Question about 1999 Yamaha V Star Custom

1 Answer

Engine oil lamp cimes sometimes, after engine gets

Engine oil lamp cimes sometimes,
but only after engine gets hot

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 541 Answers

Change your oil to thicker viscosity

Posted on Jul 05, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Why does My Jeep run for about 200 yards then shuts down , after about 10 min. it will start and do the same .on the inst.panel it reads hot oil


You need to scan the engine control unit for fault codes, it will have some I am sure. Check The codes by turning the ignition key to run and then off, then to run and then off, then to run and wait for the codes to be displayed in the digital mileage display.

Oct 15, 2016 | 2010 Jeep Wrangler

1 Answer

1998 dodge dakota overheated was ran hot lost all power an shutdown


When an engine gets hot, you must shut it off before it gets so hot that it begins to lose power. Sometimes this simply can't be done safely. Once the engine gets so hot that it shuts down, permanent damage may have be done. Bearing can gall, piston rings can break, piston crowns melt, but usually the oil breaks down and the main damage is to bearings and perhaps the crankshaft. Diagnostics would include changing the oil, attaching a good mechanical oil pressure gauge then spin the engine with the spark plugs removed to see how bad the damage is. If oil pressure is adequate, run a compression test. This should give you enough information to decide if the engine can be saved without a major overhaul. Low compression can mean blown head gaskets, warpped heads, broken piston rings, warpped valves, etc.

Jan 01, 2015 | 1998 Dodge Dakota

2 Answers

Where is the oil pump situated on a CateraS 2001.Have low oil pressure when idling or at a red light.


Hi Rejean, I suggest you have the oil pressure sender unit inspected before thinking of replacing the oil pump. If it's the sender unit the job will be a fraction of the cost of an oil pump replacement, which means opening the engine. Regards John

Jun 22, 2014 | Cars & Trucks

1 Answer

Oil light comes on.


thats normal , key on, not started or stalled
but when does it?
if cold engine (bad to bone) (ever check oil levels at fuel fill up?)
if hot engine, bad.
the oil lamp can come on only with super bad low oil pressure.
3-5 PSI is the common oil sender rating.
running 0w oil? in this old car never designed for such oil?
is engine overheating?
is engine rpm at 300 rpm (BAD) ? 800 minimum. is correct.

dont drive it. or risk, spun rod bearings and sized cam shaft.

answer back and we can progress to more , tests.

Feb 20, 2014 | 1997 Honda Accord

1 Answer

No hot air comeing out of heater on my 1992 lincoln town car.blower and water or ok lust no hot air cimeing out of ducks?


Hi,if you are not loseing water the best thing to start with is a simple kit that will flush out the rubbish that bilds up in the water channels,all you do is put the aditive in to the system by way of exspansion tank or radiater cap then let the car idle untill recermended time is up,then flush system and refill with the the recormended amont of anti-freeze.
you should be able to buy the item at eney good car spares shop.
Hope this was some help.
ps sometimes things just need cleening or ajusting rather than renewing.

Dec 23, 2013 | 2006 Pontiac Grand Prix

2 Answers

My 03 745li puts out light blue smoke sometimes when engine gets hot driving around town... why is that?


blue or blue/gray smoke is a sign that engine is burning engine oil. keep an eye on oil level and if engine is getting hot or over-heated this will not help your situation.

Jan 26, 2011 | 2003 BMW 7 Series

5 Answers

Engine start normally and when it reach the maximum heat of the engine temperature it starts surging and engine cuts out when u try it to start again it won't start.what are the possible cause of the...


Dear sir I have Bighorn 3.0 4JX1 car. Suddenly it start cuting of engine while running, like no fuel, but it start again. But sometimes it doesn´t. and before cutting it make noise us the fuel supply is cuting in the pump. Here we don´t have computer scan. Can someone indicates where to check? which sensor? Thanks

Jan 20, 2010 | 1999 Isuzu Trooper

1 Answer

Headlight left on warning not working, what should I look at?


Headlight on warning works through the radio and the Body Control Module (BCM). The BCM has an input from the lighting circuit and when it decides that the warning should turn on, it sends a class 2 serial data communications to the radio. The radio then sends a cime tone to the driver's front door speaker.

If by chance, you replaced the OEM radio with and aftermarket radio and did not install an interface module, you will be missing not only the headlight warning but many other warnings as well ( low oil / hot engine, etc.)

Nov 18, 2009 | 2002 Chevrolet Cavalier Coupe

1 Answer

1998 dodge stratus oil lamp


Check the engine oil level in your engine. If you also get the oil light coming on when making a hard corner along with when you brake sometime, it might be that the oil is just a bit lower than it should be and the movement (sloshing) of the oil in the oil pan might cause the oil pickup in the engine to be starved for oil for a few seconds.

Nov 10, 2008 | 2004 Dodge Stratus

1 Answer

When you print it cimes on 50.1 fuser error and won't print


Your fuser lamp is not coming on. Reseat the fuser. If that does not help, your fuser will need to be replaced.

Mar 03, 2008 | HP LaserJet 2840 Printer

Not finding what you are looking for?
1999 Yamaha V Star Custom Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...