Question about 2002 Yamaha TT-R 225

1 Answer

My TTR 225LE, won't start, the fuse blew and i replaced it, when i go to start it, there is a really bad shorting noise, and then the headlight goes out, any ideas?

Posted by on

  • nraku Jul 15, 2010

    I checked all of the connections, all of them were good, so I unplugged over night and it works now, i guess something was overloaded.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 232 Answers

Hi ,
it sounds like you have a wire somewhere that may have earthed itself .
Firstly look around the handle bars and around the tank that no loose wires are touching the frame .
the headlight should be full of wires as well .Open it up and trace all wires and make sure none are disconnected .
Dont try to persist if the problem is not solve as you may end up burning the loom .

Posted on Jul 15, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a Mazda 121 that wont start, I have replaced all the fuses under the bonnet, But when the battery was reconnected the 80 fuse blew straight away... Would the problem be the relay


Unlikely a relay which would have to be very seriously kaput to cause a fuse to blow and even if it was that bad it is only a slim possibility.a fuse would blow.

Clearly there is a short circuit somewhere on one of the circuits protected by that fuse. Check in the vehicle handbook what circuits are supplied by that fuse and begin disconnecting until the fuse goes away.
To save spending money on lots of fuses for testing a headlamp bulb can be connected across the fuse contacts to monitor progress. A short circuit will cause the bulb to be full brightness and when it dims or goes out you have found the faulty circuit.

Alternatively a couple of wires can be fixed to a spare MCB from a consumer unit if you have such a thing...

Aug 03, 2016 | Mazda Cars & Trucks

1 Answer

Electrical problem 2000 wrangler.


that means 1 of 2 things'
wrong size fuse, you never stated amps. or the color of the ATC fuse.
the correct fuse blows with any short, ending possible fire.

sounds like you have gross electical issues.
even bad battery terminals. clean them.
try a fresh charged battery
use a voltmeter and measure voltage yet.
at the battery and those things that fail?
that speaker noise is alternator whining noise, caused buy shorted diodes in same.
you do know alternator can fail in many a way.
dead.
regulates wrong
open diodes, and 1/3 loss of power
shorted diodes turns alternator in to a huge noise generator
weak
overvoltage
over charges battery
to name a few and bad bearings,

Jun 28, 2015 | 2000 Jeep Wrangler

1 Answer

Headlight


find the short in that wiring harness to that light its a dead short to ground so it should not be to hard to find

Jun 03, 2013 | 2001 Volkswagen Passat

1 Answer

Power door locks won't work and the instrument pnnel lights won't turn on. I replaced blown fuse a 20mp one in position 14 I believe. worked ok till I tried to lock the doors, the fuse blew


Hello. Try looking at the black earth that goes from the drivers door and into the A frame which is covered in a rubber sheath. The wire can break after opening and shutting the door over several years and as it's normally the thicker wire is more prone to break. Also check the other wires visually for any chaffing and tugging on each wire. If more electrical parts start failing, air con blowers etc it will be an earth. Hope this helps

Nov 03, 2012 | 2002 Dodge Neon

1 Answer

1983 944 Porsche drove fine till it started to shake aftermarket radio blew a fuse turn signal wipers turn on by its self ant went really fast the battery plus was touching the hood when I bought it and...


Gonna have to go to the fuse panel first, this is really bad, I have seen a few 944s require a ton of wiring from a short out on the chassis. If the fuses check out then you are going to need to take a multimeter and try getting continuity from some of the switches and sensors. but it looks like the wire going ot the fuel injection could be fried.

Jun 24, 2011 | 1983 Porsche 944

1 Answer

Dash lights not working


check the headlight relays use a continuity tester aswell, something is touching and shorting the system out, check the fuses and relays under the dash for the headlights, it may be there. somethings getting to much power and shorting out or bad earth

Jun 22, 2010 | 1997 Honda Accord

1 Answer

I was watching TV and it just cut off. There is no power light on and the outlets are working and the cord is firmly in.


good day sir/maam, chances are yout tv just blew a fuse, when a fuse blew up, there are several reasons.
  • It protects your tv from further damage.
  • a part of your tv got bad, causing it to blew.
You have a choice of calling your service center/dealer or do it your own.

If you decide to do it yourself, these are the steps you may need to do.
  1. Open the TV's back cover, to access the circuit. locate the blowned fuse.
  2. you may need to pull out the entire board, to test it.
  3. test the switching regulator IC/transistor for shorts, (you may need a multitester).
  4. check for open low value resistors, less than 100 ohms.
  5. You really need to find the cause of the blew up fuse. part by part checking is necessary,
  6. replace the bad parts and test again.
  7. if everthing else fails, you really need to call your service.
note: if you simply replace the fuse without tracing the blew up shorted bad part, chances are the fuse may blew again.

Oct 02, 2009 | Vizio L32 32 in. LCD HDTV

1 Answer

2006 TE250 Starter fuse blows when the turn signal is turned on


http://www.carlsalter.com/motorcycle-manuals.asp free pdf manual there. you definately have a short somewhere in your wiring, i am not familiar with huskies. possible behind the headlight

Apr 09, 2009 | 2005 Husqvarna TE 250

Not finding what you are looking for?
2002 Yamaha TT-R 225 Logo

Related Topics:

209 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...