How to remove a starter from a 1999 chevy silverado 4x4 pickup

1) Disconnect Negative Cable on Battery
2) Starters on right-side Close to Trans. Bell Housing
3) Remove the 2-Starter Bolts and Shim if it's
if it has shims.
4) Remove the wires off Solenoid: Mark Them:
5) Remove the Heat Gaurd Over top of Starter:
6) Take Starter on Out.

To Re-Install Reverse the Procedure that you Removed the Starter. NOTE: the Shims if there was any are only nessary if the Casting of the Starter is not Exactly or Close to The Original.

Be sure that All the Wires you Took off the Starter Solenoid are put Back on the Exact Same Terminal. And Snug them up .Be careful not to Over Tighten,:
Specs on Bolts Are :
Torque Starter Battery Cable Nut to 90 inch lbs
Torque Smaller ingnition wier nuts to 18 Inch Lbs
Torque the 2- Starter Mounting Bolts to 35 FOOT lbs.
Remember if your Old Starter Had Shims the New one MIGHT need Shims.All Starters Casting are just a Little Different. like by thousands of an inch. So if you have problems you might have to remove or add shims,they come in different sizes. Hope this has helped you,Please let me know how this solution Helped. Thank You: From d_hubbs