Question about 2002 Yamaha YZ 426 F

1 Answer

I drove through a pond with my 4 wheeler and the water mixed with the oilwhat should i do to fix it?

Posted by Anonymous on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Yamaha Master
  • 2,050 Answers

Change the oil and filter, run it for 1/2 hour or so and do it again. Also, make sure the air filter is clean!

Posted on Jul 29, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What causes polaris four wheeler brakes to lock up

1) foreign matter in the lines. old fluid, water or rust cause blockage and/or corrosion and may not allow fluid to go back properly.
Bleed lines with copious amount of new fluid. Never reuse old fluid or put back in a brake fluid bottle.
2) bent rotors - pretty common on quads. replace (bang back as required if you can)
3) caliper not returning. remove, clean, inspect required.
The rubber sleeve that the caliper pin runs back into may be full of crude.

Oct 12, 2014 | Polaris ATV

1 Answer

Pond pump quit working

1. fix power cable fix in place.
2.fix hight and distance of sucksion and dilivery pipe ability
3.check ballbaring,impiler,valves,capacitor,and other part carefuly

4.first time starting u fill some water than start
5.check manual carefully

Nov 07, 2012 | Garden

1 Answer

Where do u add oil to a polaris trail boss 250 4+4

there is a oil res in the front of the four wheeler

Nov 18, 2010 | Polaris ATV

1 Answer

Were is an oil plug for a 4 wheeler

most are on the bottom. Look for a hole in the skid plate and you should find the oil drain plug

Apr 17, 2010 | Polaris ATV

1 Answer

I have a 2005 polaris sportsman 4-wheeler. a while back the tach quit and now it doesnt charge. any ideas?

check magneto and battery connections may be dirt/surface rust causing output/charging problem

Oct 26, 2009 | Polaris ATV

1 Answer

1986 polaris 4 wheeler 250 gas leak. Need a manual in how to

Find a Clymers or Haynes manual for it at a Checker or Auto Zone or go online to find one.

Sep 10, 2009 | Polaris ATV

1 Answer

Lost low on polaris 4 wheelers heard a pop and no more low

how do you fixs pull ropes for yamaha kodak

Aug 10, 2009 | Garden

1 Answer

2007 Honda TRX250. My daughter's friend ran the

on the bottom of you carb there is a brass flat head screw that is the bowl drain screw you need to drain the carb with the gas on drain it for about 45 seconds to flush the water out of it make sure that you check you air filter as well it should be under your seat

Jun 29, 2009 | kawasaki Full Suspension Mountain Bike Men

1 Answer

Leak in formed pond

It worked for one season on mine. As the crack got older it became longer and wider. Mine was due to not sinking the pond all the way into the ground which caused stress from the weight of the water causing it to crack more. The second season I used a water epoxy putty I bought at home depot in the glue dept. It is greenish blue and turns white after mixing and can be used underwater if necessary. I filled the gap and then placed the repair liner like you are showing over the top and sealed the edges with a black waterproof silicone. This also worked for a season. Now the crack is even larger and wider and nothing I am doing this year is holding! I can't seem to find one the same size and shape or I would replace it. My next attempt is going to be a plastic welding kit, but I haven't tried it yet. Good luck.

Jun 05, 2009 | Epdm Lp1, /Pvc Liner & Preformed Pond...

Not finding what you are looking for?
2002 Yamaha YZ 426 F Logo

Related Topics:

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts


Level 2 Expert

314 Answers


Level 3 Expert

1216 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1165 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides