Question about 2005 Suzuki Boulevard C90

Open Question

I have 20k on my C90T suzuki and get lifter noise on acceleration,what causes this problem?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 653 Answers

SOURCE: I have a 2008 Suzuki C90T. I has a bad ticking

Try checking your valve stem seal or see if your exhaust pipe blows white-bluish smoke when you up the rev for the oil leak. If it does then have it fixed or you can try to use oil sealer additives for not so badly damaged seals or even piston rings.
How often did you change the oil, have you ever use engine or lifter flush additive?
Go to your local car/motorcycle shop look for an engine flush/lifter flush additives, put it into your oil, ride for about at least 60 minutes, change the oil and filter, ride again for about 2 weeks (200-300km) then use the same additives again, change your oil and filter again,put in fresh oil and filter and that should give your a relieve from the noise tappet ticking.

Posted on Mar 22, 2010

Ad
  • 72 Answers

SOURCE: lifter noise

Could be that the bike has been ridden a little hard; could be dirty oil. Put a cleaning additive in your oil, idle bike for 10 - 15 min drain oil replace filter, add new oil - good stuff- and see if they quiet down.

Posted on Mar 24, 2010

  • 21 Answers

SOURCE: 05 Suzuki C90T turn signal replacement

The turn signal indicators are attatched by a M6 screw underneath, they do not screw in like most bikes.

Both the rear and front indicators are mounted on a nice chrome fitting that can easily be removed. The rear one is bolted through the fender, access the bolts from inside the guard. The front ones are mounted with screws underneath the chrome mounting. Once you remove the mounting the wiring can be easily unplugged and indicators replaced.

Posted on Jun 12, 2010

  • 1 Answer

SOURCE: lifter noise

There is a tendency for you tohear some noise because they are normally pretty quiet, but just in case you didn't check it out put your hand on the gas cap cover when going down the road.They vibrate after awhile> you might try synthetic oil also, it does quiet them down.

Posted on Jul 19, 2010

  • 200 Answers

SOURCE: can't find dip stick to check oil on suzuki motorcycle c90t

There is no dipstick on suzuki . Stand beside your bike and look on the bottom right side of your crankcase . look for a little site glass window . That is how you
check . if the oil is half way up the glass when you stand bike straight up . . change every 3000, plus filter

Posted on Oct 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2008 Suzuki Boulevard C90T starter solenoid location


Hi, Brett for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Suzuki, despair not, for a mere zero $ you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
2008 Suzuki Boulevard C90T starter solenoid location Google Search
05 C90T Starting Problem Maybe Compression Lock
Suzuki VL1500 Service Manual
OEM parts for Suzuki
Suzuki VZ1500 Owner Manual

Jan 08, 2017 | 2008 Suzuki Boulevard C90T

1 Answer

Manual for c90t suzuki 2009?


look at this http://www.servicerepairmanualonline.com/category/motorcycle-manuals/suzuki/
wish help!


if you need laptop components?goto laptop parts

Apr 27, 2012 | 2009 Suzuki Boulevard C90T

1 Answer

What is the valve adjustment spec?


The C90T has Hydrulic valve adjusters and should not need the valves adjusted on it. There is no listed spec only to replace the lifters or adjusters.

Oct 31, 2010 | 2005 Suzuki Boulevard C90T

1 Answer

Lifter noise


There is a tendency for you tohear some noise because they are normally pretty quiet, but just in case you didn't check it out put your hand on the gas cap cover when going down the road.They vibrate after awhile> you might try synthetic oil also, it does quiet them down.

May 14, 2010 | 2005 Suzuki Boulevard C90

1 Answer

Lifter noise


Could be that the bike has been ridden a little hard; could be dirty oil. Put a cleaning additive in your oil, idle bike for 10 - 15 min drain oil replace filter, add new oil - good stuff- and see if they quiet down.

Mar 24, 2010 | 2005 Suzuki Boulevard C90

2 Answers

C90T 2005 57,000 miles oil leak on left side of cooler,bottom


Get some new washers and remove and replace these washers to stop the leak. Use Genuine Suzuki parts

Mar 22, 2010 | 2005 Suzuki Boulevard C90T

2 Answers

I have a 2008 Suzuki C90T. I has a bad ticking noise when it is cold. It has hydralic lifters so the valve can't be adjusted. The bike has 20k on it. The ticking seems to be getting worse but it will go...


Try checking your valve stem seal or see if your exhaust pipe blows white-bluish smoke when you up the rev for the oil leak. If it does then have it fixed or you can try to use oil sealer additives for not so badly damaged seals or even piston rings.
How often did you change the oil, have you ever use engine or lifter flush additive?
Go to your local car/motorcycle shop look for an engine flush/lifter flush additives, put it into your oil, ride for about at least 60 minutes, change the oil and filter, ride again for about 2 weeks (200-300km) then use the same additives again, change your oil and filter again,put in fresh oil and filter and that should give your a relieve from the noise tappet ticking.

Mar 22, 2010 | 2005 Suzuki Boulevard C90T

2 Answers

Rattling noise


I know this may sound lame but I had a similar rattle and it was the catch on the fuel lid.
I put a little rubber on the tounge of the lock and now it is quiet.

Oct 14, 2009 | 2005 Suzuki Boulevard C90T

1 Answer

Tapping noise


Could be a hydrualic lifter that is causing the noise. You would have to take off the valve cover to find out and then put a new gasket on whemn you put it back again.

Feb 12, 2009 | 2006 Suzuki DL 650 V-Strom

Not finding what you are looking for?
2005 Suzuki Boulevard C90 Logo

Related Topics:

87 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

Richard
Richard

Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...