Question about 2005 Yamaha FZS 1000 Fazer

1 Answer

Engine misfires around 5000 revs and sometimes

Engine misfires around 5000 revs when under load but with no load on the engine revs around the clock

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert who has written 50 answers of more than 400 characters.


    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 156 Answers

Give your bike a tune up, Plugs , Air filter, clean the carbs. Do these jobs one at a time till the problem goes away, Dirty fuel from leaving the bike unused can also give grief.
Happy hunting

Posted on Jun 06, 2010

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Reasons for cylinder misfires

Ford coil on plug systems are multi strike ignition (spark) under 1300 rpm then go to single strike a single cylinder misfire can be created by several things . #1 Test engine compression on a cranking engine compression it should be around 150 lbs but if gauge reads different COMPARE to other cylinders that work fine #2 check engine running compression this will be around 120 lbs then rev over 2000 rpm and check pressure drop again COMPARE to other cylinders that work fine. any drop would indicate valve train problems. #3 All internal engine is fine then external problems are present vacuum leaks and or fuel injection volume is low.

Jul 23, 2014 | 2003 Ford Thunderbird

1 Answer

Engine misfires under load

possible plugged injectors or might be electrical when was you car tuned up last

Jul 06, 2012 | Cars & Trucks

1 Answer

P38 misfires and pops when hot

it is possible that you have access carbon buildup around your valves or on top of the Pistons that gets hot and on cruise causes the engine to misfire.It is also possible that you have some water in the mix that is forced through under normal conditions that under cruise conditions is causing problems also.

Feb 19, 2012 | 1996 Land Rover Range Rover

1 Answer

My 1996 mercury 9.9 miss firers under load

The most common cause of any ignition misfire (which i think is what you have here) under a load is that the plug wires/and or plug wire boots are defective and shorting to the engine case or that you have a cracked spark plug insulator. If the plug wires are the cause you can spray water on them while the engine is running and the misfire should occur. This method is not fool proof but works well in may cases.
Please rate my help for Fixya, it all the reward I ask for for my time helping you.

Dec 29, 2011 | Seloc Mercury Outboard Engine Repair...

1 Answer

My 88 cherokee has a miss at around 40 mph. any solutions?

Check for a shorting spark plug wire when the engine is under load. Get a spray bottle of water, and mist some water on the plug wires from the dist. cap to the spark plugs. Rev the engine, and you might see a blue spark shorting to the outside of the spark plug or to the cylinder head. If that checks out, check under the dist. cap for any oxidation on the contacts, or hairline cracks in the cap. Any of these things will give you a misfire under load.

Jul 21, 2011 | 2003 Jeep Grand Cherokee

1 Answer

Engine misfire? Not changing gear.

check your coils and plugs , fuel filter and air filter

Jun 16, 2009 | 2000 Jaguar S-Type

1 Answer

My fzr genises misfires at 4000 to 5000 then wont rev past

Have you checked if the EXUP valve is working? It should cycle when you turn the ignition on.
If it's stuck in the closed position it will be choking the engine in the way you describe

Mar 22, 2009 | 1989 Yamaha FZR 1000

1 Answer

Engine shuts off/ loss of power under load

usually ignition coil will cause you this grief obd 2 scan your engine light to confirm nature of your misfire

Dec 07, 2008 | 1998 Dodge Neon

1 Answer

99 vitara misfire?

check for codes, p0300 is multiple cylinder misfire, p0301-p0304 is for cylinder 1 through 4, could be bad plug or coil, try switching and see if problem moves to different cylinder

Nov 16, 2008 | 1999 Suzuki Vitara

Not finding what you are looking for?
2005 Yamaha FZS 1000 Fazer Logo

Related Topics:

467 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts


Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers


Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides