Question about Honda CB 750 Nighthawk Motorcycles

1 Answer

Lost oil pressure - CB 750 Nighthawk Honda Motorcycles

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,978 Answers

Replace the oil pressure sender to make sure the pump has gone out. If you replace the sender and the light goes out your oil pump is OK. If you crank the motor a few times and the light does not go out you will have to do what is necessary to replace the oil pump and any parts that were damaged when it went out. Always start with the cheap stuff first see if the sender fixes the problem.

Posted on Jul 30, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 01 gmc yukon denali. It has had a small oil leak and I have been adding oil as needed. I just added some oil, drove 5 blocks and lost all oil pressure. By the time i got home there is a loud...

Did you suddenly loose all oil as well? Once you loose all oil pressure you must shut engine off IMMEDIATLY to prevent major engine damage.. How low is oil now? If very low and you really lost all pressure, engine may be junk.

Feb 25, 2015 | GMC Cars & Trucks

1 Answer

I've suddenly lost oil pressure in my 01 fairmont ghia intech Tickford any ideas as why ? It's been sluggish for awhile spent $800at mechanics and now this happened. And it's still sluggish

-Check oil level. it's full or not. If not then top it to full line.
Most engine that lost oil pressure due to not oil or very low.

Good Luck

Mai Lor

Nov 08, 2014 | Cars & Trucks

1 Answer

Suburban oil pressure sending unit

FIRST you need to get an actual oil pressure tester to hook up directly to where the oil pressure bulb is and see what you get there...

Dec 18, 2013 | Cars & Trucks

1 Answer

My oil light stays on even though I have enough oil in my

The oil warning light is telling you the oil pressure is below 10psi.
If the pressure switch is working correctly the engine has lost oil pressure and-or oil.
You would need to replace the switch or have the pressure checked with a mechanical gauge.

Jan 11, 2013 | 1995 Oldsmobile Cutlass Supreme

1 Answer


When re-installing the oil pump, make sure it is aligned properly. If it's not, binding could cause your problem.

Sep 20, 2012 | Harley Davidson Motorcycles

1 Answer

I have a 1997 ford expedition and today when i started it I had oil pressure then I drove down the road and lost all pressure and engine started to tick, I turned the engine off and then back on and The...

Sounds like the oil pump is going out. I would not drive it until you find out for sure. The ticking is oil not reaching the valves and rockers.

Jan 04, 2010 | 1998 Ford Expedition

1 Answer

Engine lost oil pressure. Where do I begin to

check for a dent in the oil pan if no dent then check that the oil filter is good and not faulty "replace it" if still no pressure u will need a oil pump

Oct 19, 2009 | 1986 Chevrolet Monte Carlo

1 Answer

Lost oil pressure in 93 Mazda 626, 2.2L estate wagon

you need to do a compression test worst case scenario you might have to rebuild motor

Mar 16, 2009 | 1993 Mazda 626

1 Answer

Lost oil pressure while driving

change oil filter use a k&n or mobile one,seen same problem on caravans some oil filters cannot take the pressure and break up inside causeing no flow of oil period.could happen at any time with cheap oil filters,chryslers have high volume oil pumps and require a better flowing filter.
as for your engine not starting you may have severe bearing wear,from low oil pressure.

Feb 07, 2009 | 1991 Dodge Spirit

1 Answer

Lost all oil pressure no oil getting to top of engine

mileage?..over heated? oil to top is function of oil pump and oil passageways ..bad worn lower engine (crankshaft/bearings)......oil pump push rod..under distributor driven gear down into block to oil pump in oil pan..clogged passages/oil filter/oil filter bypass...... do a oil pressure test while cranking from port on side of block low and determine if bottom end has the pressure first

Nov 15, 2008 | 1999 Chevrolet Blazer

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

116 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

5055 Answers


Level 3 Expert

81294 Answers


Level 2 Expert

342 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides