Question about 1981 Suzuki GS 750 L

1 Answer

1986 intruder 700cc 8 thousand miles. both

1986 intruder 700cc 8 thousand miles. both carburators have been thoroughly cleaned out with new jets and gaskets. Cleaning approximately 6 months and 500 miles ago. The bike has recently been to a mechanic who " synced the carbs. " on cold starting and occasionaly when fully warmed the front cylinder cuts out ( raw gas from pipe ) good ignition spark. We took apart the carbs and performed another cleaning and inspection reassembled now fuel leaks heavily from the overflow tube. Dissasemble and reassemble and cant figure out why its leaking. Please help me !

Posted by Anonymous on

1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 36 Answers

Float stuck

Posted on Aug 07, 2010

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

The ski has good compression and spark but after it starts it diers shortly after and the carb fills with fuel and floods it and then it doesnt start untill it dries out do you know what could be yhe...

Your carburator bowl float is stuck in open position, or it is sticking allowing the gas to flood the engine.
Remove the carburator boal and try to clean or replace the carburator bowl float.

Jun 24, 2014 | WSM 1977-1986 Kawasaki Js 440 Cc Jet Ski...

1 Answer

I have a 2000 intruder 800 that is stumbling while cruising and aputters at low RPM it runs great wide open. I have had it in the Suzuki dealer for most of the summer while they try to figure it out. When...

Sounds like you have a clogged pilot jet in the front carburator. Have the dealer remove the pilot jet and clean it. They can also adjust the pilot fuel mixture and synchronize the carburators to make it run properly. If they can not do that, you should find another shop.

Aug 02, 2013 | 2000 Suzuki VS 800 Intruder

1 Answer

Old fuel in a carburator, do i need to take the carb all apart and clean it?

I would remove the carb and give it a thorough cleaning. If you have that junk in the bowl, chances are the jets are clogged with it too.

Jun 10, 2012 | 2006 Yamaha WR 250 F

1 Answer

1400 suzuki intruder electrical failure

The clutch safety switch on the handle bars might be bad. I changed mine when I had this problem and had no problems after this. Hope this helps.

May 03, 2012 | 1995 Suzuki VS 1400 Intruder

1 Answer

My bike is ruuning rich

What kind of bike and has any work or aftermarket accessories recently been done? If not, check your air filter and clean thoroughly if needed. Look for abstruction in airbox and passages to carburator. has the carburator been adjusted in any way? If not the problem is most likely a lack of air rather than excessive fuel

Mar 23, 2012 | 2002 Suzuki VS 800 Intruder

1 Answer

I need a 22R aisan carburator diagram so I can rebuild my carburator.

purchase the carburetor rebuild kit for your carburetor and it should have instructions in the box to aid you in rebuilding it . Remember , to do it correctly you must get an acid wash tank to submerge the entire carburetor body into before you install the new parts . And be sure to clean it thoroughly after you remove it from the acid dip tank .

Nov 18, 2010 | 1986 Toyota Pickup 4WD

3 Answers

Suzuki intruder 1500 LC I have problem with carburator need to rebuild is a kit available? motorcycle.runs terrible backfires sputters poor gas mileage 135km to atank of gas

Intruder carbs are notorious for this issue. What you have going on is that the needle seat has become worn out. The problem is, that this carb was designed with pressed in needle seats that cannot be removed. You will need to search online for an intruder carb rebuilder that can press in the seats for you, as well as change the seals, replace the needle, check the diapragm and jets, and replace/clean the floats. OR, you can try to find new carbs online from a wrecked or used Intruder 1500 VL.

May 30, 2010 | 2000 Suzuki VL 1500 Intruder LC

1 Answer

About how much is a 1986 toyota pickup 4x4 worth

Depends on milage, and condition. I got an '89 short box, regular cab, 4 cylinder with NO rust at all, but over 200,000 miles. I paid just over three thousand, as the odometer read that it had 84,000 miles on it. So I got a raw deal there, but the truck is clean, so I rebuilt the entire drive line, engine, transmission, rear end, transfercase, and on. Now I have a rust free solid good running truck for under seven thousand, that runs like new. But...I do have a lot of time in it.
I love the truck, they are well built, just prone to rust.

Jan 30, 2010 | 1986 Toyota Xtracab

3 Answers

Suzuki 1500 backfires when decellerating. any

clean the carburator and the air cleaner also clean your spark plug or instead replaced it with new one. denso irridium would be the best for it.

Apr 15, 2009 | 2002 Suzuki VL 1500 Intruder LC

Not finding what you are looking for?
1981 Suzuki GS 750 L Logo

271 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts


Level 3 Expert

75797 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Ed Nelson
Ed Nelson

Level 2 Expert

149 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides