Question about 2006 Hero Honda Super Splendor
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: bike starting problem
ALWAYS have a fire extinguisher on hand when working on carburetors.
Remove the water trap bowl at the bottom of the petcock, (gas valve). Is there any water or trash in the bowl? Drain a cup of gas from the tank. Is there any water or trash in the cup? Dump it, clean it and re-mount it, ( not all bikes have a water trap bowl ).
Drain the carburetor. There should be a screw on the lower side or bottom of the carb float bowl. Remove the screw then replace it after the fuel drains. Turn the gas back on and wait a minute for the carb to fill with gas. Install a new stock NGK spark plug and try to start the engine. If the bike doesn't start and run properly then shut off the gas and remove the carburetor from the engine.
Remove the float bowl and clean the entire carb with a spray carb cleaner from the auto parts store. Wear protective goggles to avoid getting spray in your eyes. Spray into all the little airways and fittings in the carb. Remove the idle screw and the air screw on the outside throat of the carb and spray into the screw holes as well.
< < READ CLOSELY > >
Be sure to put these two screws back in the same hole they came out of. IMPORTANT > do not tighten these two adjusters down. Only screw these in until they LIGHTLY seat. Now turn each adjuster one and one half turns outward. Put the rest of the carb back together, clean the air filter and install the carb. Let the float bowl fill then start the engine.
Please rate this solution. Thanks!
Posted on Jun 29, 2009
That sounds like a fair price to me concidering the costs involved.
Please mark this as useful (if it has been!!)
Posted on Aug 03, 2009
I think you are exactly right. Sounds like you have some clogging in your idle jets and probably in need of a carb tune up. if you havnt replaced or cleaned your air filter in a while, now would be a good time to do that as well, being that some filters begin to break down and pieces of them get into the carb ports and cause clogging.
Posted on Nov 22, 2009
sometimes they are stubborne,I use stranded electrical wire to send through jets,just make sure when blowing into an orfus that it comes out somewhere hope this helps
Posted on Jun 27, 2010
SOURCE: Hi, I bought a used motorcycle
How to use your choke correctly. The choke is only to be used for starting a cold engine. If it is a lever, usually you pull it up for on , and push it down for off. look for some type off arrow, or up & down. To start your cold engine, turn on fuel tap, give full choke, turn key on and press starter or kick start, it is very important that you do not use the throttle while starting with the choke, just turn the key on, and press the starter with full ckoke, and no throttle. Once the bike fires and starts, turn down the choke a little and find a idle, after a few minits, you can turn off the choke and ride off. The use off the choke is only for starting a cold engine.
Posted on Aug 02, 2010
Testimonial: "Thanks for making me understand."
Tips for a great answer:
May 04, 2017 | Hero Motorcycles
Mar 16, 2017 | Honda Motorcycles
Jan 26, 2016 | 2011 Hero Honda Passion Pro
May 27, 2014 | 2011 Hero Honda Passion Pro
Nov 30, 2013 | 2011 Hero Honda Passion Pro
Oct 24, 2012 | 2006 Hero Honda Super Splendor
Dec 08, 2010 | Honda VT 750 Shadow Aero Motorcycles
Nov 21, 2010 | 2006 Hero Honda Super Splendor
Jan 06, 2014 | 2006 Hero Honda Super Splendor
259 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: