Question about 1983 Honda GL 1100 Innerstate Gold Wing

1 Answer

On a good ride alot of quick accelerating and slowing downalot gave it gas and it started skipping alot like running on 2 cylinders.had no power had to pull over and check everything outwhen idling it seemed okay but as soon as i applyed any gas it started skipping badly.do you have any possible answers?

Posted by Anonymous on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Honda Master
  • 6,826 Answers

Tune it up with new spark plugs and wires if so equipped? Under higher rpm loads, the coil may be cutting out on the voltage as it gets hot.

Posted on Jul 08, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

A friend of mine gave me a zr series ,625cdv homelite weed eater and I can't figure out how to adjust the carb. Bought a new primer bulb it crank and run for a little bit but I have to idle it high


Screw in the HIGH and LOW needle valves. Then turn each one out 1 full turn, That should be a good starting point.
After engine is running Run engine at Full throttle. Loosen HIGH screw until the engines RPM slows a bit. When that happens Turn screw back in until it revs high and then just starts to slow again. You do not want the engine to run at it's highest RPM or it's not getting enough Lubrication It need to run Rich, that's why you screw the screw in a bit after the engine has reached it's highest RPM. Let it idle down . Then Accelerate hard, if it hesitates, loosen or tighten the LOW until it accelerates quickly with no hesitation.

May 30, 2017 | Homelite Garden

1 Answer

Check engine light report: cylinder 2 mis-fire, engine skipping, hesitant acceleration,


Use a different fuel station. First run the fuel tank low before refilling elsewhere.

Apr 28, 2017 | 2003 Buick Rendezvous

2 Answers

Riding lawnmower loss of power, runs ok at first but in 1/2 to 1 hr loss of power, replaced fuel filter/fuel kit


you need to check compression. sound to me that ether the valves need adjustments or you have cylinder damage causing compression loose when engine warms up. send me the model# of the mower and engine too.

Feb 09, 2011 | Garden

1 Answer

I have a 1999 1200XL Waverunner and while riding it lost 1/2 its power. I changed the spark plugs in it they looked pretty worn. But I can only get 1/2 the power. It takes off great for a few minutes...


Always good to start with a compression test to make sure the cylinders haven't lost compression (power). If all are equal and above 100psi you are good. It may be a cavitation problem... (too much air leakage into the jet pump) a gasket kit may resolve this issue if it is over reving on accelleration.

Aug 03, 2010 | Yamaha 12V Air Pump

1 Answer

I had a cylinder 5 misfire on my 2002 chevy Camaro v6 3.8. I changed the spark plugs and the spark plug wires and the car runs great, until i give it alot of gas. If i accelerate too quickly now the car...


sounds like spark plug coil is bad. had the same problem on my truck also. check wich cylinder is misfiring and replace the coil and maybe the plug also. if the plug looks good leave it. autozone can give you a read out. when checking the coil, if it has a rust color to it its bad and needs to be replaced. 02 z28

Jul 07, 2010 | 2002 Chevrolet Camaro

1 Answer

Hardly start; skips badly at low rpm; smooths out some after 3000


I had a similar problem and traced it to the hole in the gas cap was rusted shut so that the engine was starved for gas. I drilled a small hole in the gas cap and it runs like new. Sorry-no new gas caps are available through the Honda dealer as the bike is so old.

Jun 02, 2009 | 1982 Honda GL 1100 Gold Wing

1 Answer

Engine is skipping when accelerating


You only have 4 so better just do a tune up and change the plug and wires, but one at a time so you don't get them crossed when re-installing the new plugs and wire.
Use Platinum plugs since there good for 100,000 miles which mean less maintenance, and double check that the spark plug boots set to the plugs when re-installed.
Run some fuel injector cleaner through the gas tank for about a week to to clean out your fuel system and hope fully the skipping stops.
If your going to get all the goodys at Auto Zone, have them scan the car for any DTC codes since it's free and see if there are other issues that is causing the skipping like a bad signal from the MAP sensor ECT.
Good luck and keep me posted.

May 26, 2009 | 1997 Saturn SL

1 Answer

I just pulled out my Snapper Ridding Mower with a Briggs 9 horse power motor from winter storage. I did a quick inspecton, checked oil levels, pulled the plug and gave a shot of wd40 in the cylinder for...


the rings have seized on the piston and the fuel is running by into the crankcase or you have a valve bent i would pour marvel mystery into the jug and leave it sit for a couple of days

Apr 27, 2009 | Garden

3 Answers

SKIPPING WHEN YOU FIRST TAKE OFF


I have the CTS, Plugs, Wires, and it continue to have a slow take off and sometimes stalls, plenty of Black Smoke when accelerating or first start-up

Aug 16, 2008 | 1997 Chevrolet S-10 Pickup

Not finding what you are looking for?
1983 Honda GL 1100 Innerstate Gold Wing Logo

117 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75197 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...