Question about 1991 kawasaki ZZR 1100

1 Answer

Carburator problem... what can i do... - 1991 kawasaki ZZR 1100

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

You do it

Posted on Jun 06, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Steelcraft generator 3300 watt Gas tank shut off


The floater of the carburator is bad(Needle). its leaking gas at the carburator and the gas is coming inside the engine at piston intake valves.
Replace carburator needle that stops the intake of gas at the Carburator.

Sep 02, 2014 | Electrical Supplies

1 Answer

Gas shooting out of rubber hose above carburator. craftsman lt200 with kohler engine.


If hose coming off carburator does not connect to anything then it is the over flow for carburator when float gets stuck and does not close needle valve causing excess fuel in carburator bowl and is drained automatically through vent orfice connected to hose that gas is dripping from. If this is the case then remove carburator bowl, check float, needle valve and o-ring in where needle valve goes. sometimes when carburators sit over winter with gas in them the gas breaks down and over time will gel/harden and cause float to hang up and o-ring for needle valve to deteriate and not sealing properly. clean and replace parts as nessesary.
I hope this helped.

Oct 26, 2011 | Craftsman 17.5 hp 42 in. Deck Lawn Tractor...

1 Answer

On my 89 Pathfinder,I changed my fuel filter an it turns over but still won't start. can i spay the carburator w/ carburator cleaner. will that help


If you smell fuel in your carburator I would check to see if you are getting spark to the plugs.

You can take starter fluid and spray into carburator and see if motor fires, if it does you may have a fuel pump problem.
Hope this helps you!

Mar 05, 2011 | 1989 Nissan Pathfinder

1 Answer

Gas flows from cutoff valve to carburator hose connection but does not flow into carburator. What is blocking the flow?


On the top of the carburator there is a needle valve, closed by the float lever. 
If the carburator chamber is full with gas, the valve is closed and no more gas can enter the chamber.

If the chamber is empty and no gas flows inside, the valve may be stuck in closed position. Cleaning or some sharp (but not very hard) knoks on chamber cover may help.

Some times the float gets broken and falls down. This is a bigger damage, because it may lead to carburator overflow.

Jul 19, 2010 | Coleman Powermate Premium Plus 6250W...

1 Answer

How to install 1988 chevy monte carlo rochester 4 barrel carburetor


You'll need to disconnect the fuel line at the front of the carburator. Disconnect the vacuum line at the back of the carburator going to the brake booster. Label and remove the vacuum hoses. Unplug the mixture control solenoid connector, the TPS connector and the connector to the automatic choke. Unbolt the 4 13mm bolts holding the carburator to the intake and remove the carburator.

Apr 23, 2010 | 1988 Chevrolet Monte Carlo

1 Answer

Can i buy a carb cleaning kit at lowes, h depot or ace. i have a troybilt tb70ss, and am having some of the same problems, but my trimmer wont run at full speed. have to run the choke on mediun, instead of...


you can buy on any auto parts carburator cleaner. And make sure you have a clean filter inside the fuel tank use a little hanguer or any kind of wire for catch the filter be careful came loose easy some times. Cleaned with carburator cleaner and let dry or use air. another think is could be yor carburator is dirty inside in that case you need to remove the cover and remove the 2 screws. Mark your lines top and bottom them removed, now remove carefully the carburator be careful with the gasket remove the 4 Little screws and remove carefully the black Gasket spray carburator cleaner inside the holes and line tubes. Second remove the 1 Big screw on the other side of the carburator be carefull with the gasket spray carburator cleaner and do the step for installed

Apr 18, 2010 | Troy Bilt Tb70ss Gas Trimmer

3 Answers

My weed eater wont start.


One of the problem could be is you have one of the line in this case top line in the carburator clog. For clean the carburator You need to remove first the cover for the filter 2 screws on front of the carburator remove lines mark the lines top and bottom remove slowly the carburator be careful with the gasket. The carburator have 4 little screws removed and remove the black gasket (diaphragm) clean with carburator cleaner and air, blow air thru the top line tube, now on the otherside remove the screw and clean the gasket and the carburator inside do the same step. Make sure you clean the fuel filter inside the tank with carburator cleaner.

Apr 05, 2010 | Troy Bilt Tb70ss Gas Trimmer

1 Answer

4390 15kw, it will start but only run for 15-20sec. Cleaned and replaced air filter, good oil qty. It's a negative 10F, I have cleaned around the pressure regulators. Again, it starts just fine, does not...


remove the carburator sediment bowl just on the underside of the carburator and see how much sediment is in the bowl,if theres a lot you may need to flush out the carburatror to rid it of these contaminents,also pull out the choke part way when it wants to die,if this keeps it running,this also is an indication of a dirty carburator restricting fuel flow through carburator to the engine intake,sometimes if you can keep it running,spray some carburator cleaner into the throat opening of the carburator and see if this helps

Jan 02, 2010 | Electrical Supplies

2 Answers

What should i buy to replace the carburator of my nissan FE model 1999?


YOUR CAR DOESN'T HAVE A CARBURATOR YOUR CAR HAS INJECTORS 4 OF THEM ONE FOR EACH CYLINDER. SO NO NEED TO BUY A CARBURATOR. HOPE THIS HELPED

Nov 27, 2009 | 1999 Nissan Sentra

2 Answers

Will not start


If it has been in storage for some time it may have water in the fuel due to condensation in the tank, if so remove old fuel from tank and lines and refill with fresh fuel

May 01, 2009 | Garden

Not finding what you are looking for?
1991 kawasaki ZZR 1100 Logo

Related Topics:

92 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75197 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...