Hot-Shot:

An expert who has answered 20 questions.

  • Expert 51 Answers
  • Posted on Jul 31, 2010
Anonymous
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points
MVP:

An expert that got 5 achievements.
New Friend:

An expert that has 1 follower.
Hot-Shot:

An expert who has answered 20 questions.

Joined: Jul 04, 2010
Answers
51
Questions
0
Helped
22059
Points
111

Check whether all the wires are connected properly. If so check the flow of charge. Otherwise contact the mechanic

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Have a 2007 ford f150 blinkers and 4 ways work fine untill headlights turned on then blinkers stay light but not blinking
Could be the turn singal relay not getting the correct power when lights engaged. Take out bulb from headlight and then turn on headlights. Now no power to the headlights. Try to turn on blinkers now. If they blink replace signal relay, if they still are solid it may be your flasher. Just a guess without looking. Thanks.
Read full answer
Sep 04, 2014 • Ford F-150 Cars & Trucks
0helpful
1answer

Blinkers dont work
You may need to replace the blinker controller, a small device that manages the timing and sequential on/off to the bulbs.
Read full answer
Mar 05, 2014 • 1999 Mazda Millenia
2helpful
1answer

I have a 98 Olds Intrigue. Hazards & Blinkers flash in the rear only.... the front lights up solid, no blinking. When disconnected from the head lamp assembly we have tested the flasher wire....
Have you checked the fuse under the drivers side dash?Manual should give you an image and should be label'd

I’m happy to help further over the phone at https://www.6ya.com/expert/zelio_00a80ed57645ccbf

Read full answer
Feb 19, 2012 • 1998 Oldsmobile Intrigue
0helpful
1answer

Blinkers do not stay on. flashers work. Brake
you need a new turn signal flasher
Read full answer
Sep 01, 2010 • 1998 Ford Explorer
0helpful
1answer

Blinkers dont work. the turning singles wont blink
Hello, what you should do is if the blinkers just stay on constant when you turn them on means that the turn signal flasher is bad, it is located under the dash on the drivers side below the steering wheel. it will be a little silver cylinder with two wires coming off of it. General Motors usually puts them up against a bar under the dash.
Read full answer
May 18, 2010 • 1992 Buick Century
0helpful
1answer

2002 trailblazer when i put my blinker on to turn left both bliners blink when light are off, when they are on the left turn signal stays solid
THERE IS A BLINKER RELAY UNDER THE DASH. IF YOU CAN GET ONE OF THE BLINKERS TO BLINK YOU CAN HEAR THE RELAY LISTEN CLOSLEY THEY PUT THESE THINGS IN SOME HARD TO GET PLACES
Read full answer
Oct 12, 2009 • 2002 Chevrolet TrailBlazer
0helpful
1answer

Blinkers, fog lamps, heater/defroster, heated seats not working
you may have aflaulty ground on your vehicle, check for good chassis and engine ground, replace relays and fuses as nessesery
Read full answer
Jul 21, 2009 • 2000 Audi A4
1helpful
1answer

1984 monte carlo left blinkers are fine but
What you need is a new blinker module. They are a relatively cheap part that you can go to an auto parts store and get, and install yourself quite quickly with their instructions.
Read full answer
Jul 17, 2009 • 1984 Chevrolet Monte Carlo
0helpful
1answer

Blinkers stay solid and dont flash, Hazards work fine.
CHECK GROUND ON TAIL LIGHT HOUSING.
Read full answer
May 07, 2009 • 1995 Chevrolet Cavalier
3helpful
2answers

Pressing brake causing blinker issue
The trailer harness that was installed probably has a short inside the box that distributes power to the trailer pig-tail. Remove the trailer harness. You problem will be cured.
Read full answer
Jan 27, 2009 • 1999 Toyota 4Runner
Not finding what you are looking for?

View Most Popular

2004 CBR 600 RR

  • Motorcycles

Related Question

Have a 2007 ford f150 blinkers and 4 ways work fine untill headlights turned on then blinkers stay light but not blinking

  • Ford F-150 Cars & Trucks

Related Topics

220 views

Ask a Question

Usually answered in minutes!

Popular Questions

My HESD warning light came on on my 2007 honda

2008 Honda CBR 600 RR

Fuel pump isnt priming

Honda CBR 600 RR Motorcycles

My honda cbr 600rr 2005 will not start the hiss

2005 Honda CBR 600 RR

Pdf of the 2007 Honda cbr600rr repair manual

2008 Honda CBR 600 RR

Honda cbr 600 rr 2005 fuel tank removal

2005 Honda CBR 600 RR

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3054 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...