Question about 1981 kawasaki Z 650

1 Answer

Will not start..i pour gas in cyclinder and trys to fire up..it set up in storge a long time

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Mentor:

    An expert who has written 3 tips or uploaded 2 video tips.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 91 Answers

Carbs have to come off and be completely cleaned and if your keeping the bike i would order carb kits and rebuild them while you have them off. the good thing is that when you are done the bike will likely run fine. when gas sits over 18 months it becomes a varnish like substance than plugs all the jets and the needle and seat. good luck. if you havent done this before get a manual and takes notes as you tear the carbs down and pictures if needed. if you take enough notes and dont let the job sit unfinished too long you should be able to do this without any problems.

Posted on Jun 03, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Virago blowing out through air filter


Will, let me tell you the "Old school" way to fix this.(1) Remove all of the spark plugs. (2) Disconnect the fuel lines. (3) Pour light weight oil directly into the heads.(I know, sounds weird) (4) Crank Crank Crank Crank. Until the engine turns smoothly. If the valves were stuck, this should cure it! (5) Blow the oil out by the compression of the engine cranking. (6) Pour alcalhol into the cylindars to clean the oil out of the top of the pistons.(Starting fluid also works well) (7) Again, Blow it out using the compression of the engine. (8) Put everything back together and fire it up! NOTE!!!! Any time you know you are going to store anything with an internal combustion engine, treat the engine in the same way, by pouring oil into, and onto the pistons directly. This prevents seize ups, and helps to preserve oil seals. ^^

Jan 11, 2013 | 1994 Yamaha XV 535 Virago DX

1 Answer

96 bonniville wont start


Chech the ignition timing is ok and is firing on the correct cylinder at the right time,

Jul 28, 2012 | 1996 Pontiac Bonneville SE CA Value

1 Answer

My 2001 Dodge Caravan started running poorly after I got gas and the check engine light came on soon after. The OBD codes are P0302 and P0420. I have changed all the spark plugs and plug wires but it still...


P0420 Catalyst System,Bank1 Efficiency Below Threshold 16804 P0302 Cyl.2 Misfire Detected 16686 the p0302 what thats saying is you have a misfire on cylinder 2 find out the fireing order for your van cyclinder 2 will be where the fireing order for your van is now what you need to do is change injector two or pour some injector cleaner in you gas and hope it clears itself

Dec 01, 2010 | Dodge Caravan Cars & Trucks

2 Answers

My 95 taurus (3.0) want start. it trys to start, but it just don't go on. It has fuel pressure and spark. I have always heard if it is firing and gets gas it will run. Not this one. Any advise thanks.


Maybe the fuel injectors are not firing even though there is pressure. Try to add gas to the intake manifold through the throttle body ( a few tablespoons) or use starting fluid to see if it starts that way for a few seconds at least. If it does, then the injectors are not firing.

Also, the timing may have skipped.

Oct 08, 2010 | 1995 Ford Taurus

1 Answer

My 2003 660 raptor will not start


You have probably checked spark by now. if you haven't do so. also check your ignition box.

May 17, 2010 | 2003 Yamaha YZ 125

1 Answer

Ran out of gas and put gas in and now it wont start


pour a half a cup of gas down the carb and see if trys too run if it does you may have a plugged fuel filter.

Jan 11, 2010 | 1994 Pontiac Firebird

1 Answer

Will not crank. Poured out gas, and mixed new. New plug. What else should I do??? Thanks


Will not crank, or spins over, and will not run? I suppose it is the 1st time this year? Let's start here. If the old plug was dry of gas, it needs a little priming, pull out your new plug you installed and pour a milk capful of gas in the sparkplug hole, put the plug back in and try starting, after 5 tries it should fire, and give you an idea whether to push the plunger, or crank a few more times.

Jun 23, 2009 | Troy Bilt Tb70ss Gas Trimmer

2 Answers

I ran out of gas in my 95 chevy caveiler and i filled it up but the car still wont start is there anything i can do to fix this without takeing it to a shop


Try holding the gas pedal to the floor and crank the engine. Don't crank for more than a minute as it will burn out the starter. Good luck and if this doesn't work we can try something else. Please rate me so I know how I'm doing. Thank you.

Dec 30, 2008 | 1996 Chevrolet Cavalier

Not finding what you are looking for?
1981 kawasaki Z 650 Logo

Related Topics:

83 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4535 Answers

yadayada
yadayada

Level 3 Expert

76630 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...