Question about 1987 Yamaha FZR 250

1 Answer

When i pull up or stop the bike it just dies other

The bike dies all way's dies when i stop,is this carb prob??other than that its going fine.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 593 Answers

Your idle circuit in the carb can be clogged. Have you tried to set and adjust the idle? Have you tried running with the choke on a bit. This problem can be due to

  • 1) clogged idle circuit in the carb.
  • 2) ignition timing
  • 3) Vacuum leak at carb to head mount.
  • 4) restriction in tank port, or clogged screen in tank valve.
Hope this helps.

Posted on Jul 16, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Motorcycle complete loss of power and bike dies


check that the tank cap is venting and not causing a vacuum in the tank and lack of fuel to the engine.

Jun 01, 2013 | Motorcycles

1 Answer

I just bought a 2004 Honda Shadow 600cc that had been sitting for a while. When I pull the choke the engine will idle but as the choke hits the middle the bike dies. also once its running I have to ride...


Sounds like you have a float sticking in your carburetor, is this a single carb or a duel carb? , also gas can go stale and your bike will run like **** if it also has been subjected to tank condensation and water in your gas, that also maybe your problem, I would drain the tank and drain the carb or carbs, and start off with fresh gas and would use 89 octane or better, also pickup some StarTron Enzyme gas treatment, it will stabilize your gas for up to 2 years, and remove the ethanol from your gas, that is a bad for your motor, try it you will never go without it. Good luck, Rick.

Aug 06, 2011 | 2004 Honda VT 600 C Shadow

1 Answer

My 2006 ninja 250r seems to have a fuel problem. She starts up fine...(and this doesn't always ocur) but after a brief ride I will pull to a stop and my bike will die. The it will not start unless I...


This sounds like your idle jet need to be cleaned or replaced, try runing a few tanks of B12 or some other carb/fuel injector cleaner threw it and see if that helps if not you may need to rebuild the carb.

Apr 18, 2011 | kawasaki Ninja 250R Motorcycles

1 Answer

I have a got a 91 zzr6oo, it starts fine and revs fine. As soon as I pull away the power dies almost like fuel stavation. I think it might be somthing to do with the carbs, is there a quick way of checking...


IF THE MAIN JETS ARE STOPPED UP A TEARDOWN WILL BE A MUST.
Sorry To check this out get the bike ready and warmed up. Start out normal and when it starts loosing power choke the thing a little. and increase choke until it runs "stronger" if this works then the carbs are stopped up. Main jets
Good Luck and Ride Safe

Feb 20, 2011 | 1991 kawasaki ZZR 600

1 Answer

GSXR 400 rev problem


The float level in your carb probably needs to be adjusted. If the gasoline level in your float bowl is borderline low, your bike may run fine when level. But on the incline, the gas level at the jet may be too low causing your engine to be starving for gas. The solution is to remove the bowl and bend the tab on the float that pushes the valve up so that the gas won't shut off until the level is higher. If you are a good mechanic, you may try this yourself. If not, take it to someone who can do this for you.

Nov 04, 2009 | 1998 Suzuki GSX 400 Impulse

1 Answer

1986 Kawasaki Ninja won't fire


Theres fuel starvation, the carbs are not getting required fuel in other words the float chambers doesnt get the correct amount of fuel .
Check the fuel flow from the petcock to the carburators.
Check the float pin and adjust accordingly to get the right level inthe float chamber of each carburator.
Hope this helps!

May 23, 2009 | 2001 kawasaki ZX-6R Ninja

1 Answer

My bike die


my bike just died. It started right back up but as I gave it gas it would die again. I managed to roll it out of traffic into a parking space. I tried the choke the fuel valve but nothing worked. It would idle, but as soon as I would give it some gas it would just sputter and die. I got a ride to my house where I got my truck and came back to my bike. I started it up and soon as I gave it some gas, it died. I started it up again and gave it some gas and then it started working just fine. I revved it a few times, but it wouldn't die again. I drove it home and didn't have a problem. It seems to be running fine now. What the heck?? It only has 693 miles on it. It has almost a full tank of gas. What could possibly be wrong?,it's fuel or air related. If your bike didn't have any issues at all, no minor symptoms until it fell on its face like that, I'd wager something worked its way loose. Could be something is preventing fuel from reaching the carbs or something rattled loose in your airbox or carb boots. If something blocked off your air filter it would show those symptoms, or if you suddenly had a huge vacuum leak from a carb boot coming undone. I'd start by verifying you have fuel in the carbs by attaching a length of tubing and opening the drain screw at the bottom. Fuel comes out of your carbs, look elsewhere. No fuel, find out why it's not getting to your carbs. Perhaps your fuel line kinked.,,,

Nov 10, 2008 | 2007 Highland Highland Outback

1 Answer

Bike died


I was on my way home from work when I stopped at the stop light and when I went to take off my bike just died. It started right back up but as I gave it gas it would die again. I managed to roll it out of traffic into a parking space. I tried the choke the fuel valve, but nothing worked. It would idle, but as soon as I would give it some gas it would just sputter and die. I got a ride to my house where I got my truck and came back to my bike. I started it up and soon as I gave it some gas, it died. I started it up again and gave it some gas and then it started working just fine. I revved it a few times, but it wouldn't die again. I drove it home and didn't have a problem. It seems to be running fine now. What the heck?? It only has 693 miles on it. It has almost a full tank of gas. What could possibly be wrong?,It's fuel or air related. If your bike didn't have any issues at all, no minor symptoms until it fell on its face like that, I'd wager something worked its way loose. Could be something is preventing fuel from reaching the carbs or something rattled loose in your airbox or carb boots. If something blocked off your air filter it would show those symptoms, or if you suddenly had a huge vacuum leak from a carb boot coming undone. I'd start by verifying you have fuel in the carbs by attaching a length of tubing and opening the drain screw at the bottom. Fuel comes out of your carbs, look elsewhere. No fuel, find out why it's not getting to your carbs. Perhaps your fuel line kinked.,,,

Nov 10, 2008 | 2003 ATK 260

Not finding what you are looking for?
1987 Yamaha FZR 250 Logo

196 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...